Skinact Milo SKU164251 User manual

Spa Equipment
&
Toll Free: 1.800.418.0830 www.skinact.com
www.spaandequipment.com International: 818.834.6640
Milo Electric Massage and Facial Bed, Table
User Manual

Toll Free: 1.800.418.0830 www.skinact.com
www.spaandequipment.com International: 818.834.6640
Spa Equipment
&
Copyright © 2021 Spa and Equipment, All Rights Reserved
NOTICE
No part of this document may be photocopied, reproduced, or
translated into any other language without prior written con-
sent of Spa and Equipment/SkinAct.
The information in this document is subject to change without
notice at any time and should not be construed as a commit-
ment by Spa and Equipment/SkinAct.
Spa and Equipment/SkinAct assumes no responsibility for
any errors that may be in this document, nor does it make ex-
pressed or implied warranty with regard to this material, includ-
ing, but not limited to, the implied warranties of merchantability
and tness for a particular purpose.
Spa and Equipment/SkinAct shall not be liable for incidental
or consequential damages arising out of the furnishing, per-
formance, or use of this document and the program material
which it describes.
P. 2

Pinch Point
!
Pinch Point
!
Pinch Point
!
Pinch Point
!
P. 3
Precautions
• Read this manual carefully before installation and operation.
• No one should ever sit on the foot rest or backrest areas.
• This unit should only be operated by trained professionals.
• Keep children from using or playing on the unit.
• Do not stand on any portion of the unit.
• Ensure the unit is kept dry and free of water. Also, make sure
any attachments like remote controls are free of water.
• When operating the unit, ensure that your and your clients’
hands or other body parts cannot be pinched by the moving
parts (see pinch points below).
• If you have gone through the troubleshooting steps in this
manual and an issue persists, please call Spaandequipment/
SkinAct for further assistance: 1(800)418-0830
• OPERATE AT YOUR OWN RISK AND USE COMMON SENSE:
OWNER/OPERATOR IS RESPONSIBLE FOR HIS/HER OWN
SAFETY AS WELL AS ANYONE NEAR OR ON THE UNIT.

Top & walls
come off as
one piece
P. 4
Removing From The Box
INSTRUCTIONS
• Please keep all original packaging materials.
• By following these instructions carefully, you can open the
box and remove your item without damaging the packaging
materials.
• If your unit arrived with a wood frame around the box like in
the photo below, you will need a screwdriver or drill and a pry
bar to remove the screws and take apart the wood frame.
• Once the wood frame is off, the top and walls of the box can
come off in one big piece.
• It helps to have another person to lift the box off.
• Lift the top and walls of the box off the unit and put it to the
side.
• TEAM LIFT: Make sure to have at least two people to lift and
move the unit.
• See next page for lifting instructions.

12
P. 5
Removing From The Box
• Do not lift from the head rest or foot rest areas.
• For this unit, it is best to lift with both hands on the wood sec-
tion underneath the cushions. It helps if the center column of
the base is in the center of your hands.
• Lift the unit with your partner and walk it out of the box.
• We recommend setting the unit on a furniture dolly or pallet
jack when and where it is practical to use one. Otherwise, you
can carry the unit to your desired location.
Furniture Dolly
Pallet Jack
One hand here One hand here

P. 6
Installation
• Please keep the all packaging until you test all the functions.
• Place the unit in the desired location in your space. Attach the
arm rests, face cradle, and any other accessories.
• Ensure the ground below the bed is at and not wet or slippery.
• If the bed wobbles on your oor, adjust the four leveling feet
(circled in the photo) by spinning them to raise or lower them.
The foot that the clears the oor when you rock the table is the
one that will need adjustment.
• Ensure the power cable is connected to the unit and plug it into
an appropriate wall outlet.
• Test all of the motor functions on the unit. Ensure the hand re-
mote works as it should and test the foot remote if you ordered
one.

*Backrest/leg rest up *Backrest/leg rest down
Height up Height down
P. 7
Please see below to see what each button does.
*Backrest and leg rest move together at the same time.
Hand Remote Use

P. 8
Measurements
76” Long when at W/O Face Cradle
45”
86” Long when at W Face Cradle attached
Adjustable
Height:
25.5”-33”

26”
4
6
.
5
”
45”
24”
27.5”
37”
P. 9
Measurements

P.10
Dimensions/Specications
Maintenance
• Length without face cradle attached: 76”
• Length with face cradle attached: 86”
• Width without arm rests: 27.5”
• Width with arm rests: 37”
• Heights: 25.5” - 33”
• BASE ONLY Dimensions: 45”L x 24”W
• Backrest angle: 0° at to 75° incline
• Weight: 180 lbs
• Capacity of 500 lbs
• Cushion thickness: 4”
• Colors available: Dark Brown or Beige: base is Dark Brown
Wood
• Fully electric top is outtted with vinyl and Milo proprietary
“skin touch” padding
* All height measurements are from ground to top of cushion *
** All measurements have a 0.25 to 0.75 inch tolerance **
• When cleaning and sanitizing, do not use bleach, Barbicide, or
other harsh chemicals. Using harsh chemicals can damage the
upholstery.
• Simple Green or upholstery cleaners work great for cleaning
the upholstery. We recommend using Lysol Wipes for sanitiz-
ing the upholstery.
• Clean and sanitize the upholstery after each treatment.
• Every six months, visually inspect the parts of the unit. If there
are any abnormal noises or vibrations during operation, call
Spaandequipment/SkinAct and describe the situation.

P.11
Troubleshooting
Warranty
Issue Possible Reason Solution
Motorized sections
not moving.
The power cord is not
connected properly.
1) Ensure outlet is work-
ing.
2) Ensure cord is con-
nected well.
Hand (or foot) remote is
not working.
1) Ensure hand (or foot)
remote is plugged in
well.
2) Replace the hand (or
foot) remote.
Control box not work-
ing.
1) Contact Spaand-
equipment/SkinAct
Technical Department:
1(800)418-0830
Abnormal sounds or
vibrations.
Parts need lubricating
oil.
1) Add lubricating oil.
Motor quality issues. 1) Contact Spaand-
equipment/SkinAct
Technical Department:
1(800)418-0830
• This item has a 1-year limited warranty for malfunctions and
manufacture defects only (parts, labor, and shipping not includ-
ed). THIS WARRANTY IS VOID IN THE EVENT EQUIPMENT IS
DAMAGED BY IMPROPER USE.
• To read the full Warranty Policy, please visit https://www.
spaandequipment.com/Return-Warranty-Repair-Policy.html or
scan the QR code below.
Scan for
warranty