Sorelle 1070-E User manual

Made in HY, China
Petite Paradise Elite (Room in a Box)
Assembly Instruction
Website: www.sorellefurniture.com
Important Information:
Read all instructions BEFORE assembling crib.
KEEP INSTRUTIONS FOR FUTURE USE.

Page 2
Sorelle
WARNING:
*Infants can suffocate on soft bedding. Never add a pillow or comforter. Never place additional padding
under an infant.
*Failure to follow these warnings and the assembly instructions could result in serious injury or death.
DO NOT use this crib if you cannot exactly follow the accompanying instructions.
*To reduce the risk of SIDS, pediatricians recommend healthy infants be placed on their backs to
sleep, unless otherwise advised by your physician.
*Strangulation Hazard: STRINGS CAN CAUSE STRANGULATION! Do not place items with a string
around a child's neck, such as hood strings or pacifier cords. Do not suspend strings over a crib or
attach strings to toys.
*Strangulation Hazard: To help prevent strangulation tighten all fasteners. A child can trap parts of
the body or clothing on loose fasteners.
*Strangulation Hazard: Do not place crib near window or patio door where cords from blinds or
drapes may strangle a child.
*Fall Hazard: When child is able to pull to a standing position, set mattress to lowest position and
remove bumper pads, large toys and other objects that could serve as steps for climbing out. This crib
has an adjustable mattress support. For the convenience of the parent when the baby is very small, the
mattress support may be used in the highest position. Important: with the mattress support and
mattress in the highest position, be absolutely sure that the top of the front crib side is at least 3 inches
higher then the top surface of the mattress. If it is not, lower the mattress support and the mattress to
the next highest position.
*Fall Hazard: Stop using crib when child begins to climb out or reaches a height of 35in. (89cm),
whichever occurs first. The child should be placed in a youth or regular bed.
*Check this product for damaged hardware, loose joints, loose bolts or other fasteners, missing parts,
or sharp edges before and after assembly and frequently during use. Securely tighten loose bolts and
other fasteners. Do not use crib if any parts are missing, damaged or broken. Contact C&T
International Inc. for replacement parts and instructional literature if needed. Do not substitute parts.
*Follow warnings on all products in a crib.
*If refinishing, use a non-toxic finish specified for children's products.
*Never use plastic shipping bags or other plastic film as mattress covers because they can cause
suffocation.
*Infants can suffocate in gaps between crib sides and a mattress that is too small.
*Ensure a safe environment for the child by checking regularly, before placing the child in the crib, that
every component is properly and securely in place.
*To avoid head injury, do not allow any child to play underneath the crib.
*Never add an accessory such as a bassinet or changing table that extends over the sleeping area.
C
Crib Warnings
AUTION : ANYMATTRESSUSEDINTHISCRIBMUST
BEAT LEAST 271/4”(69CM)x515/8”(131 CM) WITH
ATHICKNESSNOT EXCEEDING6”(15CM).

Page 3
Sorelle
C
Toddler Bed Warnings
Changing Table Warnings
TSUMUA
HTIW)AEB
ATH
WARNING
INFANTS HAVE DIED IN TODDLER BEDS FROM ENTRAPMENT.
Openings in and between bed parts can entrap head and neck of a small child.
NEVER use bed with children younger than 15 months.
ALWAYS follow assembly instructions.
The maximum user weight is 50lbs (22.7kg)
WARNING
STRANGULATION HAZARD
NEVER place bed near windows where cords from blinds or drapes may strangle a child.
NEVER suspend strings over a bed.
NEVER place items with a string, cord, or ribbon, such as hood strings or pacifier cords,
around a child's neck. These items may catch on bed parts.
CAUTION
ENTRAPMENT HAZARD
To avoid dangerous gaps, any mattress used in this bed shall be a full-size crib mattress
at least 51 5/8 in (1310mm) in length, 27 1/4 in (690mm) in width and 4 in (100mm) in
thickness. The mattress thickness must not exceed 6 in (150mm).
WARNING
FALL HAZARD - to prevent death or serious injury, always keep child within arm’s reach.
Read all instructions before use of the changing table.
KEEP THESE INSTRUCTIONS IN A SAFE PLACE FOR FUTURE USE.
Inspect the changing table periodically. Do not use the changing table if it is damaged or
broken. Contact C&T International Inc. with any questions.
Tighten all loose screws and bolts before each use.
The maximum recommended weight of the child is 30lbs for the changing table.
Use only the pad provided by C&T International Inc. or Manufacturer’s
Always secure the pad to the changing surface.See Instructions.
NEVER use crib without Changing Table attached

Page 4
Sorelle
C
AU
RIBMUST
BE A
CM) WITH
ATHI
NOTES ON ASSEMBLY:
-During the assembly process whenever using screws or bolts, check each by placing the screw/bolt on
the diagram of the item which is drawn actual size and design. Be sure to use the proper size and shape
specified in the instructions.
-To assemble this unit you may be required to place the unit on it’s side and face. It is strongly
recommended that assembly is done on a soft, non-abrasive surface to avoid damaging the finish.
NOTES ON CARE AND MAINTENANCE:
-Do not scratch or chip the finish.
- Inspect the product periodically, contact C&T International Inc. for replacement parts or questions.
-Do not store the product or any parts in extreme temperatures and conditions such as a hot attic or a
damp, cold basement. These extremes can cause a loss of structural integrity.
-To preserve the luster of the high quality finish on your product, it is recommended to place a doily or
felt pad under any items you place on the finish.
-Clean with a damp cloth, then a dry cloth to preserve the original luster and beauty of this fine finish.
-Do not use abrasive chemicals.
-Do not spray cleaners directly onto furniture.
-Lift slightly when moving on carpeting to prevent leg breakage.
-Use of a vaporizer near furniture will cause wood to swell and finish to peel.
NOTES ON USE:
Keep children and others safe by following these simple rules:
-Do not allow any child to play on furniture
-Do not allow climbing on any piece of furniture.
-Do not allow hanging from any piece of furniture.
- Always monitor your child’s activity when in the nursery.

