Special Tomato MAT Table User manual

MAT Table
User’s manual

2
WARNING: AVOID SERIOUS INJURY FROM FALLING OR SLIDING OUT.
NEVER LEAVE CHILD UNATTENDED.
ALWAYS KEEP CHILD IN VIEW.
IMPORTANT: KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
A CHILD’S SAFETY IS YOUR RESPONSIBILITY.
DO NOT USE THE TABLE AS AN CHAIR
PARTS
Tray Top Adjustment Stem
Stem Bolts &
Stem Washers
Safety Mark
Tray Angle Lock
Knob & Washer
Main Stem Knob
Side Stem Knob
Base Tube (with casters)
1. USER ASSEMBLY
To install Tray Top, pull and hold Main Stem Knob
outward while inserting Tray Top into Adjustment
Stem (insert past Safety Mark). Release Main Stem
Knob to lock Tray Top in place at desired height.
Finally, tighten Main Stem Knob & Side Stem Knob to
secure Tray Top.
Attach the Adjustment Stem to the Base Tube. Using the
8mm Allen Wrench provided, install the Stem Bolts &
Stem Washers as shown below. Ensure curved face of
each Stem Washer is installed against curved surface
of adjustment stem.
Install Tray Angle Lock Knob & Washer.

3
2. ADJUSTING TRAY HEIGHT
When adjusting Tray Top, never exceed Safety Mark.
Loosen Main Stem Knob & Side Stem Knob. Pull and
hold Main Stem Knob outward to adjust tray height.
Release Main Stem Knob to lock Tray Top in place at
desired height. Finally, tighten Main Stem Knob &
Side Stem Knob to secure Tray Top
Loosen the Tray Angle Lock Knob, but do not remove.
Tilt Tray Top to desired angle and re-tighten the Tray
Angle Lock Knob.
Safety Mark
3. ADJUSTING TRAY ANGLE
4. USING CASTER LOCKS
Level position is unlocked.
Tilted position is locked.

LIMITED WARRANTY
Bergeron by Design warrants to the original retail purchaser of the Special Tomato® product, that if any part or component
proves defective in material or workmanship within two years of the purchase date, the defective part will be repaired or
replaced (at Bergeron by Design’s discretion) free of charge. Warranty service may be performed by an authorized service
center or (at Bergeron by Design’s discretion) the factory.
This warranty does not cover normal wear and tear, or damage caused by accident or misuse.
To exercise this limited warranty, the user should first obtain a Return Authorization Number from the dealer the Special
Tomato® product was purchased from. The product must be delivered charges pre-paid (UPS recommended) to the factory or
to an authorized service center, together with a copy of the original invoice, the Return Authorization Number and a written
description of the problem
MAINTENANCE & PRODUCT CARE
Use a mild detergent/cleaner to wipe the tray surface periodically.
CUSTOMER SERVICE
Contact your dealer directly. Or contact the European Authorized Representative.
NOTICE
No part of this document may be photocopied, reproduced, transmitted, transcribed, stored in a retrieval system or translated
to another language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical,
manual, or otherwise without the prior written consent of Bergeron by Design.
Use only Special Tomato® accessories and parts on Special Tomato® products. Special Tomato® parts are not interchangeable
with other manufactures’ products. Replace any worn parts immediately for safety. © Bergeron By Design

5
Bergeron By Design
15 South Second Street
Dolgeville, New York 13329
T 1 315 429 8407
F 1 315 429 8862
Your Soft Touch Liner is guaranteed to be free from any manufacturing defects for a period of 2 years from the
date of purchase under normal use and provided it is used in compliance with the operating instructions. This
warranty extends only to the original retail purchaser and is only valid when supplied with proof of purchase.
Please retain proof of purchase with this Limited Warranty.
Should a repair be needed please contact the retailer from whom the product was purchased.
PLEASE NOTE THAT THE WARRANTY
WILL NOT BE APPLICABLE IF:
• A fault is the cause of misuse or poor maintenance.
• Repairs are carried out by a third party.
• The stroller is faulty due to general wear and tear which is the result of everyday use.
• A stroller is damaged as a result of an accident.
• The manufacturer is not satisfied that the stated warranty terms and conditions have been met.
© 2009 Bergeron By Design
The information contained herein is subject to change without notice.
Bergeron By Design shall not be liable for technical errors or omissions herein.
IMPORTANT- WARRANTY WILL BE VOID IF DEFACED OR REMOVED