Smith's Heating First SS80E User manual

Products with this symbol (crossed out wheelie bin) cannot be disposed as household waste. Old electrical
and electronic equipment must be recycled at a facility capable of handling these products and their
waste by-products. If you are purchasing replacement equipment your retailer may offer a 'take back'
scheme, or will be able to give details of the nearest approved authorised treatment facility. Proper
recycling and waste disposal will help conserve resources whilst preventing detrimental effects on our
health and the environment.
WEEE Registered Code: WEE/ED0093VW
Accessory grilles which fit in place standard grille are available in different
colours and finishes. Please consult the price list for details. In the event of
any items missing or visible damage, please contact us on 01245 324560.
Please leave this Installation & User Guide and the Guarantee Registration
Card with the intended user.
Approved CQS ISO 9001:2008
For Ireland, contact MT Agencies (Ireland) Ltd on Tel: [phone]
July 2016 8 issue 003
Space Saver
SS80E
Installation and User Guide

Safety Instructions
Read before continuing with installation or use of the product.
Disconnection must be incorporated in the fixed wiring in accordance
with the wiring rules.
If the supply cord is damaged, it must be replaced by a special cord or
assembly available from the manufacturer or its service agent.
WARNING: In order to avoid overheating, do not cover the heater
WARNING: This heater is not built with an integral thermostat to control
the room temperature; the facility to connect an external room
thermostat is included (See page 7).
Do not use this heater in small rooms when they are occupied by
persons not capable of leaving the on their own, unless constant
supervision is provided.
Children of less than 3 years should be kept away unless continuously
supervised.
Children aged from 3 years and less than 8 years shall only switch on/
off the appliance provided that it has been placed or installed in its
intended normal operation position and they have been give supervision
or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children aged from 3 years or less
than 8 years shall not plug in, regulate and clean the appliance or
perform user maintenance.
CAUTION –Some parts of this product can become very hot and cause
burns. Particular attention has to be given where the children and
vulnerable people are present.
Under no circumstances must the terminal block, intended to link to a
room thermostat (see page 7), be used to connect the heater to the
supply mains. All wiring must be carried out by a qualified electrician in
accordance with wiring rules.
2
Notes:
__________________________________________
__________________________________________
__________________________________________
__________________________________________
__________________________________________
__________________________________________
__________________________________________
__________________________________________
__________________________________________
__________________________________________
__________________________________________
__________________________________________
__________________________________________
__________________________________________
__________________________________________
__________________________________________
__________________________________________
__________________________________________
__________________________________________
__________________________________________
__________________________________________
__________________________________________
__________________________________________
__________________________________________
__________________________________________
__________________________________________
_________________________________________
7

REMOVE SCREWS AND
REMOVE PANEL
L
T2
N
E
T1
CHASSIS
EARTH
CABLE
CLAMP
BLUE
GREEN
PURPLE
BROWN
T1-T2 LinkWire
A
A
A
B
B
1
2
3
Thermostat Wiring:
1. To link a room thermostat remove the electrical panel on the back of the unit by
removing the 2 fixing screws (See below diagram)
2. Remove T1 –T2 link wire (See above diagram) and connect room thermostat (not
supplied) following the manufacturer’s instructions.
6
SS 80 mm
The following items should be included in the carton:
Product complete with stainless steel grille and plug and play lead.
Fixing screws (2).
Installation Guide
1. We recommend the use of a kneepad when
installing this product. Cut the opening in the plinth
using method 1, 2 or 3 (Method 1 represents
installation into an 80mm plinth).
3
Model Width A Width B
SS 80E 400 mm 74mm
Space Saver is primarily intended for
installation in the space beneath kitchen
cupboards behind the plinth. However it
can also be installed in similar applications
such as stair risers and other built-in
furniture.
This Space Saver model must not be
installed in a bathroom or other high
humidity area. Please contact us on 01245
324560 for details of products suitable for
these applications.
Space Saver is classified as a fixed
appliance and electrical connection should
be via a double pole 10A fused spur. The
fused spur must not be directly above the
heater but should be accessible after
completion of the installation.
If the mains cable is damaged, it must be
replaced by either the manufacturer, its
service agent or similarly qualified persons.
The appliance must be earthed.
To avoid the possibility of vibration, this
product must be installed on a flat, even
surface.
To conform with Building Regulations Part L
(Part J in Scotland), a remote room
thermostat (Smith’s Part No. 08-0826) can
be used in conjunction with this Space
Saver fan convector.
Please note the guarantee may be
invalidated if this product is not
installed and used in accordance with
this guide.

