WXM-800 SET UP PROCEDURE
WXM-800
Please set up the Receiver first:
1. Press POWER for about 3 seconds until the LCD displaying "CH 11"or "864.000MHz";
2.Press the SET for around 3 seconds, you will enter the setup status when displaying
flashed "SETUP"
3.Press "▲", LCD will display the channels or the frequencies, "CH 12" or "864.100MHz"
etc.; Press "▼" LCD will display the channels or the frequencies, "CH 10" or
"863.900MHz" etc.
4 .Press "SET", LCD will display "SCAN", then press "▲" or "▼" searching for the
frequency sent out by Transmitter.
5.Press "SET", LCD shows "SQL", press "▲" or "▼" to change the noise sensitivity.
6.Press SET, LCD dispays "ID 10", press "▲" or "▼" to revise the ID Numbe. For
example: displaying "ID 9" after you pressed "▼";
7.Press SET, displaying "DIS CHN" or "DIS FRQ", press "▲" or "▼" choosing the
channels and frequencies displayed;
8.Press SET for 3 seconds, exit the setup procedure.
Setup the Transmitter secondly:
1.Press POWER button for about 3 seconds, until the LCD displaying "CH 11" or
"864.000MHz";
2.Press the SET for around 3 seconds, you will enter the setup status when displaying
flashed "SETUP"
3.Press "UP", LCD will display the channels or the frequencies, "CH 12" or "864.100MHz"
etc.;Press "DN" LCD will display the channels or the frequencies,"CH 10" or "
863.900MHz" etc.
4.Press SET, LCD dispays "ID 10", press "UP" or "DN" to revise the ID Number. For
example: displaying "ID 9"after you pressed "DN";
5.Press"SET", LCD shows "SQL", press "UP" or "DN" so as to change the noise
sensitivity.
6.Press SET for 3 seconds, exit the setup procedure.
NOTICE:
1.When finish the setup, make sure to quit this procedure so as not to affect the normal
operarion; if you didn't exit the setup status, the system will exit automatically.
2.ID Number on A and B channel on the Receiver can not be the same; the ID Number
here only used as channel identification.
3.Frequency on A and B channel on the Receiver must be different from each other; the
frequency must be at an interval of no less than 300KHz.