Page 5
SORELLE
55mm Allen Bolts (8 pcs)
)scp 01( slewoD dooW)d()scp 01( stloB nellA mm24)b(
(c)17mm Allen Bolts (4 pcs)
(DRF)Right Front Corner Post (1 pc)
(DLF)Left Front Corner Post (1 pc)
(ERB)Right Back Corner Post (1 pc)
(ELB)Left Back Corner Post (1 pc)
Connect Sideframes to Corner Posts by using
Allen Key (e) and Allen Bolts (b)as figure shows.
DLF
ELB
DRF
ERB
b
b
d
d
d
d
b

Page 6
SORELLE
Connect Sideframes to Back frame (B)
by Allen Bolts (a).
Make sure plug in wooden dowels first.
Install the Metal Support (F) to the crib by using 4 pcs Allen Bolts (c).
This crib has a high position setup for use during your baby's first months.
As soon as your baby starts to sit up,you must use the lowest mattress level.
Front Frame assembly.
Your crib is now ready to use.
a
d
d
d

Page 7
SORELLE
(DRF)Right Front Corner Post (1 pc)
(DLF)Left Front Corner Post (1 pc)
(ERB)Right Back Corner Post (1 pc)
(ELB)Left Back Corner Post (1 pc)
Move out the Front Frame (A) by loosing Allen Bolts (a).
Install the Guard Rail and Bottom Rail to the Crib as figure.
55mm Allen Bolts (8 pcs)
)scp 01( slewoD dooW)d()scp 01( stloB nellA mm24)b(
(c)17mm Allen Bolts (4 pcs)

Page 8
SORELLE
(DRF)Right Front Corner Post (1 pc)
(DLF)Left Front Corner Post (1 pc)
(ERB)Right Back Corner Post (1 pc)
(ELB)Left Back Corner Post (1 pc)
Move out the Front Frame (A) from crib by loosing Allen Bolts (a).
Install the Guard Rail and Bottom Rail to the Crib as figure.
NOTE:DAYBED IS NOT FOR ADULTS.
55mm Allen Bolts (8 pcs)
)scp 01( slewoD dooW)d()scp 01( stloB nellA mm24)b(
(c)17mm Allen Bolts (4 pcs)

Page 9
SORELLE
(DRF)Right Front Corner Post (1 pc)
(DLF)Left Front Corner Post (1 pc)
(ERB)Right Back Corner Post (1 pc)
(ELB)Left Back Corner Post (1 pc)
(I)Top Cap (2 pcs)
ELB
ERB
DLF
DRF
55mm Allen Bolts (8 pcs)
Wood dowels(10 pcs)
)d(
Gap (8 pcs)
)g(
)scp 01( stloB nellA mm24)b(
(c)17mm Allen Bolts (4 pcs)
d
d
(f)20mm Allen Bolts (8 pcs)

Plug in the Allen Bolts( f ) and Cap (g) as figure shows.
NOTE:Your Fullsize Bedframe is sold separatly.Contact
with CNT International INC for specific assembly sheet
to assemble your Fullsize Bed.
Page 10
Install the Top Cap (I) on the Front Corner Post.
DLF
DRF
SORELLE
g x 8
f x 8

Page 11
(U)Short Dowels
( 2 pcs)
(V)Long Dowels
( 2 pcs)
(a) 42mm Allen Bolts (1 pc)
a
(c)20mm Allen Bolts (2 pcs)
(b) 32mm Allen Bolts (20 pcs)
(f)30mm screw (8 pcs)
SORELLE

Page 12
SORELLE

Page 13
SORELLE
V
V

Page 14
SORELLE

(d)42mm Allen Bolts(6 pcs)
(a) Hinges (2 pcs)
(b) Knop Screw (1 pc)
(c) Door Knop (1 pc)
(j) Hinges Screw (8 pcs) (k) Shelf Support (4 pcs)
(e)29 mm Allen Bolts(8 pcs)
(g)16 mm Screws (20 pcs)
(f)Allen Key (1 pc)
Page 15
(DC)Dresser Top Support Bar (1 pc)
(DK)Bottom Support Bar (2 pcs)
(DF)Bottom Panel (1 pc) (DG) Middle Panel(1 pc)
(DH)Door (1 pc)
(DI) Fixed Shelf (2 pcs)
(DA)Left End Frame (1 pc) (DB)Right End Frame (1 pc)
(DD)Top Panel (1 pc)
(DE)Back Panel (1 pc)
SORELLE
(DJ) Adjustable Shelf (1 pc)
(n) 35mm Screw (4 pcs)
(l)35 mm Allen Bolts(1 pc)
(m)Wood Dowels (4 pcs)

Page 16
SORELLE
1
Clothing Organizer assembly
2
3
DD
DD
DK
l
DG
DG
DG
DC
DI
DI
DI
DF DF
DF
DA
DD
DD
DA
d x 3
e x 2
d x 3
m x 2
DI
DF
DF
DF
e x 4
n x 4

Page 17
SORELLE
Wall Strap assembly instruction please check the Wall Strap Bag.
4
5
DB
DB
DF
DF
DG
DD
DD
m x 2
DF
DB
d x 3
d x 3
e x 2
g x 20

Page 18
SORELLE
6
7
DH DH
j x 4
j x 4
h
h
a x 2
a x 2
DH
HDHD
DH
k x 4
DG
DJ
DD
DD
DD
DA
DA
DB