Spektrum DX2S User manual

®
DSM Sport System with Integrated Telemetry

2SPEKTRUM DX2S USER GUIDE
TABLE OF CONTENTS
Introduction.............................................................................................................................................3
Contents..................................................................................................................................................3
ModelMatch/Binding ..............................................................................................................................3
System Features......................................................................................................................................3
Identifying Buttons, Switches and Controls ............................................................................................4
Switching Rubber Grips..........................................................................................................................5
Installing the Batteries.............................................................................................................................5
Charging.................................................................................................................................................5
Steering Rate...........................................................................................................................................6
Receiver Compatibility............................................................................................................................6
Receiver Connection and Installation......................................................................................................7
Using the Rolling Selector ......................................................................................................................7
Main Screen............................................................................................................................................8
Telemetry Screen.....................................................................................................................................9
List........................................................................................................................................................10
Model Select.........................................................................................................................................10
Model Name .........................................................................................................................................11
Model Reset..........................................................................................................................................11
Travel ....................................................................................................................................................12
Exponential ...........................................................................................................................................13
Reverse .................................................................................................................................................14
Sub Trim ...............................................................................................................................................14
Timer.....................................................................................................................................................15
Bind ......................................................................................................................................................16
ModelMatch..........................................................................................................................................16
Binding a Receiver................................................................................................................................16
Failsafe..................................................................................................................................................17
Telemetry Settings.................................................................................................................................17
System..................................................................................................................................................20
Installing the Telemetry Sensors in Your Vehicle..................................................................................21
General Notes .......................................................................................................................................23
Tips on Using 2.4GHz Systems ............................................................................................................24
General Information ..............................................................................................................................25
Warranty Information.............................................................................................................................25
Instructions for Disposal of WEEE by Users in the European Union.....................................................27

3SPEKTRUM DX2S USER GUIDE
INTRODUCTION
Spektrum’s DX2S features an integrated telemetry system
providing accurate speed/rpm, temperature and voltage
readings. Featuring DSM 2.4GHz technology, the DX2S
offers sophisticated software combined with an easy-to-
use one-touch Rolling Selector making programming
quick and easy. Spektrum technology offers a bulletproof
radio link that’s immune to internal (noisy motors/ ESCs,
etc.) and external interfering sources. No longer will you
have to wait for a frequency or worry about someone else
being on the same channel. With Spektrum when you’re
ready to race there’s nothing stopping you!
CONTENTS
The DX2S radio system is supplied with the following:
• DX2Stransmitter
• SR3300TReceiver(SPMSR3300T)
• BindPlug(SPM6802)
• 4AAalkalinebatteries
• ReceiverAAbatteryholder
• Switchharness
• GripSet(SPM9006)
• HeadTemperatureSensor(SPM1450)
• Battery/MotorTemperatureSensor(SPM1451)
• RPMSensor(SPM1452)
• SensorMountHardware.21-.26(SPM1501)
• SensorMountHardware.12-.15(SPM1502)
• SensorMountHardwareElectrics(SPM1503)
• TelemetryRPMSticker(SPM1512)
MODELMATCH/BINDING
The DX2S features patent pending ModelMatch.
ModelMatch prevents a model from being operated when
the wrong model memory is selected. If the wrong model
memory is selected, the receiver simply won’t respond to
the transmitter.
It’s necessary to program the receiver to a specific
model memory (called binding) so that the receiver
will only recognize and respond to that specific model
memory. See page 16 for specific details on Binding and
ModelMatch.
SYSTEM FEATURES
• IntegratedTelemetry
• One-toucheasy-to-useprogramming
• InternalandprogrammableUporDowntimers
• 128x64highresolutiondot-matrixscreen
• 5-modelmemory
• Traveladjust
• Exponential
• Steeringmix
• Expertandstandardmodes

