Singer SHG 2627 User manual

03.2014
INSTRUCTION MANUAL
STEAM GENERATOR
SHG 2627
ENG
TR

1
INSTRUCTIONS
SINGER SHG 2627
220-240V ~50-60Hz max 2200W
www.singer.com
ENG

2
INTRODUCTION
The iron offers non-stop ironing and also has a detachable water tank that can be refilled
at any moment.
The iron has a high steam output and gives you a constant and fast ironing result.
IMPORTANT
Read this manual thoroughly before using the appliance. This will ensure optimum
results and maximum safety. Save these instructions for future reference
- Check if he voltage indicated on the bottom of the steam tank corresponds to
the local mains voltage before you connect the appliance.
- Only connect the appliance to an earthed wall socked
- Do not use the appliance if the plug, the cord, the hose or the appliance itself is
damaged.
- Regularly check if the mains cord and the supply hose are still undamaged and
safe.
- If the mains cord is the damaged, it must be replace by a service centre
authorized or similarly qualified persons in order to avoid any hazard.
- Never leave the iron unattended when it is connected to the mains.
- Never immerse the iron or the steam tank into water.
- Infirm persons should not be allowed to use the appliance without supervision.
Keep the appliance out of the reach of the children.
- The iron stand and the soleplate of the iron can become extremely hot and may
cause burns if touched. If you want to move the water tank, do not touch the
stand.
- Always place the iron on the stand or on its heel. Do not put the hot iron on the
supply hose or the mains cord. Make sure that mains cord and the supply hose
do not come into contact with the hot soleplate.
- Do not put perfume, vinegar, starch, descaling agents, ironing aids or other
chemicals in the water tank.
- Always place the appliance on a stable, level and horizontal surface.
- When you have finished ironing and even when you leave the iron for a short
while, unplug the iron and put it on the iron stand.
- If steam escapes from the steam tank when the appliance is heating up ,switch
the appliance off and tighten the Calc-Clean rinsing plug. If steam continues to
escape when the appliance is heating up, switch the appliance off and contact a
service centre.
- Rinse the steam tank once a month or after 10 times of use to prevent damage
to your iron.
- Never remove the Calc-Clean rinsing cap and unscrew the Calc-Clean rinsing
plug when the steam tank is hot.
DESCRIPTION OF THE APPLIANCE
A - Power Cord
B - Detachable water tank
C - Iron stand grille
D - Soleplate
E - Thermostat dial
F - Steam button
G- Iron temperature control indicator light
H - Steam rate dial
I - Steam ready light
J - Power on-off switch
K - Iron/Station connection cable

3
BEFORE FIRST USE
- The iron may give off some smoke when you use it for the first time. This is normal and
will stop after a short while.
- White particles may out of the soleplate when you use the iron for the first time. This
is normal; The particles are harmless and will stop coming out of the iron after a short
while.
- When you switch the appliance on, the steam tank may produce a pumping sound.
This is normal; the sound tells you that water is being pumped into the steam tank.
1. Remove any sticker or protective foil from the soleplate and clean the soleplate with
a soft cloth.
2. Place the steam tank on a stable and level surface, i.e. on the ironing board or on a
table.
PREPARING FOR USE
Filling the detachable water tank
- If the tap water in your area is very hard, We advise you to use the demineralised
water.
- Do not put perfume, vinegar, starch, descaling agents, ironing aids, other chemicals or
100 percent distilled water in the water tank.
1. Remove the detachable water tank from the steam tank.
2. Fill the water tank with water up to the MAX indication.
3. Slide the water tank back into the steam tank.
Setting the temperature
1. Check the garment label for the required ironing temperature
Synthetic fabrics (e.g. acryl, viscose, polyamide) and silk
Wool
Cotton
MAX Linen
ENG
A
H
I
J
B
D
F
C
EG
K