SpectraLink NetLink e340 Service manual

Technical Bulletin CS-04-04
THE INFORMATION PROVIDED IN THE SPECTRALINK TECHNICAL BULLETIN IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. NO
OBLIGATION OR LIABILITY WILL ARISE OUT OF, SPECTRALINK RENDERING TECHNICAL OR OTHER ADVICE OR SERVICE IN CONNECTION
HEREWITH.
SpectraLink Corporation • 5755 Central Avenue • Boulder, Colorado 80301 • 303.440.5330
High Noise Mode functionality on e340 or i640 Wireless Telephones
Date: June 03, 2004
Software Versions: See Below
Hardware Revisions: PTE1xx, PTX1xx
Product Type: NetLink Wireless Telephones
Access Level: General
Originator: Matt Jerger
Approvers: Wayne McAllister
Gary Bliss
Status: Approved
Revision: A
Problem
When changing the High Noise Mode setting in the Wireless Telephone, the change
does not take place until the phone is turned off and back on again. On some protocols,
changing the High Noise Mode has no effect on that setting.
Description
The following list of software versions (based on protocol) is where the problem will
occur. If you have this version, or an earlier one, then you will have to re-boot the
Wireless Telephone after you have changed the High Noise Mode setting.
SRP – 89.104
Cisco SCCP - 91.035
Avaya CCMS - 96.024
Nortel UNIStim - 97.030 (No change occurs)
H.323 - 99.012
Inter-Tel Axxess - 100.011 (No change occurs)
Mitel ICP - 101.004 (No change occurs)
Resolution
The following list of future releases will correctly fix the problem. The user will no longer
have to re-boot the Wireless Telephone to get the change to take effect. Release dates
are unknown at this time. Please check www.spectralink.com for software updates.
SRP – 89.110
Cisco SCCP - 91.039
Avaya CCMS - 96.025
Nortel UNIStim - 97.039
H.323 - 99.013
Inter-Tel Axxess - 100.012
Mitel ICP - 101.007