203 9
212
77
70
MAINS SUPPLY
WITHPLUG
78 78
460
304
Grille to plinth securing screws
ELECTRICAL
CABLE
PLINTH
2. Isolate the electrical supply and
connect the heater the electrical cable
to the 10A fused spur. The fused spur
must not be directly above the heater
but should be accessible after
completion of the installation.
3. Note if a room thermostat is to be
fitted refer to page 7 before
continuing.
4. Plug the electrical cable into the
heater.
5. Position the heater ensuring that the electrical cable is not snagged.
6. Fix the heater to the plinth
Heating
Before switching the heater on for the first time ensure the fascia grille is free from obstruction.
Ensure the fused spur is switch ON. Set the thermostat
(If fitted) to maximum.
Set the upper fan switch and the middle 600W switch to
the ON position. If a higher heat setting is required
then set the bottom 1200W switch to the ON position.
Set the thermostat (If fitted) to its required setting.
Air Circulation (Summer Use)
The heater may be used in fan only mode by setting the upper switch to the ON position, both
other switches must be OFF.
4
Fault Finding
1. The fan does not run/ no heat output
a. Check the power supply is switched ON.
b. Check the fuse in the fused spur.
c. Check the switches on fan switch is in the on position on the heater
2. If the overheat protection has activated, manually reset as follows.
a. Switch the power supply OFF at the fused spur
b. Wait five minutes for the overheat cut out switch to reset
c. Switch the power supply back ON at the fused spur
This Space Saver is covered by a free 5-year parts and labour guarantee.
In the event of difficulty, please contact us on 01245 324560.
Dimensional Drawing:
5
Fan
600 W
1200 W

Guarantee Statement
Thank you for purchasing a Smith’s heater.
It has been designed and manufactured to the highest quality standards to ensure it
gives you efficient and trouble-free service for many years.
To back up our commitment, included with your product is a free five year parts
and labour guarantee.
This gives you peace of mind that in the unlikely event of the product failing within
the first five years, we will repair or replace the product completely free of charge
provided the product has been installed, used and maintained in accordance with the
instructions.
It is important to register within 7 days. This will ensure you receive a prompt and
efficient service, if your product requires attention within the guarantee period. If you
do not register your product, you will be required to produce a proof of purchase prior
to receiving this service.
If you experience any problems with the use of your product, please contact our
after-sales office on 01245 324560.
Smith’s Environmental Products Ltd manufactures a complete range of heaters for
domestic and commercial applications.
If you require any further information, please contact us on 01245 324900 or visit
our website at www.smiths-env.com.
Your statutory rights are not affected by this guarantee.
Please pull this Registration card from the
booklet and fill in all parts and return.

Guarantee Registration Card
& Customer Satisfaction Survey
Dear Customer
We hope our product suits all your requirements; it would help us immensely if you could find the time to
fill in this form, your response will help us maintain the quality standards we all expect in today’s climate.
Customer name ________________________________________ Date_____/_____/__________
Email Address ____________________________@________________________________________
Product Name ______________________________________________________________________
Tick as appropriate
V Good Good Fair Poor
Product
Delivery
Sales & Ordering
Response to
any problems
Comments …………………………………………………………………………………………………
………………………………………………………………………………………………..
………………………………………………………………………………………………..
Thank you for your time to fill in this survey, the response will help us to serve your
needs more effectively. Please return by fax to 01245324422.
Quality Control Manager: Ron Brown [e-mail]
User Details
User Name Mr/Mrs/Miss/Ms/Other ……………………………………………………………………………
Initials …………………. Surname ………………………………………………………………………………
Address ………………………………………………………………………………………………………………….
………………………………………………………………………………………………………………………………
…………………………………………………………………… Post Code: …………………………………
Telephone: ……………………………………………………………………………………………………………..
Product & Model installed (e.g. Space Saver SS5)
……………………………………………………………………………………………………………………………….
Room Installed (e.g. Kitchen): …………………………………………………………………………………..
Your details will only be held by Smiths Environmental Products Ltd and used solely to
provide customer services and product information.
If you do not wish to be contacted, please put an x in the box.
Installer Details
Company name: …………………..
Principal contact: Mr/Mrs/Miss/Ms/Other: …………………………………………………………………
Initials: ………………… Surname: ……………………………………………………………………………
Address: …………………………………………………………………………………………………………………
………………………………………………………………………………………………………………………………
…………………………………………………………………… Post Code: ……………………………………
Telephone: …………………………………………………………………………………………………………….
Date of installation ……………/……………/………………
Room Installed (e.g. Kitchen): …………………………………………………………………………………..
Your details will only be held by Smiths Environmental Products Ltd and used solely to
provide customer services and product information.
If you do not wish to be contacted, please put an x in the box.