4SPEKTRUM DX2S USER GUIDE
IDENTIFYING BUTTONS, SWITCHES AND CONTROLS
Antenna
LCD Screen
Steering Rate Knob
On/Off Switch
Steering Trim
Remote Start Button
Battery Door
(on bottom)
Timer Button
Charge Jack
(on back)
Throttle Trim
Rolling Selector
Steering Wheel
Throttle Trigger

5SPEKTRUM DX2S USER GUIDE
SWITCHING RUBBER GRIPS
The DX2S is supplied with three different sized rubber
grips with the medium size installed on the transmitter.
Each grip’s size is identified with an “S” (small), “M”
(medium), or “L” (large) on the inside of the grip for
easy identification. To remove, simply lift the edge of the
grip and continue around the grip until it is completely
removed. To replace, align the tabs of the grip to the slots
in the handle and press the grip in place.
INSTALLING THE BATTERIES
TheDX2Sradiosystemissuppliedwith4AAalkaline
batteries required for operation that provide over 16
hours of run time. Many drivers prefer alkaline batteries
over rechargeable batteries finding it more convenient to
simply replace the batteries when depleted rather than
taking the time to recharge them.
OptionalNiMH1.2-voltAArechargeablebatteries
(SPM9525)canalsobeused.Achargejacklocated
opposite of the on/off switch is provided for convenient
rechargingwithSpektrumchargerSPM9526.
Removethebatterydoorandinstall4AAbatteries
observing the polarity marked on the battery holder.
Replace the battery door.
CHARGING
Charger Pigtail for Transmitter
Spektrum Transmitter Charge Jack Polarity
BLACK TO POSITIVE
BLACK W/WHITE STRIPE TO NEGATIVE
-+
Achargingjackislocatedontheoppositesideoftheon/
off switch. If rechargeable batteries are used they can be
conveniently charged without removing them from the
transmitterusingthechargejack.
IMPORTANT:AllSpektrumchargejacksare
center-pin negative. This is opposite of many
chargers. Before using a charger, make sure
the connector is center-pin negative. This
canbedoneusingavoltmeter.Also,unlike
conventional radio systems that use 8 cells to
power the transmitter, the DX2S uses 4 cells.
This is due to the electronics being more
efficient. When charging, be sure to use a
charger designed for 4 cells (a 4.8-volt battery
pack) when charging the transmitter. Many
drivers simply make a harness and use the
same charger used to charge their car packs
but turn the current rate down to 1 to 2 amps.
Warning:Chargeonlyrechargeablebatteries.Other
typesofbatteriesmayburstcausinginjuryto
persons and/or damage to property. Risk of
fire and electric shock. Dry location use only.

6SPEKTRUM DX2S USER GUIDE
STEERING RATE
Steering rate, (also known as dual rate) allows on-the-fly
steeringtraveladjustmentstobemadeusingthesteering
rate knob. Steering rate limits the amount of travel of the
steering servo. The steering rate cannot be greater than
100% and will never exceed the amount of steering travel
set in the travel screen.
RECEIVER COMPATIBILITY
The DX2S features DSM technology and is also
compatible with Spektrum DSM and DSM2 surface
receivers and the marine receiver.
COMPATIBLE SPEKTRUM RECEIVERS
The DX2S is compatible with the following receivers.
Note: The DX2S operates in either 11ms
(default) or 16.5ms frame rates. 5.5ms frame
rate is not available on the DX2S. See page 22
for more information on frame rates.
DSM
SR300-3-channelSport-SPMSR300
SR3000-3-channelStandard-SPM1200
SR3001-3-channelPro-SPM1205
SR3300T-3-channelwithbuilt-intelemetry- SPMSR3300T
SR3500-3-channelMicroRace-SPM1210
Note:TheSR3000HRS(SPM1202)receiver
is designed to be used with Spektrum’s Futaba
HRS compatible module system only and is
not compatible with the DX2S.
DSM2
SR3100-3-channelPro-SPMSR3100
SR3520-3-channelMicroPro-SPMSR3520
Marine
MR3000-3-channelMarine-SPMMR3000
PleasenotethatDSM2andmarinecompatibleDX2S
transmitters can be identified by the following logo
located on the back of the transmitter:
Steering
Rate

