Spacetronik SPR-211M Series User manual

Item No.：SPR-211Mx
Installation guide
WARNING
x1
NO.
A
>600mm
0~8kg
40-400mm
Table size:
Accessory
Spare part
TOOLS
>450mm
40~400mm
410mm
544mm
660mm
470mm
0-8KG
MAX
Specification
Please do not exceed the maximum
WARNING bearing weight.
Loading range
Height adjustment range
STEP 2
Please press the switch to adjust it to a
desired height according to your situation.
WARNING
Please do not put hands near the supporting
bars, to avoid any hurt while the desk is lifting up
and down.
When lifting the workstation, press the switch by your thumb and up the table with holding both
sides of table edges, then it will get next height ,locked asthmatically when you hearing the voice.
When lowering the workstation, press the switch by your thumb and the loading will let it lower
from current height, locked it automatically when hearing the voice.
when the

STEP 3
Please put the devices onto the top of the
workstation. CAUTION
Please make sure all installed
equipments are on the table, and
not exceed the edge, or it may
hurt you or cause damage.
Please make sure all installed equipments
are on the table, and not sticking out of
the edge, or it may harm or cause damage.
Please leave enough length of cable for
height adjustment function, or it may
hurt you or cause damage.
Attention
A t t e n t i o n
Produced in ChRL for:
DMTrade Mikołaj Tomaszewski Wiśniowa 36; 64-000 Kościan, Poland
NIP: PL 6981681757
[e-mail]
Tel.: [phone]