START International THO DC5100 User manual

7LD5000
5
Load Dispenser
Plug In - Turn On
A: Feed label liner under
guide rod and brush
B: Bend liner around
strip plate (label will hang
slightly over edge for lifting)
C: Slide lock rod back onto
take-up hub to secure liner
A: Connect power cord (in back)
B: Press power switch (on front) to turn
on the machine
A
B
C
B
A
6
Adjust Sensor
A: Loosen wingscrew to adjust sensor plate
B: Point sensor towards edge of label
C: Tighten wingscrew to secure in place
A
C
Point sensor toward
edge of label.
B
Quick Start Guide
DC5100
4270 Airborn Dr. Addison, TX 75001, USA
972.248.1999 | [email protected]
startinternational.com
Need more help? Download the full manual or contact us
Q9.4
®

ITEMS INCLUDED
DC5100
Electric Label Dispenser
4
2
31
Load Label Roll
A: Insert core holders (2) into each side
of your label roll
B: Slide loaded roll onto the reel hanger bar
Lift Reel Holder Arm
A: Lift reel holder arm slightly past 90º
angle and lock into position using
provided hex wrench
Material Guide
A: Slide material guide onto reel hanger
bar to secure your label roll
B: Tighten lightly using tension screw
Dispenser
A
Remove Lock Rod
A: Slide lock rod off of take-up hub
Core Holders (2)
Material Guide
Power Cord
Hex Wrench
A
B
A
A
B