Sony SPK-HCB User manual

Sony EMCS Co.
2006I1600-1
©2006.09
Published by Kohda TEC
9-876-923-11
SPK-HCB
SPK-HCB
SPORTS PACK
US Model
Canadian Model
AEP Model
SERVICE MANUAL
Ver. 1.1 2006. 09
SPECIFICATIONS
Material
Plastic (PC, ABS), glass
Waterproof
O-ring, buckles
Built-in microphone
Stereo
Dimension
Approx. 159 ×148 ×203 mm (w / h / d) (6 3/8 ×5 7/8 ×8 inches)
Mass
Approx. 930 g (2 lb 1 oz) (only sports pack)
Included items
Sports pack (1), Shoulder strap (1), Camera mounting shoe (A (1)/B (1)/C (1)),
Tripod screw plate (1), Reflex prevention ring (Ø 25 (1)/M30 ×Ø 62 (1)/M30 ×Ø 43
(1)), Grease (1), Spacer (1), Anti-fogging lens solution (1), Desiccant (1), Set of
printed documentation
Design and specifications subject to change without notice.

— 2 —
SPK-HCB
TABLE OF CONTENTS
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK 0OR DOTTED LINEWITH
MARK 0ON THE SCHEMATIC DIAGRAMS AND IN THE PARTS
LIST ARE CRITICAL TO SAFE OPERATION. REPLACE THESE
COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS
APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS
PUBLISHED BY SONY.
ATTENTION AU COMPOSANT AYANT RAPPORT
À LA SÉCURITÉ!
LES COMPOSANTS IDENTIFÉS PAR UNE MARQUE 0SUR LES
DIAGRAMMES SCHÉMATIQUES ET LA LISTE DES PIÈCES SONT
CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT. NE
REMPLACER CES COMPOSANTS QUE PAR DES PIÈSES SONY
DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL OU
DANS LES SUPPÉMENTS PUBLIÉS PAR SONY.
1. Check thearea ofyourrepair for unsolderedorpoorly-soldered
connections. Checkthe entire boardsurfaceforsolder splashes
and bridges.
2. Check the interboard wiring to ensure that no wires are
"pinched" or contact high-wattage resistors.
3. Look for unauthorized replacement parts, particularly
transistors, that were installed during a previous repair. Point
them out to the customer and recommend their replacement.
4. Look for partswhich,through functioning, show obvioussigns
of deterioration. Point them out to the customer and
recommend their replacement.
5. Check the B+ voltage to see it is at the values specified.
6. Flexible Circuit Board Repairing
• Keep the temperature of the soldering iron around 270˚C
during repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
SAFETY CHECK-OUT
After correcting the original service problem, perform the following
safety checks before releasing the set to the customer.
1. GENERAL
Precautions on Use ······································································· 3
Handling the O-ring······································································ 3
Maintenance ················································································· 3
Troubleshooting ············································································ 3
Using the Sports Pack··································································· 3
2. REPAIR PARTS LIST
2.1 EXPLODED VIEWS ························································· 5
2-1-1.OVERALL SECTION························································ 5
2-1-2.FRONT CASE SECTION ·················································· 6
ACCESSORIES LIST ·································································· 7

