Spear & Jackson BoilerMag XC BMXC22 Maintenance and service guide

Installation & Maintenance
PPE
Pack Contents
2
Register Your Warranty at
boilermag.com/register-warranty
Tel: [phone]
x1 x1
x2
x2
x1
XC
TM

www.boilermag.com
Where To Install BoilerMag XC
Installation - Always ensure the air vent points upwards


 
BMXC BMXC

BM22 is suitable for
this configuration.

Cut designated pipe section (see table below)
www.boilermag.com
Model/Valve Type (a)
BMXC22 203mm
BMXC 3/4”BSP 225mm
BMXC ¾” 200mm
BMXC 1” 225mm
Attach isolation valves to pipework.
(a)
12
Insert the valve seals and fit the filter
unit into place, tighten the nuts on the
isolation valves. Ensure that the filter collar
is tightened. Ensure the air vent and drain
valve are closed.
13
11
Open isolation valves. Vent out any
air through the air vent then re-close
using the multi tool provided.
14
www.boilermag.com
Installing BoilerMag XC
BM22 is suitable for
this configuration.

Cleaning & Servicing
Close both isolation valves, open the
air vent, then open the drain valve and
drain the unit.
Re-insert drain valve, unscrew
locking collar and remove the filter
bowl and core.
Remove any sludge or magnetite.
1112
1314
15Insert core cover into
port block, ensure fins
are horizontal when
pipe vertical and vertical
when pipe is horizontal.
(Continued Overleaf)
www.boilermag.com
Remove the core cover with tool
provided.

Locate the filter bowl and core into place by tightening the locking collar, making
sure the air vent is positioned at the top.
Turn valves to the on position. Vent to release air then re-close.
16
1718
www.boilermag.com www.boilermag.com

2
Register Your Warranty at
boilermag.com/register-warranty
Visit boilermag.com or Phone: [phone]
Also Available
BM1 BM3
Electrolytic Scale
Reducer
www.boilermag.com
XC TM