SMARTdesks TAO User manual

TAO Assembly Instructions
Place tops face down on a blanketed surface.
Install post legs with 1/4-20 hex head Phillips Drive
bolts into installed inserts.
TAO TABLE TOP, 60", BLACK
TUBULAR STEEL LEG, 2"Ø, & HARDWARE
ROUND COVE UNIT, 1 POWER - 2 USB
TTT-60-B (#1)
TTT-60-B (#2)
60.000
Install Plako Table Connectors into the pilot holes.
Place the hub into the closed
circle of the interlocking part,
then install the hub with 4 screws
(provided).
Each Plako Connector consists of
2 hubs and 2 interlocking parts.
The interlocks snap around the
hubs to connect the table. This is
done in 2 locations.
Unlock the table sections and
turn over to proceed.

Standard Clamp
TAO Assembly Instructions
Install the Cove Round Power and Charging Center.
Insert the Cove through the cutout.
Place brackets and thumb nuts on stud. Tighten until
secure. Do not over-tighten.
Connect power as needed.
800 770 7042 | www.smartdesks.com