START International Labelmoto LD6025 User manual

7
5
Load Dispenser
Plug In & Turn On
A: Feed label liner under guide
rod and brush
A: Connect power cord (in back)
B: Press power switch (on back) to turn
on machine
B
A
A: Loosen wingscrew to adjust sensor plate
B: Point sensor towards front edge of label
C: Tighten wingscrew to secure sensor
plate in place
QuickSTART
4270 Airborn Dr | Addison, TX 75001, USA
972.248.1999 | [email protected]
www.STARTinternational.com
Need more help? Download the full manual or contact us.
QS03.14
LD6025 LD6050 LD6100
LDX6025 LDX6050 LDX6100
Guide
A
C
Point sensor toward
edge of label
B
B: Bend liner around strip plate
and take-up hub (label will hang
slightly over edge for lifting)
C: Slide lock rod back into
take-up hub to secure liner
6
D: Slide small hub lock into
guide rod and rotate clockwise
lightly until it locks into place
B
C
A
D
LD6050 Model Shown
Small Hub Lock
Slide the hub lock into the rod
Turn the hub lock clockwise
lightly until it locks into place
Now you’re ready to roll.
Adjust Sensor

4
3
Material Guide
A: Slide large hub lock into reel hanger
bar to secure label roll
B: Rotate the large hub lock lightly
clockwise until it locks into place
Remove Lock Rod
A: Slide lock rod off take-up hub
A
B
A
2
1
Load Label Roll
A: Insert core holders (2) into each side of your
label roll
B: Slide loaded roll into reel hanger bar
Lift Reel Holder Arm
A: Lift reel holder arm slightly past 90º angle
and lock into position using provided
hex wrench
A
A
B
ITEMS INCLUDED
LD6025, LD6050, LD6100
Electric Label Dispenser
Large Hub Lock
Power Cord
Hex Wrench Core Holders (2)
LDX6025, LDX6050, LDX6100
Small Hub Lock