7SPEKTRUM DX2S USER GUIDE
RECEIVER CONNECTION AND
INSTALLATION
Typical Electric Installation
Typical Gas Installation
USING THE ROLLING SELECTOR
The Rolling Selector is pressed to access functions and
rolled to select specific features or to change settings
orvalues.PressingandholdingtheRollingSelector
for more than 3 seconds returns the display to the main
screen.
The DX2S features one-touch programming utilizing a
Rolling Selector. The Rolling Selector has three functions.
1. PressingtheRollingSelector-enterstheselected
function.
2. Rolling the Rolling Selector - highlights function or
changes settings and values when selected.
3. PressingandholdingtheRollingSelectorformore
than 3 seconds from any screen - returns the display
to the Main Screen.
Programmingisveryintuitiveandalwaysstartswitha
press on the selector, then a roll, then a press, then a
roll and so on. Most find that within a few minutes they
are able to easily program their car without reading the
instructions; however, to realize the full benefit of the
programming it is recommended that the manual be read.
Most racers find it is most convenient to use their thumb
when making programming changes as this allows for
one-handed programming, even allowing the car to be
runinonehandwhilemakingprogrammingadjustments
with the other.
Rolling Selector
Futaba is a registered trademark of Futaba Denshi
Kogyo Kabushiki Kaisha Corporation of Japan

8SPEKTRUM DX2S USER GUIDE
MAIN SCREEN
The main screen displays pertinent information about
the selected model like trim and steering rate positions,
timers, the model selected, battery voltage, etc.
TO ACCESS THE MAIN SCREEN
From the List screen, the first function at the top of the
ListscreenisMAIN.UsingtheRollingSelectorhighlight
the Main function and press the Rolling Selector to
access the Main screen.
From any screen, pressing and holding the Rolling
Selector for more than three seconds will return the
display to the main screen.
Note: When the battery voltage drops below
the preset value in the System function, an
alarm will sound.
Model Number and Name
Transmitter Voltage
Steering Trim
Down Timer
Steering Rate
Throttle Trim
Internal Timer
Brake Trim

9SPEKTRUM DX2S USER GUIDE
TELEMETRY SCREEN
The Telemetry screen displays information received from
the on-board telemetry built into the SR3300T receiver.
Note: The signal strength display is for the
Telemetry link only. Typical telemetry range is
100–200 feet and will vary depending on the
operating environment.
TO ACCESS THE TELEMETRY SCREEN
From any screen, pressing and holding the Rolling
Selector for more than three seconds will first return
the display to the Main screen. Three seconds later the
Telemetry screen will be displayed.
Model Number
Maximum Recorded rpm/Speed
Transmitter Voltage
Real-Time rpm/Speed
Down/Up Timer
Receiver Battery Voltage
Signal Strength
Temperature
Maximum Recorded
Temperature
Alert Temperature

10 SPEKTRUM DX2S USER GUIDE
LIST
The List screen displays all the available functions. The
desired function can be accessed by highlighting the
desired function using the Rolling Selector and, when
highlighted, pressing the Rolling Selector to enter the
function.
TO ACCESS THE LIST SCREEN
From the telemetry or main screen press the Rolling
Selector until the List screen appears.
From any other screen, List is located at the top right
side of the programming screens. Highlighting List
with the Rolling Selector and then pressing the Rolling
Selector will return back to the List screen.
MODEL SELECT
TO ACCESS THE MODEL SELECT FUNCTION
In the List screen rotate the Rolling Selector to highlight
the Model Select function.
PresstheRollingSelectortoaccesstheSelectfunction.
Rotate the Rolling Selector to highlight the Select
function by placing the box around it.
PresstheRollingSelectorandtheboxwillflash,
indicating the Select function is active.
Use the Rolling Selector to select the desired model
memory (Models 1 thru 10).
To return to the main screen press and hold the Rolling
Selector for more than three seconds, or to go back to
the list screen roll up and select List.