—3 —
SPK-HCB
1. GENERAL

—4 —
SPK-HCB

— 5 —
SPK-HCB
2. REPAIR PARTS LIST
2-1. EXPLODED VIEWS
NOTE:
• -XX, -X mean standardized parts, so they may
have some differences from the original one.
• Items marked “*” are not stocked since they
are seldom required for routine service. Some
delayshouldbe anticipated when orderingthese
items.
• Themechanicalpartswith no reference number
in the exploded views are not supplied.
2-1-1. OVERALL SECTION
Ref. No. Part No. Description Ref. No. Part No. Description
1 2-580-983-01 SHAFT, HINGE
2 2-668-973-01 CASE, REAR
03 2-668-985-01 O RING, MAIN (Note1)
4 A-1174-866-A HOOD ASSY, MIRROR
5 2-580-955-01 MIRROR
6 2-580-954-01 HOOD, MIRROR
7 2-580-969-01 SHAFT, BUCKLE
8 2-589-138-01 RETAINER, GRIP
9 3-076-866-01 BIND (2X6), TAPPING SCREW
10 A-1105-402-A GRIP BELT ASSY
11 2-634-715-01 TUBE, GRIP BELT
12 2-580-957-01 BUCKLE
13 3-951-813-11 SCREW (2X6) (TYPE 2), +K
014 3-073-881-01 CAP (RED), AIR PUNCHING
15 2-580-959-01 KNOB, BUCKLE SLIDER
16 2-589-297-01 LOCK, BUCKLE
17 2-589-298-01 SPRING, BUCKLE LOCK
18 2-593-190-01 SLIDER (LOWER), BUCKLE
19 2-651-030-01 SPRING, SLIDER
20 2-580-958-01 SLIDER, BUCKLE
21 2-580-961-01 PLATE, BUCKLE RETAINER
22 3-052-424-01 SHAFT, GRIP
(Note1) When putting grease the main O-ring (Ref. No. 3),
always use the grease of the blue tube of the accessory.
When using the grease of the yellow tube and the grease
of the other Inc., it hurts the main O-ring and it causes the
water leakage.
Note :
The marked “ 0 ” are parts in
relation to waterproof.
Replacethesecomponents with
Sony parts.
Be sure to check up waterproof
after repair.
Note :
La0marquée sontdes piècespar
rapport à imperméable à l’eau.
Ne les remplacer que par une
pièceportant lenumérospécifié.
Soyez sûrdevérifiervers lehaut
d’imperméable à l’eau après la
réparation.
1
1
2
3
4
5
6
7
13
99
9
9
10
12
14
15
16
17
18
19
20
21
22
8
11
ns
ns
ns
ns
(Note 1)
Front case section
(See page 6)
ns : not supplied

— 6 —
SPK-HCB
2-1-2. FRONT CASE SECTION
Ref. No. Part No. Description Ref. No. Part No. Description
51 3-076-866-01 BIND (2X6), TAPPING SCREW
52 A-1175-085-A SPK-001 BOARD, COMPLETE (Note2)
53 2-668-979-01 BOX, CONTROL
54 - CAUTION - HIMERON
*55 3-959-469-01 PLATE, TRIPOD SCREW
56 3-091-040-01 SCREW (2.6X6), TAPPING
57 2-668-974-01 LENS (WINDOW RETAINER)
58 2-668-987-01 GLASS, LENS WINDOW
059 2-668-986-01 PACKING, LENS WINDOW (Note3)
60 X-2108-848-1 FRONT CASE ASSY
061 A-7095-209-A MICROPHONE BLOCK ASSY
62 2-668-980-01 LIGHT, GUIDE,
63 2-342-952-01 SCREW (1.7X4 #0-1), TP
64 2-668-977-01 COVER, MICROPHONE
65 2-668-992-01 SHEET, INDICATION
66 2-668-976-01 COVER, CONTROL
67 1-832-162-11 CORD, CONNECTION (AV MULTIPLE)
68 A-1174-862-A BASE (A) BLOCK ASSY
69 X-2048-702-1 BASE ASSY, SCREW
70 2-593-204-01 LABEL, TEMPERATURE CAUTION
71 2-668-975-01 COVER, LENS WINDOW
72 2-668-993-01 COVER, CODE
ns : not supplied
(Note2) In this model, parts are exchange in order to repair only
the mounted board.
CAUTION :
For the part of 54: HIMERON (3-091-327-01) , cut WOVEN (T0.25),
FABRIC NON (3-076-631-01) into the desired length and use it.
Note :
The marked “ 0 ” are parts in
relation to waterproof.
Replace these components with
Sony parts.
Be sure to check up waterproof
after repair.
Note :
La 0marquée sont des pièces par
rapport à imperméable à l’ eau.
Ne les remplacer que par une
pièce portant le numéro spécifié.
Soyez sûr de vérifier vers le haut
d’ imperméable à l’ eau après la
réparation.
(Note3) When putting grease the lens window packing (Ref. No.
59), always use the grease of the blue tube of the acces-
sory. When using the grease of the yellow tube and the
grease of the other Inc., it hurts the lens window packing
and it causes the water leakage.
SPK
-001
51
52
53
55
56
70
57
58
59
65 60
62
51
51
67
68
69
51
71
ns
ns
ns
ns
(Note 3)
51
51
66
61
51
64
63
72
(SIZE : 12mm × 38mm)
54
(Note 2)
CAUTION

