
To reduce the risk of fire or
electric shock, do not expose this
apparatus to rain or moisture.
To reduce the risk of fire, do not cover tile
ventilation of the apparatus with newspapers,
tahlecloths, curtains, etc. And do not place
lighted candles on tile apparatus.
To reduce the risk of fire or electric shock, do
not place ohjects filed with liquids, such as
vases, oil tile apparatus.
Connect the unit to an easily accessible AC
outlet. Should you nofice an abnormality in
the unit, discom*ect the main plug t?'om the AC
outlet immediately.
Do not install the appliance in a confined space,
such as a bookcase or built-in cabinet.
CAUTION
Tile use of optical instruments with this product
will increase eye hazard.
Except for customers in the U.S.A
and Canada
This appliance
is classifed
as a CLASS 1
LASER product.
This marking is
located on tile rear
exterior.
Notice for the customers in the
U.S.A
CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK/
NO USER-SERVICEABLE PARTS INSID£
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL
This symbol is intended to
alert the user to the presence
of uniusulated "dangerous
voltage" within tile product's
enclosure that may be of
sufficient magnitude to
constitute a risk of electric
shock to persons.
This symbol is intended to
alert the user to the presence
of important operating and
maintenance (servicing)
instructions in the literature
accompanying the appliance.
WARNING
This equipment has been tested and _tmd to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in
a residential installation. This eqnipment
generates, uses, and can radiate radio frequency
eum2zy and, if not installed and used in
accordance with the instructions, may cause
harmful interti?rence to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If
this equipment does cause harmful interti?reuce
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interf?rence by one or more of the fallowing
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment
and receiver.
- Connect the equipment into an outlet on
a circuit dil['erent from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV
technician tk)r help.
This device complies with Part 15 of tile FCC
Rules. Operation is sulziect to the falh)wing two
conditions:
(1) this device may not cause harmtM
interti?reuce, and (2) this device must accept any
interf?reuce received, including interference that
may cause undesired operation.
You are cautioned that any changes or
modilications not expressly approved in this
manual could void your authority to operate this
equipment.
2GB