Soldron 938 User manual

Thank you customer for choosing Soldron as your preferred brand. As
this will give you perfect soldering with long life and reliability. We also
offer you service and assistance in order to help you maintain your
product in perfect working condition.
938
STATION
1) Higher soldering temperatures can reduce the life of the tip (Try to use lower
temperatures wherever possible)
2) Clean the tip with the provided cleaning sponge to remove all oxides and flux
deposits on the tip. This improves the effectives of the bit over long term usage.
3) After the soldering job is complete, clean the tip and coat it with solder to enhance
its life.
4) CAUTION!: Using files and abrasive material to clean the tip, will wear away the
protective iron coating to expose the copper, which will make the tip useless.
5) When the tip develops a hole due to wear of protective iron coating, it's time to
purchase and replace the bit with an original Soldron bit.
1) Put the iron in the provided stand.
2) Connect the iron plug in the iron socket provided on station.
3) Connect the power cord into the mains.
4) Turn on the power switch located on the left side of the station.
5) Set the temperature using knob as per requirement.
6) Once the iron reach to the preset temperature the display will show a blinking dot(.)
after3 digit.
7) The iron is now ready for use.
8) Station enters into sleep mode after 15 mints of inactive.
Set up and operation:
Important Points for tip care
TEMPERATURE CONTROLLED ANALOG
SOLDERING STATION

• Station x 1
• Iron (with MCH element) x 1
• Iron Stand with Cleaning Sponge x 1
• Instruction Leaflet x 1
Package Contents :
WARNING!
Misuse may potentially cause death of, or serious injury to, the user.
CAUTION!
Warning and Caution are defined as follows:
Misuse may potentially cause death or serious injury to
the user. Proper diligence has to be used by the user in order to avoid injury or physical
damage to objects and or fire hazard.
• When the power is on, tip temperature is between 200°C/392°F and 480°C/896 °F.
hese tempera tures are potentially high enough to cause the following:
• Serious burn injuries may cause by touching the metallic parts of iron.
• Can cause fires if product comes in contact with inflammable objects.
• People in the vicinity of the product should be warned about it's potential dangers.
• Power should be off when not being used.
• Before replacing parts on the unit, be sure to switch off the unit and allow ample time
for cooling to ambient.
The following conditions must be strictly be adhered to while using this product.
• Use for soldering applications only
• Banging the solder ing iron against hard surfaces to remove extra solder may result in
damage to product beyond warranty and cause short
• circuit or shock hazard.
• Do not attempt to modify the unit as warranty will be void.
• Use only genuine Soldron®Replacement parts.
Calibration is necessary after replacement of the iron or element
Calibration of the station:
Specifications:
Name
Soldron
®
938
Power Consumption
Input Voltage
Output Voltage
Temperature Range
Dimensions
Weight
Type
Type of element
Tipto ground resistance
60W (Iron with Station)
230V AC 50Hz
24V AC
200°C/392°F & 450°C
120(L) X 93(W) X 70(H) mm
1300g
Digitally Controlled
> 2ohms
Metallised Ceramic Heater
(MCH) With Sensor
Manufactured in india
By
Vimla Engineering
A2/157,S. & N. lnd. Estate,
Lower PareI,
Mumbai - 400 013.
Tel No. : 022-48973337
www.soldron.com