STATESMAN ESH60SS User manual

ESH60SS / ESH60WH
BUILT-IN ELECTRIC HOB
Instruction Manual

SAFETY WARNINGS
Your safety is important to us. Please read this
information before using your electric hob.
Installation
Electrical Shock Hazard
• Disconnect the appliance from the mains
electricity supply before carrying out any
work or maintenance.
• Connection to a good earth wiring system
is essential and mandatory.
• Alterations to the domestic wiring system
must only be made by a qualied
electrician.
• Failure to follow this advice may result in
electrical shock or death
Cut Hazard
• Take care – panel edges are sharp.
• Failure to use caution could result in injury
or cuts.
Important Safety Instructions
• Read these instructions carefully before
installing or using this appliance.
• No combustible material or products should
be placed on this appliance at any time.
• Please make this information available to
the person responsible for installing the
appliance as it could reduce your
installation costs.
• In order to avoid a hazard, this appliance
must be installed according to these
instructions for installation.
• This appliance is to be properly installed
and earthed only by a suitably qualied
person.
• This appliance should be connected to a
circuit which incorporates an isolating
switch providing full disconnection from the
mains power supply.
• Failure to install the appliance correctly
could invalidate any warranty or liability
claims.
Operation and Maintenance
Electrical Shock Hazard
• Do not cook on a broken or cracked electric
hob. If the hob surface should break or
crack, switch the appliance off immediately
at the mains power supply (wall switch) and
contact a qualied technician.
• Switch the electric hob off at the wall before
cleaning or maintenance.
• Failure to follow this advice may result in
electrical shock or death.
Health Hazard
• This appliance complies with
electromagnetic safety standards.
• Failure to follow this advice may result in
death.
Hot Surface Hazard
• During use, accessible parts of this
appliance will become hot enough to cause
burns
• Do not let your body, clothing or any item
other than suitable cookware contact the
electric hob surface until it is cool.
• Never leave metal objects (such as kitchen
utensils) or empty pans on the hob as they
can become hot very quickly.
• Keep children away.
• Handles of saucepans may be hot to touch.
Check saucepan handles do not overhang
other cooking zones that are on.
Keep handles out of reach of children.
• Failure to follow this advice could result in
burns and scalds.
Cut Hazard
• The razor-sharp blade of an electric hob
scraper is exposed when the safety cover is
retracted. Use with extreme care and always
store safely and out of reach of children.
• Failure to use caution could result in injury
or cuts.

Important Safety Instructions
• Never leave the appliance unattended when
in use. Boil over causes smoking and
greasy spill overs that may ignite.
• Never use your appliance as a work or
storage surface.
• Never use your appliance for warming or
heating the room.
• After use, always turn off the cooking zones
and the electric hob as described in this
manual.
• Do not allow children to play with the
appliance or sit, stand or climb on it.
• Do not store items of interest to children
in cabinets above the appliance.
Children climbing on the electric hob could
be seriously injured.
• Do not leave children alone or unattended
in the area where the appliance is in use.
• Do not repair or replace any part of the
appliance unless specically recommended
in the manual. All other servicing should be
done by a qualied technician.
• Do not use a steam cleaner to clean your
electric hob.
• Do not place or drop heavy objects on your
electric hob
• Do not stand on your electric hob.
• Do not use pans with jagged edges or drag
pans across the ceramic electric hob as
this can scratch the surface.
• Do not use scourers or any other harsh
abrasive cleaning agents to clean your
electric hob as these can scratch the
surface.
• If the mains cable is damaged, it must be
replaced by a qualied technician.
• Do not operate your electric hob by means
of an external timer or separate remote
control system.
• Warning: If the surface is cracked, switch
off the appliance to avoid the possibility of
electric shock.
• Do not leave any objects such as knives,
forks, spoons and lids should not be
placed on the hob surface since they can
get hot.
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision
or instructions concerning the use of the
appliance by a person responsible for
their safety.

Thank you for purchasing our product. We hope you enjoy using the many features and
benets it provides. Before using this product please study this entire Instruction Manual
carefully. Keep this manual in a safe place for future reference. Ensure that other people
using the product are familiar with these instructions as well.
UNPACKING
Remove all packaging from the unit.
Retain the packaging.
If you dispose of it please do so
according to local regulations.
The following items are included:
Main Unit
1. Max. 1000W zone
2. max. 1500W zone
3. Control Panel
1. Power Regulating Controls
2. Power Indicator Light
Screws x 4
Instruction
& Installation
Manual
Brackets x 4
PRODUCT OVERVIEW
Top View Control Panel

BEFORE USING YOUR NEW ELECTRIC HOB
Read this guide, taking special note of the “Safety Warnings” section.
Remove any protective lm that may still be on your electric hob.
Make sure that the base of
your pan is smooth,
sits at against the surface
and is the same size as
the cooking zone.
Always lift pans off the electric hob –
do not slide, or thay may scratch
the surface.
2. Adjust the power regulating control to the desired
level to turn on the control.
Setting 1 – Lower heat setting
Setting 6 – Higher heat setting
CHOOSING THE
RIGHT COOKWARE
Do not use cookware with jagged
edges or a curved base.
USING YOUR ELECTRIC HOB
To Start Cooking
1. Place a suitable pan on the cooking zone you wish to use.
Make sure the bottom of the pan and the surface of the
of the cooking zone are clean and dry.
When You Have Finished Cooking
Turn the cooking zone off by turning the power regulating
control to “O” position.

