Stanley SLP3 Setup guide

1
STANLEY Spot Line SLP3 and SLP5 repair instruction
TO REPLACE INTERNALS
1 Remove the 4 screws from the SLP mount
base
The screws circled in blue can be directly
removed while the 2 circled in red can only be
accessed by rotating the base to align the hole
with the screw. Attention should be paid to the
angle the base rotates to as shown to see the
screws inside

2
2. Remove the top housing.
It is now possible to remove the top housing, then left, right, front
dot window and the horizontal beam window
3. Unplug the connector linking the top housing
and main board.

3
4).Remove the other 4 bottom screws that secure the
internals
The 2 screw cirled in blue can be directly removed and the 2 screws circled
in red can only be removed by rotating the base to align the hole with the
screw hole underneath. Attention should be paid to the angle the base
rotates to as shown so as to see the screws inside

4
5). Remove the connector linking the internals and the main board.
Then remove the internals

5
To Disassemble the base
1). Remove the 4 screws from the base, then unsolder the 2 cables linking
the main unit and the base.

6
2).Now it is ok to remove the “nail hook” from the base

7
3). Remove the bottom screws as shown below
Then it is ok to remove the base top from the base