— 7 —
SPK-HCB
Checking supplied accessories.
Other accessories
*2-667-229-11 OPERATING INSTRUCTIONS
(ENGLISH/FRENCH/SPANISH/GERMAN)
*2-667-229-21 OPERATING INSTRUCTIONS
(ITALIAN/DUTCH/PORTUGUESE/SWEDISH)(AEP)
*2-667-229-31 OPERATING INSTRUCTIONS
(RUSSIAN/ARABIC/TRADITIONAL CHINESE/
SIMPLIFIED CHINESE/KOREAN)(AEP)
2-667-230-01 OPERATING INSTRUCTIONS (PREPARATION)
(JAPANESE/ENGLISH/FRENCH/GERMAN/
SPANISH/DUTCH/SWEDISH/ITALIAN/
PORTUGUESE/RUSSIAN/ARABIC/
TRADITIONAL CHINESE/
SIMPLIFIED CHINESE/KOREAN)
Make sure that the following accessories are supplied with your camcorder.
Note :
The marked “ 0 ” are parts in
relation to waterproof.
Replace these components with
Sony parts.
Be sure to check up waterproof
after repair.
Note :
La 0marquée sont des pièces par
rapport à imperméable à l’ eau.
Ne les remplacer que par une
pièce portant le numéro spécifié.
Soyez sûr de vérifier vers le haut
d’ imperméable à l’ eau après la
réparation.
Grease (blue)
0 2-582-620-01
Anti-fogging lens solution
3-072-039-01
Reflex prevention ring (M30
× φ 43)
3-061-059-01
Reflex prevention ring ( φ 25)
3-088-917-01
Reflex prevention ring (M30 × φ 62)
2-668-984-01
2-672-371-01
Shoulder strap
A-1174-864-A
Base (C) block assy
* 3-959-469-01
Tripod screw plate
A-1174-863-A
Base (B) block assy
Screw base assy
not supplied
Spacer
3-941-348-01
Desiccant
2-672-372-01
Base (A) block assy
A-1174-862-A
X-2048-702-1

Sony EMCS Co.
2006I1600-1
©2006.09
Published by Kohda TEC
9-876-923-82
SERVICE MANUAL
SUPPLEMENT-1
File this supplement-1 with the service manual.
(DI06-067)
• Change of repair parts list
Ver.1.1 2006. 09
Page
XXX
54 - CAUTION - HIMERON
Ref. No. Part No. DescriptionRef. No. Part No. Description
2. REPAIR PARTS LIST
2-1. EXPLODED VIEWS : Deleted portion
Before change After change
6
2-1-2. FRONT CASE SECTION
SPK-HCB
SPK-HCB
US Model
Canadian Model
AEP Model
CAUTION :
For the part of 54: HIMERON (3-091-327-01) , cut WOVEN (T0.25),
FABRIC NON (3-076-631-01) into the desired length and use it.
(SIZE : 12mm × 38mm)
54 CAUTION
55
56
70
51
69
ns
72
55
56
70
51
69
ns
72

Revision History
987692312.pdf
SPK-HCB
Ver.
1.0
1.1
Date
2006.01
2006.09
History
Official Release
Supplement-1
(DI06-067)
Contents
—
• Change of repair parts list
S.M. Rev.
issued
—
No
Reverse