Solid Signal CDLRC User manual

CAMERA DETECTOR WITH
DIRECTIONAL FINDER
SKU: CDLRC
THANK YOU FOR PURCHASING THE CAMERA DETECTOR
WITH DIRECTIONAL FINDER
Please read this manual before operating the Camera Detector with
Directional Finder and keep it handy.
Are you worried that you may be being filmed or listened to without
your knowledge? Check homes and offices for wireless devices. This
wireless detector will expose both wired and wireless cameras, dead
or alive. The ultra-advanced hand held unit will also let you know
about RF bugs and wiretaps in one of three ways: with an alarm,
silent LED or silent vibration. The built-in compass makes locating and
noting where bugs are during large building sweeps a breeze.
Detects hidden video cameras dead or alive
Wide range sweep for bugs from 1MHz-6500 MHz.
Detects wired & wireless hidden video cameras
Silent alert vibration mode
Alarm alert mode
Silent LED alert mode
Instant auto-detecting function
Sweeps and detects VHF, UHF, GSM bugs.
Very small, lightweight, and portable size
Adjustable sensitivity
Multi-alarming mode: vibrating, beeping & LED
Viewfinder combined with flashing LEDs for detecting camera lens
Your purchase should include:
1 x Camera Detector with Directional Finder
1 x Power Adapter
1 x Set of Ear buds
1 x Instruction Booklet

GET FAMILIAR WITH YOUR CAMERA DETECTOR WITH
DIRECTIONAL FINDER
Antenna
Source
Indicator Lights
Compass
Laser Button
Power/Mode
Switch
Sensitivity
Adjuster
Viewing
Window
Speaker Headphone
Port
Charging
Port

OPERATING THE CAMERA DETECTOR WITH DIRECTIONAL
FINDER
IMPORTANT NOTICE: Allow the device to charge 4 – 6 hours before
using.
HOW TO CHARGE THE DEVICE
1. Ensure the device is turned OFF
2. Plug the power adapter into the charging port of the device
3. Plug the power adapter into a power outlet
 The blue indicator light behind the compass will turn
on
HOW TO TURN THE DEVICE ON
1. Move the power switch up into the mode of your choice
 The blue indicator light behind the compass will turn
on
TIP:
 First position uses sound indication and can be used with the
ear buds
 Second position uses vibration indication
HOW TO DETECT CAMERA LENSES
1. Turn the device on
2. Press the Laser Button
 The red laser lights on the back of the device will flash
3. Look through the viewing window on the front of the device
 Camera lenses will appear as white/blue flickering
lights
4. Press the Laser Button again to turn off camera lens detection
TIP: Holding the Laser Button will increase the flash frequency of the
laser lights and make camera lenses more visible
HOW TO DETECT RADIO WAVES (WIRELESS CAMERAS,
LISTENING DEVICES, ETC.)
1. Turn the device on
2. Move the device around your environment to find the radio
wave source
 The red source indicator lights will increase with
proximity to the radio wave source
TIP: Extend the antenna to increase detection range
TROUBLESHOOTING
THE DEVICE WON’T TURN ON
 Charge the device for at least 4 hours before the first use
 Make sure the charging cable is securely inserted into the
device and into the power source
THE DEVICE ISN’T CHARGING
 Replace the battery or charging cable
 If you are charging via a wall power source, you may need to
charge via your PC. The AC adapter might be bad
THE DEVICE HAS CRASHED
 You need to reset the device
SPECIFICATIONS
Water Resistant
No
Battery Life
3-4 Hours