Special Tomato MPS Seat User manual

MPS Seat (seat only)
MPS Classic (seat & mobile)
User’s manual
Small & large

2
SETTING UP YOUR MPSSETTING UP YOUR MPS
UNPACKUNPACK
Check to see that the following items are included
with your Multi-Positioning Seat (MPS):
• Seat Shell
• Head Cushion installed
• Headrest Tether Strap
• Back Cushion installed
• Seat Cushion (Regular or Extended size) installed
• Two Safety Attachment Straps installed
• Five Point Harness System installed
• Top Tether Strap
• Left and Right Leg Rest Extensions
• 2 Leg Rest GROOVED Knobs (1 3/16”)
• 2 Footrest BALL Knobs (1 1/2”)
WARNING:WARNING: AVOID SERIOUS INJURY FROM FALLING OR SLIDING OUT.
NEVER LEAVE CHILD UNATTENDED.
ALWAYS KEEP CHILD IN VIEW.
IMPORTANT: KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
A CHILD’S SAFETY IS YOUR RESPONSIBILITY.
ALWAYS USE THE SEAT HARNESS.
SECURE STRAPS TIGHTLY
ALWAYS BE SURE TO LOCK LOCKING CASTERS WHEN NOT MOVING
THE SITTER MOBLIE BASE
THIS VEHICLE IS SUITABLE FOR ONE CHILD.
- Note: Make sure the
chair is stable!

3
B
A
C
D
B
A
B
A
C
D
FOOTREST ASSEMBLYFOOTREST ASSEMBLY
Your Special Tomato® Multi-Positioning Seat (MPS) comes partially assembled for your convenience.
• Insert both ends of the Leg Rest Extensions into the corresponding holes in the front of the seat shell.
• Make sure to insert the leg rests far enough so that the Leg Rest GROOVED Knobs (1 3/16”) go through one of the
three corresponding holes in the leg rests, giving the appropriate depth for your child.
• Tighten the 2 Leg Rest GROOVED Knobs (1 3/16”). Overtightening is not necessary! Turn it until you feel resistance.
There is a block to prevent tightening it too much.
• Place the footrest at the appropriate height, depth, and angle for your child.
• Insert the 2 Footrest BALL Knobs (1 1/2”) into one of the three appropriate holes on the side of the footrest. These
Footrest BALL Knobs (1 1/2”) should be tight!
Please Note: It is NOT necessary to overtighten any of the knobs. They are designed to hold with a SNUG t!
ADJUSTMENTSADJUSTMENTS
The Special Tomato® Multi-Positioning Seat provides a comfortable and adjustable seating surface for your child.
The durability of this unique product along with built-in adjustability allow for years of use as it grows with your child.
Adjustability is accomplished as follows:
B
A
HEAD CUSHION & BACK CUSHIONHEAD CUSHION & BACK CUSHION
Adjust up and down easily. Hook and loop strips and our track reference mark system
allow you to quickly reposition the modular cushions to t your child.
ASSEMBLYASSEMBLY
First attach the MPS to the appropriate base of choice with the Attachment Straps:
MOBILE FLOOR BASEMOBILE FLOOR BASE
Secure tightly the Rear Strap
under lip of Mobile Floor Base.
Secure tightly the Bottom Strap
underMobileFloorBasebetween
both sets of wheels
PUSH CHAIR SEATPUSH CHAIR SEAT
Secure tightly the Rear Strap around
back of Push Chair Base, between the
fabric and the cross bars.
Secure tightly the Strap under Push
Chair Base under the seat making sure
to thread between the seat back frame
and the front leg frame.
STANDARD CHAIRSTANDARD CHAIR
Secure tightly the Rear Strap
around back of chair (spiral
method below or straight
method in Figure 1.)
Secure tightly the Bottom
Strap under seat of chair
Figure 3.

4
90°
105°
75°
Lille
SEAT CUSHIONSEAT CUSHION
Uses hook and loop strips plus our track system for easy adjustment.
Under the Seat Cushion are three guide lines.
The middle line positions the hips at 90°. The top line provides 15° of Hip Exten-
sion. The bottom line provides 15° of Hip Flexion.
Our Hip Flex® Adjustment provides 15° of Hip Flexion or 15° of Hip Extension
without recline.
FOOT RESTFOOT REST
Provides maximum adjustment allowing for height, depth, and
angle adjustability. Hook and loop straps.
Secure your child’s feet to the footrest for proper positioning.
Adjust the depth of the footstraps as needed.
15° of Hip Extension
Neutral Hip position
15° of Hip Flexion

5
FIVEPOINT HARNESSFIVEPOINT HARNESS
LAP STRAPLAP STRAP
Press the center red button to release both sides of the lap strap.
Re-insert each metal buckle into the corresponding socket to secure the lap strap
portion of the 5-point harness.
To adjust the Five-Point Harness, remove
the black covers from the shoulder straps.
Press in the gray button.
Pull the bottom strap to loosen.Pull the top strap to tighten.
Provides comfort and adjustment needed to
properly support and position your child. A
soft built in chest pad promotes comfort and
provides support by simply tightening the over
the shoulder straps as needed.

