SportsArt Fitness N865 User manual

N865/G690 Service Manual (Mechanism Category)

1. Exploded View Diagram for Use in Business
M1-1-1

1. Exploded View Diagram for Use in Business
M1-1-2

1. Exploded View Diagram for Use in Business
M1-1-3

1. Exploded View Diagram for Use in Business
M1-1-4

1-2.Introduction to Major Parts of the Machine
M1-2-1
Jogging Belt
Foot Plate
Rear-End Set
Side Plate
Support Rod
Handl
e
Electronic Meter

1-2.Introduction to Major Parts of the Machine
M1-2-2
Horizontal Rod X3
Front Wheel
Block Wheel X4
Rear Wheel
Slide Plate

Inspection & Maintenance
Item: Checklist.
Sequence
Check Items
Check Contents
1.
Brake System
a. When you abort operations, the Jogging Belt will be very tight.
b. When you press Start, the Jogging Belt will become smooth.
c. Remove the safety-key, and the Jogging Belt will be very tight.
d. When you abort operations, the Machine will be shut down automatically and the
Jogging Belt will be very tight.
2.
Inspection of the Battery
1. Battery Voltage
3.
Inspection of the Slope
1.The Ideal Slope should be 7.0%.
4.
Inspection on the Tightness of the Jogging
Belt and the Deviated Belt.
1. Adjustment to the tightness of the Jogging Belt and the Deviated Belt.
5.
Inspection on the Smoothness and
Abnormal Sounds of the Jogging Belt.
1. When the Jogging Belt slides, check if the Jogging Belt is moving smoothly without
any abnormal sound.
6.
Inspection of the Front Wheel and the
Poly-Rib Belt.
1. Check if the position of the Poly-Rib Belt is the middle of the idler wheel.
2. Tightness of the Poly-Rib Belt. The sound frequency should be between 125-135hz .
7.
Maintenance of the Internal Transmission
System.
1. Use the Dry Cloth to clean the Bearing in the Jogging Belt.
2. Use the Dry Cloth to clean the Surface of the Slide Plate.
3. Use the Dry Cloth to clean the Inner Layer Surface of the Jogging Belt.
8.
Cleaning and Maintenance of the Front
and Rear Wheels.
Clean and Maintain the Front and Rear Wheels when the Jogging Belt is disassembled..
1. The Dust on the Surface of Rear Wheel before cleaning
9.
Cleaning of the Plastic Outer Cover
1. Dampen the cloth and wring out excess water. Then, use the Cloth to clean the Plastic
Outer Cover.
10.
M2-1-1

Inspection & Maintenance
Item: Fine-tuning of the Tightness of the Jogging Belt and the Deviated Belt.
M2-2-1
Testing Point for the
Test Rod
Left Side: Tightness
Adjustment
Right Side: adjustment
of the Deviated Belt
Position for Placement of the
Test Rod

Inspection & Maintenance
Item: Fine-tuning of the Tightness of the Jogging Belt and the Deviated Belt
M2-2-2
Step1. As shown below, gently insert the Test Rod into the tightness
testing port.
Step2. Insert the Test Rod into the tightness testing port, as shown
below.
Step３.Adjust the Rear Wheel Screw, so that Half of the Red Part
of the Test Rod is exposed.
Clockwise tightening Counter-Clockwise 
loosening
Step4. Half of the Red Part of the Test Rod is exposed.