Specialised Orthotic Services MoJo & Stroller 2 User manual

USER’S MANUAL
ALL USER’S OF THE EQUIPMENT SHOULD BE AWARE
OF THIS DOCUMENT AND ITS CONTENT
ISSUE 3
MoJo & Stroller 2
Net Carrier
|CLASS 1 DEVICE

CONTENTS
1. MOJO NET CARRIER FITTING INSTRUCTIONS
1 x Net Carrier
1 x Base Board (pre-installed)
Place•the bag insde of the chassis with the manufacturers label at the rear by the tilt
pedal.
Hook
•the rear straps over the rear cross beam as shown (Fig.1a) and secure the two
halves of the Velcro together.
Hook
•the front straps over the front cross beam as shown (Fig.1b) and secure the two
halves of the Velcro together.
Hook
•the middle straps over the lower frame, around the back of the tilt mechanism as
shown (Fig.1c) and secure the two halves of the Velcro together.
Correctly
• tted net carrier shown (Fig.1d).
Removal
•is a reversal of the above.
Be
• careful not to overload the carrier especially with loose items as these may
lodge in the wheels causing instability.
Fig.1a Fig.1b
Note:
If you remove the base board for
cleaning, etc make sure that the
narrow end is tted to the rear of the
net carrier (label end) when retting.

2. STROLLER 2 NET CARRIER FITTING INSTRUCTIONS
Fig.1c Fig.1d
Place the carrier inside the chassis with the manufacturers label at the rear by the tilt•
pedal.
Hook
• the rear straps over the rear cross beam
as shown (Fig.2a) and secure the press studs
together.
Hook
• the side straps over the frame as shown
(Fig.2b & 2c) and secure the two halves of the
Velcro together.
Correctly
• tted net carrier shown (Fig.2.1c).
The rear section of the net carrier can be
•
expanded via the two zips.
Removal
• is a reversal of the tting procedure.
Be
• careful not to overload the carrier
especially with loose items as these may
lodge in the wheels causing instability.
Fig.2b Fig.2c
Fig.2a

Should any problems arise due to faulty manufacturing & materials under normal everyday
use then it is covered by our comprehensive 12 months warrantee from the date of purchase
(For terms and conditions please consult our Customer Services Department).
Specialised Orthotic Services Ltd cannot be held responsible for any unauthorised use
or incorrect tting whether resulting in personal injury or not and any damage caused to
equipment not supplied with the tray.
The company has a policy of continual development and we reserve the right to alter
specication and design without prior notication. All products manufactured are covered by
design rights or patents. This document is the copyright of the company and the contents are
its intellectual property.
Unit 127/128, Fauld Industrial Park, Tutbury, Staffordshire. DE13 9HS.
Tel: [phone] Fax: [phone]
E-mail: [email protected]
If you require further copies of this handout or require further details relating to any of its
content, then please contact us (Copyright applies):