Stanley SXLS31322E User manual

SXLS31322E - 240V
40W Plasterers Worklight
Instruction Manual
IP44
Technical Data
Supply Voltage: 220-240 V~ 50 Hz
Bulb Type: Non-replaceable 40W LED
(See rating / box info)
Conformity with all relevant EC Directive
requirements.
Class I product, must be connected to earth.
Protects against solid objects over 1mm and
sprays from all directions.
Limited ingress permitted.
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or local store for recycling
advice.
The light source contained in this luminaire
shall only be replaced by the manufacturer or
his service agent or a similar qualified person

Images for illustration purposes only – Product may differ slightly from the one shown
Safety
These instructions are for your safety. Please read through them thoroughly prior to installation
and retain them for future reference.
Always organise cables and extension leads so that they will not be a trip hazard
Check the pack and make sure you have all of the parts listed.
Remove all packaging, wrap etc. from the product.
Decide on the appropriate location for your product.
IP44 product: Protects against solid objects over 1mm and sprays from all directions,
Limited ingress permitted.
Always refer to the installation drawing for the orientation of the product.
Never put anything on the product or hang anything on any part of this product.
When the product does not light after installation:
> Ensure there is no electricity failure
> Ensure all the connections are secured
If the external flexible cable or cord of this Luminaire is damaged, it must only be replaced by a
qualified electrician to avoid any electrical hazards.
Always disconnect the product from mains at least 10 minutes allowing to cool down before
any maintenance or adjustment.
Cleaning care
The lamp can be cleaned with a clean dry cloth. Do not immerse it in water.
Always switch off the supply before cleaning
READ ALL INSTRUCTIONS Installation Instructions
Parts Supplied
x1
CAUTION: Do not stare at the operating LED light source.