Stanley SXLS36986E User manual

IP54
Technical Data
Supply Voltage: 220-240 V~ 50 Hz
Bulb Type: Non-replaceable 30W LED
Class I product, must be connected to earth.
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or local store for recycling
advice.
Protects against dust and low pressure jets
of water from all directions.
Limited ingress permitted.
Conformity with all relevant EC and UK
Directive requirements.
&
SXLS36986E
LED Area Globe Light
Instruction Manual
SAVE THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE
The thick and thin horizontal line field and the engineering plan packaging design are trademarks
of Stanley Tools.
CUSTOMER SUPPORT:
For customer service please visit the Online Customer Service Centre at: www.2helpU.com
© Stanley Black & Decker, Inc.
STANLEY and the STANLEY Logo are trademarks of Stanley Black & Decker, Inc or one of its afiliates,
and are used under license.
Products are manufactured by:
Cascade Holdings Ltd.
Gorse Mill, Gorse St
Oldham, OL9 9RJ U.K.
www.stanleytools.co.uk
2-YEAR LIMITED WARRANTY
The warranty of this product is covered by Cascade Holdings Ltd.
Eu Authorised Representative:
Authorised Rep Compliance
Ground Floor
71 Lower Baggot Street
Dublin
Ireland
D02 P593

Images for illustration purposes only – Product may differ slightly from the one shown
Safety
These instructions are for your safety. Please read through them thoroughly prior to installation
and retain them for future reference.
Always organise cables and extension leads so that they will not be a trip hazard
Check the pack and make sure you have all of the parts listed.
Remove all packaging, wrap etc. from the product.
Decide on the appropriate location for your product.
IP54 product: Protects against dust and low pressure jetsof water from all directions.
Limited ingress permitted.
Always refer to the installation drawing for the orientation of the product.
Never put anything on the product or hang anything on any part of this product.
When the product does not light after installation:
> Ensure there is no electricity failure
> Ensure all the connections are secured
If the external flexible cable or cord of this Luminaire is damaged, it must only be replaced by a
qualified electrician to avoid any electrical hazards.
Always disconnect the product from mains at least 10 minutes allowing to cool down before
any maintenance or adjustment.
Cleaning care
The lamp can be cleaned with a clean dry cloth. Do not immerse it in water.
Always switch off the supply before cleaning
READ ALL INSTRUCTIONS Installation Instructions
Parts Supplied
x1
CAUTION: Do not stare at the operating LED light source.
Extension Socket
Additional features:
Magnetic base.
Adaptor - the lamp can be used on a Tripod. (Item SXLS37627E)
Storage Hook