6
B
AC
Complete with four swivel casters.
Rear casters have foot-operated locks.
Tray Storage in rear of Mobile Floor Base. Stay secure with hook placements.
OPTIONAL SEAT CUSHIONSOPTIONAL SEAT CUSHIONS
Extended Seat Cushion can be purchased as the standard seat cushion with your MPS
depending on your child’s dimensions.
Extended Seat Cushion can be purchased at a later date as an optional accessory if
your child needed the Regular Seat Cushion at the time of your original purchase. This
way you can extend the“life”of the MPS without having to buy a completely new
seating system.
B
A
C
MOBILE FLOOR BASEMOBILE FLOOR BASE
SWITCHING SEAT CUSHIONSSWITCHING SEAT CUSHIONS
Unclip crotch strap and pull down through hole in seat
cushion.
Remove seat cushion.
Test it by pulling on both straps to make sure that they
stay connected
Place new cushion in seat shell.
Pull crotch strap back up through seat cushion.
Verify that the 5-Point Harness Clip is securely fastened.
Push small metal clip through slot of large metal clip to
secure the 5-Point Harness.

7
B
AC D
E F
TRAYTRAY
Tray items include:
Tray
2 Tray Risers
2 Tray Riser BALL Knobs (1 1/2”)
2 Washers
Secure both Tray Risers to the Seat Shell at desired angle (0º - 30º) with the attached hook and
loop strips.
Place Washers on BALL Knobs (1 1/2”) and insert them into the corresponding slot and hole.
Tighten both BALL Knobs (1 1/2”).(Not necessary to over tighten.)
Place the Tray on the Tray Risers with the attached hook and loop strips on the bottom of the Tray
surface considering the appropriate amount of depth for your child. Use the hook and loop ap to
secure the Tray to the Tray Risers.
To remove the tray, rst pull up on the hook and loop ap.
Second, pull the tray o by holding onto the curved sides and rotating one side towards you.
The Tray Risers can remain on the Seat Shell.
B
A
C
D
E
F
PUSH CHAIR BASEPUSH CHAIR BASE
If you have purchased the MPS Push Chair Base, you will receive a separate manual with your MPS Push Chair
Base.

LIMITED WARRANTYLIMITED WARRANTY
Bergeron by Design warrants to the original retail purchaser of the Special Tomato® product, that if any part or component
proves defective in material or workmanship within two/ve years of the purchase date, the defective part will be repaired
or replaced (at Bergeron by Design’s discretion) free of charge. Warranty service may be performed by an authorized
service center or (at Bergeron by Design’s discretion) the factory.
This warranty does not cover normal wear and tear, or damage caused by accident or misuse.
To exercise this limited warranty, the user should rst obtain a Return Authorization Number from the dealer the Special
Tomato® product was purchased from.The product must be delivered charges pre-paid (UPS recommended) to the factory
or to an authorized service center, together with a copy of the original invoice, the Return Authorization Number and a
written description of the problem
MAINTENANCE & PRODUCT CAREMAINTENANCE & PRODUCT CARE
Clean chair with damp cloth; then wipe dry. With normal use, over time screws may loosen. Please maintain tight screws.
Use chair on smooth level surface.
HARNESS CAREHARNESS CARE
Place harness in a mesh bag and machine wash with cold water, then air dry.
CUSTOMER SERVICECUSTOMER SERVICE
Contact your dealer directly. Or contact the European Authorized Representative.
NOTICENOTICE
No part of this document may be photocopied, reproduced, transmitted, transcribed, stored in a retrieval system or trans-
lated to another language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical,
chemical, manual, or otherwise without the prior written consent of Bergeron by Design.
Use only Special Tomato® accessories and parts on Special Tomato® products. Special Tomato® parts are not interchange-
able with other manufactures’products. Replace any worn parts immediately for safety. © Bergeron By Design

9
Bergeron By Design
15 South Second Street
Dolgeville, New York 13329
T 1 315 429 8407
F 1 315 429 8862
Your MPS is guaranteed to be free from any manufacturing defects for a period of 2/5 years from the date of
purchase under normal use and provided it is used in compliance with the operating instructions. This warranty
extends only to the original retail purchaser and is only valid when supplied with proof of purchase. Please retain
proof of purchase with this Limited Warranty.
Should a repair be needed please contact the retailer from whom the product was purchased.
PLEASE NOTE THAT THE WARRANTYPLEASE NOTE THAT THE WARRANTY
WILL NOT BE APPLICABLE IF:WILL NOT BE APPLICABLE IF:
• A fault is the cause of misuse or poor maintenance.
• Repairs are carried out by a third party.
• The stroller is faulty due to general wear and tear which is the result of everyday use.
• A stroller is damaged as a result of an accident.
• The manufacturer is not satised that the stated warranty terms and conditions have been met.
© 2009 Bergeron By Design
The information contained herein is subject to change without notice.
Bergeron By Design shall not be liable for technical errors or omissions herein.
IMPORTANT- WARRANTY WILL BE VOID IF DEFACED OR REMOVED