SIIG LB-GE0114-S1 User manual

1
04-1056A
Gigabit Ethernet PCIe
4-Lane Card
Introduction
TheGigabit Ethernet PCIe 4-Lane Card adds Gigabit
Ethernet ports to your PCIe-enabled server or
desktop systems.
Specifications
• Bus connector: PCI Express x4
• Version: PCI Express 2.1
• Network transfer rate: 10/100/1000 Mbps
System Requirements
• Desktop PC with one available PCIe slot
• Windows®
10 (32-/64-bit) / 8.x (32-/64-
bit) / 7 (32-/64-bit)
• Windows Server 2012 R2 / 2012 (32-/64-
bit) / 2008 R2 / 2008 & 2003 (32-/64-bit)
Installation Guide

2
Package Contents
•Gigabit Ethernet PCIe 4-Lane Card
• Low profile bracket
• Driver CD
• Installation guide
Hardware Installation
Static Electricity Discharge may permanently
damage your system. Discharge any static
electricity build up in your body by touching your
computer case for a few seconds. Avoid any
contact with internal parts and handle cards
only by their external edges.
Note: For slim desktop PCs, replace the pre-
installed bracket by the included low profile
bracket.
1. Turn OFF the power to your computer and
any other connected peripheral devices.
2. Unplug the power cord from the computer.
3. Remove your computer cover.
4. Remove the slot bracket from an available
PCIe slot.

3
5. Carefully align the card's bus connector
with the selected PCI Express slot on the
motherboard. Push the card down firmly,
but gently, until it is well seated.
6. Replace the slot bracket holding screw to
secure the card.
7. Replace the computer cover and reconnect
the power cord.
Windows Driver Installation
Windows 10 and 8.x have built-in driver support
for this adapter. Just install the board and
Windows will automatically detect and install
the correct drivers for it. No additional driver is
needed.
For earlier versions, follow below instructions to
install the driver:
1. After Hardware Installation, start the
computer and insert the driver CD.
2. The AutoPlay window will show
automatically, and select RUN
AUTORUN.EXE. If not, browse the CD
manually.

4
3. At "Intel(R) Network Connections"
window, select Install Drivers and
Software, then follow on-screen steps to
install the driver.
4. When "Install wizard Completed" message
shows, click Finish.
5. Restart the computer and it's ready for use
now.
To Verify Installation
1. Right click This PC or Computer on the
desktop, click Manage, then click Device
Manager.
2. Double click Network adapters, and below
should be displayed.
* 2-port:
For more details, please go to the Support section at www.siig.com.
* 4-port: