SportsArt Fitness A918 User manual

LOW ROWLOW ROW
A918
OWNER'S MANUAL
ASSEMBLY INSTRUCTIONS

A. SAFETY INSTRUCTIONS
Read all cautions/warnings and obtain proper instruction on use of the machines
prior to using. Use appropriate positioning and controlled movements.
Assemble and operate the strength on a solid, level surface. Do not use outdoors
or near water.
Never allow children on or near the strength.
Make sure all fasteners are properly tightened for safety. DO NOT use the
strength if the unit is disassembled in any way.
Keep head, limbs, and fingers clear of all moving parts.
If at any time during exercise you feel faint, dizzy or experience pain, stop and
consult you physician.
DO NOT wear loose or dangling clothing while using the equipment. Keep away
from all moving parts.
Use care when mounting and dismounting the unit.
DO NOT use any accessories that aren't specifically recommended by the
manufacturer. These might cause injuries or cause the unit to fall.
Close supervision is necessary when this strength is used by, on, or near
adolescent, invalids, and disabled persons.
Use this strength only for its intended use as described in this manual.
Never operate this strength if it has been damaged in any way. If it is not working
properly, been dropped or damaged, contact your dealer. DO NOT attempt to fix a
broken or jammed machine. Notify floor staff.
Never drop or insert any object into any opening.
1

2
B. Introduction
Logo display board
Front cover
Back cover
Side frame
Cord
Belt
Foot pad
Seat cushion
Frame
Foot rest
Grip
Stack fork
Weight stack
(11Lbs / 5kgs)

1. One side
2. One seat cushion
3. One frame
4. One grip
5. Two hexagon head bolts M10 x P1.5 X L30 for the side frame and frame
6. Two spring washers M10 for the side frame and frame
7. Two hexagon nylon nuts M10 x P1.5 for the side frame and frame
8. Four hexagon socket raised head bolts M8 x L20 for the seat cushion
9. Four spring washers M8 for the seat cushion
10. One double-end open wrench, 17mm x 23mm
11. One double-end open wrench, 8mm x 17mm
12. One hex key wrench, M6
13. One hex key wrench, M5
14. User's manual
15. Four washers, D16 x d10.2 x t1.0 for the side frame and frame.
frame
3
C. List of Parts

D. STEP BY STEP INSTRUCTION:
1. Tighten the seat cushion with the screws provided. (See Fig. 1)
2. Assemble the frame with screws as shown in Fig 2.
4
Fig.2
Fig.1

Fig.3
Fig.4
5
3. Loosen the screws and take off the axle as shown in diagram A. Then place the
belt as shown and secure the axle with screws as shown in diagram B. (See Fig.3)
4. Assemble the grip with the hook as shown in the diagram. (See Fig.4)
diagram
diagram

Fig.5
6
E. BELT ADJUSTMENT:
1. If the belt is too tight or too loose, first loosen nut A as shown then adjust nut B. If
the belt length is too long, adjust downward; if the belt length is too short, adjust
upward. Adjust the belt to the proper position, then tighten nut A.
2. The gap between nut A and B must be within 35mm(1.4"). If the gap still
exceeds the 35mm limit after the first step, please loosen the screws on C
and adjust the belt to the proper length. Tighten the screws and follow the
1st step again. (See Fig. 5)

7
Usage Instruction: