Sorelle Lynn User manual

Lynn Dressing Table
Important Information:
Before assembly, read these instructions. Make sure
all preassembled parts are tight. Store this instruction
manual in envelope (attached to mattress support
tube) for future reference.

Page 2
WARNINGS
ST

Page 3
“
(E) - TOP MDF SHELF (6mm)
(1pc)
(2pcs)
(2pcs)
(B) - TOP FRONT RAIL
(F) - PAD (1pc)
(C) - CROSS BAR
(4pcs)
(4) - DOWEL (8pcs)
(3) - 1/2” SCREW
(10pcs)
(1) - 2 1/4” LONG-BOLT
(16pcs)
(2) - BARREL NUT
(16pcs)
(7) - Allen Key (1pcs)
(1pcs)
(6) - RESTRAINT
(A) - END FRAME
(D) - MDF SHELF(3mm)
（2pcs）

Page 4
Assembly Steps
Figure 1
Figure 2
Figure 3
(4)
(1)
(C)
(C)
(C)
(A)
(A)
(B)
(E)
(D)
(D)
(1)
(1)
(2)
(2)
STEP #1
INSERT THE DOWELS (4) INTO THE HOLES IN EACH END OF
THE CROSS BARS (C). ATTACH FOUR CROSS BARS TO ONE END
FRAME (A) USING ONE LONG-BOLT (1 ) AND ONE BARREL
NUT (3 ) EACH. ASSEMBLE TWO TOP FRONT RAILS (B) TO
THE SAME END USING TWO LONG BOLT (1) AND TWO BARREL
NUTS (2) EACH , BE SURE THE GROOVES FACE IN. SLIDE THE
MDF SHELVES ( E&D ) INTO THE
BE CAREFUL TO SUPPORT ALL BARS SO
THEY DO NOT BREAK.
STEP #2
ATTACH THE OTHER END FRAME ( A )TO THE ASSEMBLY
FROM STEP #1. BE SURE ALL GROOVES ARE FACING IN. USE ONE
LONG-BOLT (1 ) AND ONE BARREL NUT ( 3 ) FOR
EACH CROSS RAIL, USE TWO LONG BOLTS & TWO BARREL NUTS
FOR EACH FRONT RAIL. SEE FIG.2. TIGHTEN THE BOLTS - FINGER
TIGHT.
STEP #3
ATTACH THE FOUR METAL BARS (5 )
UNDERNEATH THE SHELVES (E&D ) USING
TWO SCREWS ( 3 ) PROVIDED. TIGHTEN ALL
NOTE:TWO METAL BARS ARE REQUIRED
FOR TOP SHELF(E)
STEP #4
ATTACH RESTRAINT ( 6 ), FIND PRE-DRILLED HOLES
UNDERNEATH THE TOP FRONT RAILS. USE ONE SCREW
( 3 ) TO ATTACH EACH END.
PLACE THE PAD( F ) PROVIDED ON THE TOP SURFACE.
WARNING: ALWAYS SECURE CHILD IN RESTRAINT.
TO FASTEN STRAP - PUSH BUCKLE SIDE
TOGETHER BE SURE BUCKLE IS FULLY
FASTENED TO SECURE CHILD SAFELY
TO RELEASE PRESS BOTH TABS AND PULL APART
Figure 4
GROOVE, SEE FIG.(1). TIGHTEN
BOLTS - FINGER TIGHT.
SCREWS. SEE FIG.3