SimplyMed SMF010F User manual

CONTINUED
SIMPLYMED EXTRA HEAVY DUTY FOLDING WALKING FRAMES
Model Nos: SMF010F (Frames)
SMF010FW, (Wheels only)
Maximum User Weight: 300kg (48st) Extra Heavy Duty
(Do not exceed thisweight)
USING THE FOLDING WALKING FRAME
The SimplyMed Extra Heavy Duty Folding Walking Frame is
intended for use by persons with disabilities or difficulty in
walking but who are capable of mobilising themselves. The
SimplyMed Walking Frame can be used indoors or conditionally
outdoors
When the frame is adjusted correctly the user should be able to main-
tain an upright posture with the elbow slightly flexed. In this way, body
weight is taken through the frame by pushing down on the frame when
walking.
WARNING
1 Use a chair with high seat and arms to help you sit and stand up with ease.
2 Remove obstacles such as loose rugs, draught excluders and worn floor
Coverings.
3 Ensure lighting in hallways and stairways is adequate.
4 Wear flat supportive shoes.
5 Avoid wet floors.
6 Beware of outdoor hazards including uneven surfaces, wet leaves and ice.
7 Do not store this product in temperatures below freezing.
8 Take special care if carrying a bag or similar package.
9 All equipment should be regularly inspected for any damage or significant signs
of wear.
Check for: Bent or damaged tubes or cracks at the tubejoints.
Elongated adjustment holes.
Loose handles.
Smooth, worn or split ferrules (rubber tips).
Replace where necessary.
10 Regular cleaning with a mild disinfectant is recommended. DO NOT use bleach or
any solvents (such as lighter fluid).

SIMPLYMED EXTRA HEAVY DUTY FOLDING WALKING FRAMES
FOLDING WALKING FRAME
TO OPEN
1. Holding the left hand handle in the left hand,grasp the righthand
handle with the right hand and pull open until the handle locksin
position.
2. Repeat for the left hand handle.
3. Check that both handles are firmly locked in position.
TO CLOSE
1. Depress the left hand red button with the right hand and closethe
left handle with the left hand.
2. Repeat for the right hand handle.
WARNING
When adjusting frames fitted with wheels it is advisable to set the rear
legs one position higher than the frontwheels.
Thisis to compensatefortheincreasedheightof thewheelsat thefront
which can adversely affect the stability of the frame and the slope of the
handles.
ADJUSTING THE HEIGHT OF FRAME
Toensure the frame is the correct height for the user, it will need to be
adjusted accordingly.
1. Adjust the walker so that when the arm is extended, thehandle
is at wrist height.
2. Depress the brass button positioned just above the rubber
ferruleat the bottom of the leg, and slide the leg to the required
position.
3. Engage the button in the hole that provides the correct height
4. Repeat for each leg, making sure that the walker is level.
5. Check that all buttons are fully engaged and the walkeris
stable.

SIMPLYMED EXTRA HEAVY DUTY FOLDING WALKING FRAMES
USING ALL FRAMETYPES
Walking
1. Place the frame one step ahead and walk towards it using the
affected leg first, followed by the other leg, which should then step
through. Do not walk too far into the frame area.
2. When steady, lift the frame forward a short distance (if using a
wheeled frame, push it forward) and repeat this process (Fig3).
FIG. 3
Chairs
Getting into and out of
1. Position the frame in front of the chair.
2. Get up by pushing on the arms of the chair and transfer hand to
frame when fully standing.
3. Tosit down, using the frame, turn round in front of the chair and
feel the chair behind you with your legs.
4. Place hands gently on the chair arms, bend slightly forward andsit
down gently (Fig 4).
FIG. 4

SIMPLYMED EXTRA HEAVY DUTY FOLDING WALKING FRAMES
LIFE EXPECTANCY
Weestimate a life expectancy of 2 years for this product, provided that:
•It is used in strict accordance with the intended use as set out in this
document.
•All service and maintenance requirements are met.
The estimated life expectancy can be exceeded if the product is carefully used
and properlymaintained.
The life expectancy can also be considerably reduced by extreme or incorrect
usage.
The fact that we estimate a life expectancy for this product does not constitute
an additionalwarranty.
WARRANTY
All SimplyMed products are warranted for 12 months from the date of
purchase against manufacturing or designdefects.
The warranty is subject to the following conditions:
•It does not apply to wear and tear, inappropriate or incorrect use, or non-
observance of User Instructions.
•Defective set up by the user or third parties or negligent or careless
treatment.
•Use of unsuitable or unapproved spares or unauthorised alteration.
•The warranty does not extend to consequential costs resulting from fault
clearance, loss of earnings orexpenses.
Conforms to
The Medical Device Directive 93/42/eec 1993
Simplymed Ltd
Unit B New Venture Business Park
Leopold Street
Wigan, WN5 8DH
Tel: [phone] | Fax: [phone]