Shure SM35 User manual

SM35
Performance Headset Condenser Microphone
The Shure headworn electret condenser microphone, SM35, user guide.
Version: 2 (2019-L)

Shure Incorporated
2/6
Table of Contents
SM35Performance Headset Condenser Microphone 3
SM35 Headworn Microphone 3
Wearing the Microphone 3
Certifications 4
Specifications 4

Shure Incorporated
3/6
1.
2.
3.
SM35
Performance Headset Condenser Microphone
SM35 Headworn Microphone
The Shure SM35 is a headworn electret condenser microphone, intended for use with a wireless bodypack transmitter in live
stage performances.
Wearing the Microphone
Install the windscreen on the microphone boom.
Place the headband around the back of the head, with the boom on the left side.
Place the microphone at the corner of the mouth. To decrease pops and plosives, avoid placing the microphone directly
in front of the mouth

Shure Incorporated
4/6
Note: Do not store the microphone in damp, enclosed spaces. Allow perspiration to dry completely before storing.
Certifications
Note: Testing is based on the use of supplied and recommended cable types. The use of other than shielded (screened) cable types may degrade EMC per
formance.
The CE Declaration of Conformity can be obtained from: www.shure.com/europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: [phone]
Fax: [phone]
Email: [email protected]
Specifications
Type
Electret Condenser
Frequency Response
40Hz to 20,000Hz
Polar Pattern
Unidirectional (Cardioid)
Output Impedance
100Ω, @ 1 kHz
Sensitivity
-57.8dBV/Pa, @ 1 kHz, 1000Ωload
Signal-To-Noise Ratio
59.2dB, @ 1 kHz, 1000Ωload
Maximum SPL
151.3dB, 1000Ωload, @ 1 kHz, 1% THD
[1]
[1]

Shure Incorporated
5/6
Dynamic Range
116.5dB, @ 1 kHz, 1000Ωload
Self Noise
34.8dBSPL-A, 1000Ωload
Power Requirements
TA4F +5VDC (nominal), 10V maximum (DC bias)
XLR connector 12 to 52VDC, phantom power
Polarity
TA4F Positivepressureondiaphragmproducesposi-
tive voltage on pin 3 with respect to pin 1
XLR Positivepressureondiaphragmproducesposi-
tive voltage on pin 2 with respect to pin 3
Cable
1.1m (45in.)
Connector
TA4F or XLR
Weight
72g (2.53oz.)
Measurements taken using RPM400 preamp
*All specifications measured with a 48 Vdc phantom power supply. The microphone operates at lower voltages, but with slightly
decreased headroom and sensitivity.
[1]
[1]
[1]

Shure Incorporated
6/6