Sorelle Portofino 4 in1 Crib User manual

Made in Vietnam
Important Information:
Read all instructions BEFORE assembling crib.
KEEP INSTRUCTIONS FOR FUTURE USE.
Portofino 4 in1 Crib
Assembly Instruction
IMPORTED BY C&T International, Inc. / IMPORTE` PAR de C&T International, Inc.
CANADA ADDRESS:
105 Stonehurst Ct Northvale, NJ 07647 U.S.A.
3453, DU PRESIDENT KENNEDY LAC MEGANTIC, QUEBEC, CANADA G6B 2Y4
Tel, 201- 531-1919 Fax, 201- 531-1920
Website: www.sorellefurniture.com / Site Internet : www.sorellefurniture.com

Page 2
WARNING
*Infants can suffocate on soft bedding. Never add a pillow or comforter. Never place additional padding
under an infant.
*Failure to follow these warnings and the assembly instructions could result in serious injury or death.
DO NOT use this crib if you cannot exactly follow the accompanying instructions.
*To reduce the risk of SIDS, pediatricians recommend healthy infants be placed on their backs to
sleep, unless otherwise advised by your physician.
*Strangulation Hazard: STRINGS CAN CAUSE STRANGULATION! Do not place items with a string
around a child's neck, such as hood strings or pacifier cords. Do not suspend strings over a crib or
attach strings to toys.
*Strangulation Hazard: To help prevent strangulation tighten all fasteners. A child can trap parts of
the body or clothing on loose fasteners.
*Strangulation Hazard: Do not place crib near window or patio door where cords from blinds or
drapes may strangle a child.
*Fall Hazard: When child is able to pull to a standing position, set mattress to lowest position and
remove bumper pads, large toys and other objects that could serve as steps for climbing out. This crib
has an adjustable mattress support. For the convenience of the parent when the baby is very small, the
mattress support may be used in the highest position.
*Fall Hazard: Stop using crib when child begins to climb out or reaches a height of 35in. (89cm),
whichever occurs first. The child should be placed in a youth or regular bed.
*Check this product for damaged hardware, loose joints, loose bolts or other fasteners, missing parts,
or sharp edges before and after assembly and frequently during use. Securely tighten loose bolts and
other fasteners. Do not use crib if any parts are missing, damaged or broken.Contact C&T
International Inc./Sorelle for replacement parts and instructional literature if needed. Do not substitute
parts.
*Follow warnings on all products in a crib.
*If refinishing, use a non-toxic finish specified for children's products.
*Never use plastic shipping bags or other plastic film as mattress covers because they can cause
suffocation.
*Infants can suffocate in gaps between crib sides and a mattress that is too small.
*Ensure a safe environment for the child by checking regularly, before placing the child in the crib, that
every component is properly and securely in place.
*To avoid head injury, do not allow any child to play underneath the crib.
*Never add an accessory such as a bassinet or changing table that extends over the sleeping area.
C
Crib Warnings
AUTION : ANYMATTRESSUSEDINTHISCRIBSHALL
BEATLEAST271/4”(69CM)x515/8”(131CM) WITH
ATHICKNESSNOTEXCEEDING6”(15CM).
SORELLE

Important: In order to properly assemble the crib, carry out the operations in order specified. Failure to assemble the crib in the manner recommended could
make the crib hazardous.
SORELLE
D
HB- Right Post
HB-Middle Panel
HB- Top Rail
HB- Left Post
REF.
A.
A1.
A2.
A3.
PART NAME QUANTITY
1
1
1
1
Right End
Foot Board
Left End
B.
C.
D.
1
1
1
Mattress Base
MS. 1
Assembly Parts List
Hardware List
C
A
A1
A2
A3
B
MS
1/4"*1 5 Bolt
H1 (X18)
1/4"*45 Bolt
H2 (X18)
Half Moon Washer
H3 (X6
)
Joint Connector Nut
H4 (X6 )
10*40 Wooden Dowel
H5 (X4)
Allen KeyH6 (X1)
Allen KeyH7 (X1)

Page 4
SORELLE
Preparation
Assembly Steps
Before beginning assembly of product, make sure all parts are present. Compare parts with parts list
and hardware list. If any part is missing or damaged, do not attempt to assemble the product.
1. Attachthe FB-Left Post(A-2) and FB-Right Post(A-3) to the FB-Middle Panel(A) as show on figure 1.
Important :
1. Please do not use power tool
Veuillez ne pas utiliser d'outil électrique
2.Please do not over tighten the bolt/ screw
Veuillez ne pas trop serrer les boulons et/ou les vis
3.Please clean the product use water, do not use liquid/ detergent.
Veuillez nettoyer le produit avec de l'eau, ne pas utiliser de détergent liquide.
4.Please set up the anti-tip kit
Veuillez configurer et installer la courroie anti-basculement.
H5
H3
H2
&
H6
X 4
A-2
A-3
A
A
A-3
A-2
Figure 1

Page 5
SORELLE
Assembly Steps (Continued)
A
A
H3
H5
H2
H6
X 2
A-1
A-2
A-2
A-3
A-1
Figure 2
Figure 3
H2
H1
H4
X 4
D
D
A
C
A-3
2. Attachthe FB-Top Rail (A-1) to FB as show on figure 2.
3. Attach the Left End (C) and Right End ( D) to FB as show on figure 3.
X 2

SORELLE
Assembly Steps (Continued)
H2
X 4
B
B
Figure 5
Page 6
Figure 4
H1
H1
Center Level
2
Lower Level
Higher Level
1
3
2
1
3X 4
MS
D
MS
4. Assembly Mattress Base (MS) as show on figure 4.
5. Attach Foot Board (B) to the Left End (C) and Right End ( D) as show on figure 5.

Page 7
SORELLE
FINALLY CHECK
• PRIOR TO USING THE CRIB, ENSURE ALL BOLTS ARE TIGHTENED. DO NOT OVER TIGHTEN.
• ENSURE THAT THE MATTRESS IS THE RECOMMENDED SIZE.
• ENSURE THE MATTRESS BASE IS LOCATED AT THE CORRECT LEVEL TO SUIT THE CHILD.
• CRIB IS NOW READY FOR USE.
NOTES
Assembly Steps ( Continued)
AU
BEA
ATHI

SORELLE
Page 8
TODDLER BED ASSEMBLY ( Option Purchase )
FULL SIZE BED ASSEMBLY ( Option Purchase )
#215 Adult Rail
#136 Toddler Rail
Note: The Toddler rail (#136) and Adult rail (#215) are sold separately to convert
the crib to a Toddler bed and a full size bed for your choose.
Contact the store where you purchased the crib or visit:
www.sorellefurniture.com to locate a dealer near you.

Page 9
Sorelle
C RIBMUST
BEA CM) WITH
ATHI
Disassembling Crib for Storage
To disassemble crib for storage, follow assembly steps in reverse.
Store all parts and hardware together in a safe place. Store the instruction manual in the supplied
envelope attached to mattress support base for future reference for reassembly.
To clean, use only mild household soap and warm water. DO NOT use bleach or detergent. DO
NOT use abrasive cleaners which can scratch the finish. Use clean soft cloths to wash, rinse and
dry. With proper care, the quality finish will last a long time. Wood surfaces may be treated with
a light application of a good grade of non-toxic furniture polish. Read contents on back of polish
to make sure polish will not harm unit.
Store all parts from Crib, which are not used for Full Size Headboard, in original carton(s) (if
available) to prevent damage and allow reuse.
Cleaning and Storage