Sky Elevator Sky 301-VS Operating instructions
MAIN CONTROL BOARD
Troubleshooting
V - 5.01
1
Troubleshooting:
1- Please check to the 14. SAFETY VOLT parameter if correct.
- Please check to the safety voltage between 1 0 and 11A lines.
---------------------------------------------------------------------------------------------------------------------------------------------
Troubleshooting:
1- Please check to the KG signal connection .
- You should seed 4V in KG signal when all conductors are fine.
---------------------------------------------------------------------------------------------------------------------------------------------
3
Troubleshooting:
1- Please check to the T signal connection .
- If signal already have 4V in the T input you should change the input from the 3 .AUX INPUT
parameter .
---------------------------------------------------------------------------------------------------------------------------------------------
4
Troubleshooting:
1- SL1 and SL inputs cables .
- The 5.SHAFT COM. TYPE parameter must be seted to PAR. DATA in Parallel lift systems.
---------------------------------------------------------------------------------------------------------------------------------------------
5
Troubleshooting:
1- R PHASE MISS / S PHASE MISS / T PHASE MISS , Please check to the missed phase voltage.
---------------------------------------------------------------------------------------------------------------------------------------------
6
Troubleshooting:
1- Please replace the R and S wires .
---------------------------------------------------------------------------------------------------------------------------------------------
7
Troubleshooting:
1- The elevator is overloaded , Overload signal is 804 .
---------------------------------------------------------------------------------------------------------------------------------------------
8
Troubleshooting:
1- The elevator must be maintained.
- Talk to the maintenance company. If you do not receive an answer, please contact us via email or
phone Our E-mail is: sky@sky-elevator.com Tel: +359 89 588 41 58.
---------------------------------------------------------------------------------------------------------------------------------------------
9
Troubleshooting:
1- Goto To The 38.ERROR LOG Parameter .
- Press ENT.
3- Press ESC to exit from the ERROR LOG parameter.
4- You should see ERROR CLEAR on display then press ENT
5- Restart the card.
6- Talk to the maintenance company. If you do not receive an answer, please contact us via email or
phone Our E-mail is: sky@sky-elevator.com Tel: +359 89 588 41 58.
---------------------------------------------------------------------------------------------------------------------------------------------
10
Troubleshooting:
1- Please check to the 1 0 and 130 safety input voltage.
Table of contents
