Sonic Alert Sonic Boom SB1000 User manual

2) If within 1 minute no black button on the front is pressed, then
it will exit the Test Mode and return back to the Time Mode.
3) While in Test Mode, sliding the Outlet Switch will demonstrate
the different functions of the clock.
4) After you are finished with the Test Mode, press any button
(expect the Snooze, Time and Lamp buttons, which has no
effect) it will exit the Test mode immediately.
time

* Press and hold the ALARM button (5) for six seconds. The clock
display will show the default alarm duration as ‘30’, release the
ALARM button.
Pressing the blus SNOOZE button will turn the alarm signals off for
nine minutes. After nine minutes, the alarm will go on again.
Pressing the ALARM OFF button will turn the alarm off and
automatically reset the alarm to go on at the same time the next day.
Setting the OUTLETS switch to OFF turns off the alarm. The alarm
will not go off again until you set the OUTLETS switch back to
LAMP, VIB, or BOTH.
Adjusting The Snooze Duration
The default snooze duration setting is 9 minutes but you may adjust
the snooze duration between 1 minute and 30 minutes as desired.
To adjust the snooze duration:
* Press and hold the SNOOZE button for four seconds. The clock
display will show the default snooze time ‘9’.
* Press the “MIN” button to adjust the snooze duration to the desired
setting, from 1 minute to 30 minutes.
* When the display is showing the desired snooze duration, it will
return to the normal clock mode after 3 seconds. The new snooze
duration setting becomes the new default and remains in the
memory until you change it again.
Auto Dimmer
Dimmer Operation
Auto dimmer built in.
Battery Backup
In the event of a power interruption, the Sonic Boom alarm clock can
use battery to save your time and alarm settings until power is
restored.
To use battery backup, you can install a 9V battery (not provided) in
the clock.

• DB100/200 Doorbell Signaler
• TR75VR Telephone Signaler
• BC400 Baby Cry Signaler
To turn the clock’s remote receiver on for use with a remote
transmitter, locate the RECEIVER ON/OFF button and set it to ON
Working with Remote Transmitter
Press and hold the ALARM OFF button for 3 seconds to toggle
RECEIVER between ON/OFF status. There is a round indicator light
at the top right corner to indicate status. The software default setting
is ON.
If you are not using Sonic Alert remote transmitters, or if you do not
want the clock to respond to a transmitter, set the mode to OFF.
Receiver On/Off
Button