
Important
Safety Instructions
!CiUTIONI
PLEASE READ AND OBSERVE ALL WARNINGS AND INSTRUCTIONS
IN
THIS OWNER'S MANUALAND THOSE MARKED ON THE UNIT. RETAIN THIS
BOOKLET FOR FUTURE REFERENCE.
This set has been designed and manufactured to assure personal safety.
Improper use can result
in
electric shock or fire hazard. The safeguards
incorporated
in
this unit will protect you
if
you observe the following procedures for
installation, use and servicing. This unit is fully transistorized and does not contain
any parts that can be repaired by the user.
I
I \
""er~l.~~\f>
'£
••
+
) - 0
0_-:.
DO
NOT
attempt to operate
if
picture fails
or
no sound
is
heard. Stop using the unit and turn it off immediately
if
there
is
any smoke
or
burning smell.
If
unit is damaged,
it
could cause fire or electrical shock.
This product
is
designed for DC 12V. It is recommended
to check with a tra
in
ed "Authorized Dealer" for using this
unit in a
RV
,
truck
or
bus application.
DO
NOT
install unit where it may obstruct driver's sight
or
cause possible injury to passengers.
DO
NOT
allow installation to interfere with normal vehicle
operations. Wiring and installation should not interfere with
the brake pedal, steering wheel
or
transmission shift lever.
DO
NOT
remove any screws
or
hardware from vehicle to
install products.
For the best results, follow wiring diagram for products a
shown
in
the manual.
Do
not place unit on uneven
or
unstable surfaces, avoid
dusty areas and unsealed doors,
or
openings where water
may be splashed.
DO
NOT
watch the unit wihile driving. Distracting the
driver from proper operation
of
the vehicle can result in
possible accident or injury.
Proper installation allow the driver to only watch TV when
the vehicle is stopped and the parking brake is applied.
DO NOT disassemble
or
modify the product as it may
cause accident, fire
or
electrical shock.
Set the volume to a moderate level, which will not prevent
your hearing outside noises such as emergency vehicles.
I
II
..
II
~
~
~
~
s::s
G3
0
0
~~[2
~~
of<t:JoV
Inspect any vehicle areas before drilling any holes for
mounting
or
wiring
of
unit. Make sure
to
check behind
installation area
to
prevent damaging any existing vehicle
wiring
or
other connections. Failure
to
do
so could result
in vehicle malfunction
or
impaired vehicle operation.
All wiring must be routed safely and should not distract
the driver's attention during normal operating conditions.
DO
NOT
allow wiring to interfere with operation of the
vehicle's brake pedal, shift lever
or
steering wheel.
DO
NOT
cut
or
modify
any
DIN cables with fuse built-in.
This could render such protective circuit inactive and
potentially
re
sult in permanent damage to the unit or
vehicle.
Make sure both DIN cable and other wiring is not run
where
it
may be cut
or
damaged.
The slots and openings
in
the unit is provided for nece-
ssary ventilation. These must not be blocked to ensure
reliable operation.
Use
provided parts. Over-sized hardware may cause an
electrical short
or
result in product not being mounted
securely.
Use correct voltage batteries only. Make su;e to insert
batteries observing correct polarity. Using old and new
·ba
tteries is not recommended. Keep small objects such
as batteries out
of
the reach
of
children.
Swallowing them may result
in
serious injury.
Keep the remote control
in
safe place when not in use to
insure that the remote control dose not interfere with the
vehicle operation if it is dropped
or
shifts while driving.
DO NOT Install antennas where they could cause unex-
pected accident
or
injury to pedestrians.