CLEANING AND MAINTENANCE
The settings below are guidelines only. The exact setting will depend on several factors,
including your cookware and the amount you are cooking.
Experiment with the electric hob to nd the settings that best suit you.
HINTS AND TIPS
The above are the judgement and inspection of common failures.
Please do not disassemble the unit by yourself to avoid any dangers
and damages to the hob.
What?
Everyday soiling on
surface
( ngerprints, marks,
stains left by food or
non-sugary spillovers
on the surface )
Spillovers on the
power regulating
controls
How?
1. Switch the power to the
electric hob off.
2. Apply an electric hob cleaner
while the hob is still warm
(but not hot!)
1. Switch the power to the
electric hob off.
2. Soak up the spill.
3. Wipe the power regulating
control area with a clean damp
sponge or cloth.
4. Wipe the area completely dry
with a paper towel.
3. Rinse and wipe dry with a
clean cloth or paper towel.
Important!
• When the power to the electric hob is
switched off, there will be no ‘hot surface’
indication but the cooking zone may still
be hot! Take extreme care.
• Heavy-duty scourers, some nylon scourers
and harsh/abrasive cleaning agents may
scratch the surface. Always read the
label to check if your cleaner or scourer
is suitable.
• Never leave cleaning residue on the
electric hob: the surface may become
stained.
• Make sure you wipe the power regulating
control area dry before turning the
electric hob back on.
Problem
The electric hob
cannot be turned on.
The surface is being
scratched.
Possible Causes
No power.
Rough-edged cookware.
Unsuitable abrasive scourer or
cleaning products being used.
What To Do
Make sure the electric hob is connected to
the power supply and that it is switched on.
Check whether there is apower outage in
your home or area.
If you’ve checked everything and the
problem persists, call a qualied
technician.
Use cookware with at and smooth bases.
See ’Choosing the Right Cookware’,
See ‘Care and Cleaning’.

INSTALLATION
Preparing the Worktop
Cut out the work surface following the dimensions shown in the drawing below
For the purpose of installation and use, a minimum distance of 5.5cm space must be left around
the cut out. Ensure the thickness of the work surface is is at least 20mm. Use a heat resistant work
surface material to avoid deformation caused by heat from the hob. Minimum distance between
hob and cupboard should be at least 65mm.
Ensuring Adequate Ventilation
Make sure the ceramic cooker hob is well ventilated and that air inlet and outlet are not blocked.
This hob requires an adequate supply of fresh, cool air to fully function. The base of the hob must
have direct unrestricted ventilation to the room where the hob is installed.
Follow the
requirements
below.
There are ventilation holes around outside of the hob.
YOU MUST ensure these holes are not blocked by the
worktop when you put the hob into position.

Fastening the Fixing Brackets
The unit should be placed on a stable, smooth surface (use the packaging).
1. Turn the hob upside down and fasten the brackets to the appropriate holes.
DO NOT tighten the screws at this stage.
2. Apply sealing strips around the edge of hob.
3. Insert the hob into the cut out and position it correctly.
4. Tighten the screws to secure the hob to the worktop.
• The hob must be installed by qualied personnel or technicians.
• Do not mount above cooling equipment, dishwashers and rotary dryers.
• Surfaces around the hob should be able to withstand heat generated by hob.
• Never use a steam cleaner to clean the hob.
• Do not use a silicon sealant to seal the appliance against the aperture. This will make it
difcult to remove hob from the aperture, particularly if servicing is required.
Do not over-tighten the hob
clamps as distortion of the
hob may occur.

ELECTRICAL CONNECTION
Fitting Guidelines
The electric hob is manufactured to work with single-phase alternating current (220V-240V/50Hz.
The connection diagram is also on the cover of the connection box.
Connecting the Hob to the Mains Power Supply
The connection cable must be secured in the strain-relief clamp.
Wiring Instructions
The earth wire coloured Green/Yellow must be connected to the Earth terminal marked .
The Live wire coloured Brown must be connected to the Live terminal marked L.
The neutral wire coloured Blue must be connected to the terminal marked N.
Always place the wire on the side of the screw which
follows the tightening direction (clockwise).
All electrical work should be carried out by a suitably qualied and authorised
electrician. No alterations or wilful changes in the electricity supply should be
carried out.
The electricity supply for the electric hob must have
an isolation switch which enables the power to be
cut off in case of an emergency and for maintenance.
The distance between the working contacts of the
isolation switch must be at least 3mm.
Before connecting the electric hob to the mains
power supply it is important to read the information
on the data plate and the connection diagram.

This symbol on the product or in the instructions
means that your electrical equipment should be
disposed of at the end of its life separately from
your household waste.
There are separate collection systems for
recycling in the EU.
For more information, please contact your local
authority or your retailer where you purchased
the product.
SPECIFICATIONS
Features and specications are subject to
change without prior notice.
Model 60PKE10S01
Power (W) 5000W (max)
Voltage (V) 220-240V
Frequency (Hz) 50
SERVICE AND SPARE PARTS
Should you experience any difculty in using your Statesman appliance at any time,
you may contact your Statesman Retailer or call our Customer Service Department on:
0844 848 5861
Disclaimer: Updates to hardware components are made regularly. Therefore some of the instructions, specications and pictures in this
documentation may differ slightly from your particular situation. All items described in this guide are for illustration purposes only and may
not apply to your particular situation. No legal right or entitlements may be obtained from the description made in this manual.
Spare Parts information
can be obtained by
calling our Spare Parts
Department on:
0844 848 5862
Please have the following details ready;
• Model Name / Model Number
• Serial Number
• Date of Purchase
• Where Purchased
• Customer Name and Address including Post Code
• Contact Telephone Number
• Accurate description of the fault