Sonnen sonnenBatterie eco 8.2 User manual

sonnen Installation Practical

sonnen Components

416.08.2016 sonnen Australia Pty Ltd
sonnenBatterie eco 8.0 –Single Phase
System Components

516.08.2016 sonnen Australia Pty Ltd
sonnenBatterie eco 8.0 –Single Phase
System Components

616.08.2016 sonnen Australia Pty Ltd
sonnenBatterie eco 8.0 –Single Phase
System Components –Main Cabinet

716.08.2016 sonnen Australia Pty Ltd
sonnenBatterie eco 8.0 –Single Phase
System Components –Battery Module

816.08.2016 sonnen Australia Pty Ltd
sonnenBatterie eco 8.0 –Single Phase
System Components Extension Cabinets & Pedestal

916.08.2016 sonnen Australia Pty Ltd
sonnenBatterie eco 8.0 –Single Phase
System Component Descriptions

sonnen Installation

1116.08.2016 sonnen Australia Pty Ltd
sonnenBatterie eco 8.2 –Single Phase
Technical Data

1216.08.2016 sonnen Australia Pty Ltd
sonnenBatterie eco 8.2 –Single Phase
Technical Data

1316.08.2016 sonnen Australia Pty Ltd
sonnenBatterie eco 8.2 –Single Phase
Technical Data –Charge Rates

1416.08.2016 sonnen Australia Pty Ltd
sonnenBatterie eco 8.2 –Single Phase
Warnings
Touching components inside the storage
system poses a danger to life due to
electrocution.
»Do not touch any components.
»Do not remove any plastic covers.
»Never reach below covers.
When carrying our electrical work on the
storage system, the following must be
observed:
»Switch off the storage system.
»Disconnect the relevant electrical
circuits.
»Secure against anyone switching on the
device again.
»Check that the device is disconnected
from the power supply.
»Only authorised electricians are
permitted to carry out electrical work.

1516.08.2016 sonnen Australia Pty Ltd
sonnenBatterie eco 8.2 –Single Phase
Warnings
When working on the DC circuit:
»Set aside metal jewellery.
»Switch off the storage system.
»Switch off the series fuse.
»Fuse connectors on all battery modules
ae supplied separately do not install
until commissioning system.
Risk of Burns:
»Very high short-circuit currents are
possible and the following must be
observed when working with the battery
modules:
»The battery module is activated when
the fuse connector is plugged in. The
voltage runs between the plus and
minus contacts of the battery module
(nominal voltage of battery modules
51.2 V DC).
»The battery module is deactivated when
the fuse connector is unplugged. No
voltage runs between the plus and
minus contacts of the battery module. If
all interconnected battery modules are
deactivated, it is safe to work on a
battery module.

1616.08.2016 sonnen Australia Pty Ltd
sonnenBatterie eco 8.2 –Single Phase
Location Selection
Observing minimum distances.
»Observe the specified minimum
distances to neighbouring objects.
»The minimum distances ensure that:
»there is sufficient heat dissipation,
the storage system door can be
opened easily and
»there is sufficient space for
maintenance work.

1716.08.2016 sonnen Australia Pty Ltd
sonnenBatterie eco 8.2 –Single Phase
Safe Handling of Equipment

1816.08.2016 sonnen Australia Pty Ltd
sonnenBatterie eco 8.2 –Single Phase
Safe Handling of Equipment

1916.08.2016 sonnen Australia Pty Ltd
sonnenBatterie eco 8.2 –Single Phase
OH&S + Risk Assessment & Work Site Safety

2016.08.2016 sonnen Australia Pty Ltd
sonnenBatterie eco 8.2 –Single Phase
Location Selection
Component Options.
»The storage system with the optional
extension cabinet must be floor
mounted.
»A storage system without the optional
extension cabinet must be mounted
to the wall with screws.
»Use only screws with the following
properties:
»The diameter of the screw head
(see figure) must be between 13
mm and 15 mm.
»The screw diameter must be 8
mm.
»The screw head must not
exceed 5mm.