SMARTdesks Piatto User manual

Sheet of
1 3
SMARTDesks
83 Jacobs Road
Rockaway, NJ 07866
800-770-7042
WWW.SMARTDesks.com
Piatto Assembly Instructions
Refer to Parts Lists and Diagram of the assembled top to arrange the top sections in the
place they will occupy when completed. Take care to pad the assembly area to protect the
tops from damage. Keep hard metal objects away from this area. A stray screw, or a paper
clip can ruin everything.
Separate instuctions are included for installing the flipIT units. These will be installed after
the table is assembled.
Step 1: Assemble Support
Plates to Base Panels
Use #14 x 1 1/4" screws to install the two Support Plates to
the top of the Base Panel in the machined notches as
indicated in the image.
Step 2: Subassemble Keel Side
Panels to Base Panels
Install (4) Connecting Bolts into the threaded inserts in the
Base Panel for each Base Panel. Slide the Keel Side Panels
on the the Connecting Bolts and insert Minifix Connector
with arrow toward the Base Panel. Tighten the Minfix
Connector to the connecting bolt.
Adjust the position of the first Base Assembly Section to the
correct placement in the room and continue the same
assembly steps until all Base Panels are assembled per the
provided assembly drawing.

Sheet of
2 3
SMARTDesks
83 Jacobs Road
Rockaway, NJ 07866
800-770-7042
WWW.SMARTDesks.com
Step 3: Assemble the end
top to the correct base
section.
Use hex head 1/4-20 bolts the the support plates to
attach the end top to the correct base section as
indicated by the assembly drawing.
Install (6) Zipbolts to join the Tops together and
align the surfaces to be flush. These will be
tightened after the entire unit is complete.
Step 4: Attached the next
section of Top Panel.
Assemble the next section of Tops to the Base
Assembly per the Assembly Drawing and attach with
1/4-20 Hex Head Bolts.
Continue assembling Top Panels until all tops are
assembled.
Step 5: Attach Angle
Brackets to Keel.
Assemble the Metal Angle Brackets using
(6) #12 x 1/2" wood screws to the under
side of the Top and to the Keel Side Panel.
ZipBolt Connector
Metal Angle Bracket
Keel Side Panel

Sheet of
3 3
SMARTDesks
83 Jacobs Road
Rockaway, NJ 07866
800-770-7042
WWW.SMARTDesks.com
Step 6: Run Wiring for Computers and Install
Bottom Keel Panel.
Run required wiring (to be provide by others) for computer connections through the
available wire management areas in the Base Panels and in the Keel.
Attach the Bottom Keel Panel as indicated using Connecting Bolts and Minifix Connectors.
Step 7: Adjust and Tighten All
Connection Points
Make any necessary adjustments to the table assembly and tighten all
connection points.
Install Flipit Mechanisms and Keyboards using the supplied instructions for those
items.
Connecting Bolts
Minifix Connectors