Sport-thieme 122 6557 Manual

Operating/assembly instructions
Wall bars, w=80 cm
Prod. no. 122 6557; 122 6560
(210 x 80) (230 x 80)
page 1of 3
04/2016
!
!
Assembly instructions for fixed mounting of wall bars
Thank you very much for choosing a Sport-Thieme product. Please read the instructions
fully before you assemble the equipment so you can enjoy the product and its
guaranteed safety:
These wall bars with round rungs are designed for use in primary schools and nurseries
as well as at home.
Included:
Pos. Description
1 1 x wall bars
2 4 x mounting bracket L130 x 65 x 3 x 25 long
3 4 x coach bolt with spring washer and nut M 8 x 40
4 4 x hexagonal wood screw M 8 x 60
5 4 x nylon wall plug S 12
!
!

Operating/assembly instructions
Wall bars, w=80 cm
Prod. no. 122 6557; 122 6560
(210 x 80) (230 x 80)
page 2of 3
04/2016
!
!
Assembly instructions:
Please, make sure that the coach bolts (short bolts with rounded head) sit tightly on the
inside of sides. To achieve this, you can use a standard hammer for example. Once the
square part of the bolt is hammered into the wood the bolt will not turn when the mounting
bracket is later mounted.
Coach bolt M8 x 40 mm
Nut and spring washer
If installed correctly, the
rounded head of the bolts
should sit on the inside of the
side without leaving a gap.
The mounting of the wall
bars can only be completed
when this has been done.
!
""
Use the hexagonal screws (long
screws with hexagonal head) for
mounting to the wall.
Width!of!recess!1100!
#
$
%

Operating/assembly instructions
Wall bars, w=80 cm
Prod. no. 122 6557; 122 6560
(210 x 80) (230 x 80)
page 3of 3
04/2016
!
!
Please check the wall before mounting the wall bars to it.
The wall should be stable and solid (solid brick, lime sand
brick, or reinforced concrete) and be able to cope with
horizontal forces in accordance with DIN 7910.
If you are not sure about the wall's properties, please consult
a structural engineer.
First, fix the mounting brackets to the wall. The mounted wall bars must stand on the floor.
See the illustration for drilling measurements on the wall and the sides. The wall bars do
not have any pre-drilled holes because on-site conditions such as electrical wiring, pipes
and others, could make mounting impossible. The height information for the mounting
brackets (wall plugs) is approximate. The horizontal distance between the mounting
brackets must be 880 mm.
Maintenance and care instructions
Instructions: Carry out a visual check at regular intervals. Due to our
continuous quality control of the products, technical changes
may occur which may lead to slight deviations in the
instructions.
Check at regular intervals that the screw connections are tight.
Check the equipment for possible damage and replace worn-out
parts. Check the condition of wooden elements as chipping and
other signs of wear can result from use.
We are happy to answer any questions
you may have.
Your Sport-Thieme
Team