smart things AEON LABS PANIC BUTTON User manual

AEON LABS PANIC BUTTON:
CONNECTING DEVICE:
First, install the device's battery.
Then, in the SmartThings mobile app:
1. Tap Marketplace
2. Under Things, tap Connect New Device (iOS) / Start Looking for Things (Android)
3. The app will say, I’m looking for Things… and display a spinning circle
4. While the Hub searches, press the Learn button on the device (using the provided button pin or a paper
clip)
The device’s light will pulse and then stay lit for 2 seconds when it joins with the Hub
5. When the device is discovered, the message # Thing(s) Found! will increment and the device will list
below
6. Tap the device to configure it
7. Follow the in-app prompts to configure the device
8. When finished, tap Done
TO RESET THE AEON LABS PANIC BUTTON:
If the Aeon Labs Panic Button was not discovered, you may need to reset, or “exclude,” the device
before it can successfully connect with the SmartThings Hub. To do this in the SmartThings mobile app:
1. Tap the menu
2. Tap the Hub
3. Tap Z-Wave Utilities
4. Tap General Device Exclusion
5. When prompted, press the Learn button on the device (using the provided button pin or a paper clip)
After the app indicates that the device was successfully removed from SmartThings, follow the first set
of instructions above to connect the Aeon Labs Panic Button.
TO REMOVE THE AEON LABS PANIC BUTTON FROM SMARTTHINGS:
If the Aeon Labs Panic Button is connected but not performing as normal, you may need to remove the
device and reconnect it with the SmartThings Hub.
To remove the device via the SmartThings app:
1. Tap My Home
2. Tap Things
3. Select the device
4. Tap the gear icon
5. Tap Remove
6. Confirm removal

When prompted, perform the exclusion procedure to remove the device from the mobile app and from
the SmartThings Hub
AS A QUICK REMINDER, THESE DEVICES AND SERVICES
ARE ONLY TO ASSIST YOU IN MONITORING YOUR
LOVED ONES AND/OR YOUR HOME AND ARE NEVER
MEANT TO REPLACE MEDICAL CARE OR EMERGENCY
SERVICES.