
Instruction
Caution
Washing instructions
Product views
1. Separate the liner from the brace and open the
leg and foot sections of the liner by detaching
the hook-loop fasteners.
Then, slide foot and lower leg into the liner.
2. Attach the fasteners of liner, and make sure the
lower limb is wrapped snugly around by the liner.
3. Insert wrapped limb into brace frame between
the two uprights. The uprights should be
centered carefully over the ankle to ensure a
comfortable fit and proper support.
4. Tighten the foot straps that secure the foot in the
brace. The foot straps should fit snugly. These
straps can be adjusted by simply loosening or
tightening the hook-loop fastener.Next, tighten
the leg straps to secure the leg between the
uprights.Adjust the fastener to the foot and
working up the leg. The last strap should be
secured snugly around the uprights to ensure
closely fixed and properly aligned.
Front
1
2
4
5
3
1. Separate the liners and the plastic shell before
washing.
2. Shell: The surface can be cleaned with damp cloth.
3. Liner: Hand wash with mild detergent.
4. Rinse thoroughly and air dry.
5. Avoid direct exposure to sunlight.
1. The product should be used under the supervision
of a medical professional.
2. Over tightening of strap may compromise blood
circulation.
3. If discomfort or pain results and persists, please
discontinue wearing and consult with medical
professional.
4. Make sure the fasteners are well fastened while
wearing the brace. If the fasteners can not be
fastened well, please stop using the brace to
prevent injuries.
5. If product is in poor condition, please do not use it.
6. While walking with brace, foot should step on the
ground at a right angle (90°). Do not land
diagonally.
7. Stop wearing when the sole is worn.