STC Easy Grow User manual

Y
e
a
r
s
W
a
r
r
a
n
t
y
P
C
S
H
E
L
L
7
10
Y
e
a
r
s
W
a
r
r
a
n
t
y
S
T
R
U
C
T
U
R
E
Easy GrowTM
6’ x 12’ Greenhouse
Assembly Instructions
Systems Trading Corporation
450 7th Avenue Suite 2809, New York, NY 10123
Customer service: 1-877-782-4482 Email: [email protected]
T

www.stcny.com 1 / 44
Introduction
Before Starting Assembly:
5. Make sure you have the proper tools:
After choosing a location, proper preparation of the site is essential. The site must be level. If the site is
not level, create a base slightly larger than the outside dimensions of the greenhouse using a perimeter
diagonals from both sides and making sure they are equal. The greenhouse is secured from the inside
with pegs into holes cast with concrete. See step15 for details.
level. Make sure you have checked with your local authorities regarding any required building permits.
water drainage and easy access to power and water necessary for greenhouse gardening.
Choose a sunny, level position away from overhanging trees and power lines and protected from the
wind as much as possible. The location should be away from structures that could cause snow to drift
on or around the greenhouse.
Locate underground pipes or cables before preparing the site or anchoring the greenhouse.
The List of Parts has the corresponding step number referenced to each part. We recommend that
while you go through the list, make staging areas for each step and place the parts necessary for
2. Lay the parts out in separate staging areas:
3. Select a Location:
4. Prepare a Foundation:
1. Make sure you have all the necessary parts:
Compare the contents of the three cartons to the List of Parts. If any parts are missing or damaged or
you have any questions, please contact Customer Service by phone at 877-782-4482 or by email
at easygr[email protected] before beginning assembly.
CAREFULLY READ ALL INSTRUCTIONS BEFORE YOU BEGIN AND FOLLOW THE STEPS IN
THE ORDER THEY ARE PRESENTED.
NOTE: A cordless drill with Phillips head bit is highly recommended but not essential.
Tape Measure
Work Gloves
Safety Goggles
Phillips Screwdriver
Spirit Level
Small Step Ladder
Wooden Mallet
Liquid Soap or WD40 Lubricant
Scissors
Hex Key (included)
•
•
•
•
•
•
•
•
•
•
Our patented greenhouse has been designed to be easily assembled. All but one step can be completed
by one person. You will need assistance from another person to attach the roof. Although the greenhouse
can be assembled in six to eight hours, we recommend you take your time and make it a weekend project.
These instructions include helpful hints and important information needed to safely assemble and properly
maintain the greenhouse. Please read these instructions completely before you begin.
Thank you for purchasing your Easy GrowTM 6x12 Greenhouse. This model features two roof vents and a
circular air vent to ensure proper ventilation. We have also included an automatic vent opener to help
greenhouse will provide years of enjoyment.

2 / 44
www.stcny.com
12
2
2
9
13
13
4
45
8
6
10
3
3
11
11
14
15
7
1
1
General Order of Assembly
Step 2: Assemble Front and Back
Step 1: Prepare Doors
Step 3: Assemble Sides
Step 4: Prepare Shelves
Step 5: Connect Sides to Back
Step 6: Connect Sides to Front
Step 7: Prepare Roof Vents
Step 8: Connect Gables and Roof Vents
Step 9: Brace Sides
Step 10: Install Circular Vent
Step 11: Install Side and Roof Panels
Step 12: Install Trim Plates
Step 13: Hang Doors
Step 14: Secure to Ground
Step 15: Install Trays
Safety Advice Table of Contents
Dispose of all plastic bags safely. Keep them out of the
reach of small children.
Keep children and pets away from the assembly area until
the work is completed.
Always wear shoes, gloves and safety goggles when working.
In manufacturing all sharp edges and burs have been removed
but caution should still be taken when handling metal parts.
Do not lean against or push the greenhouse during assembly.
Take special care not to touch overhead power lines with the
Do not attempt to assemble the greenhouse in windy or wet
Do not position your greenhouse in an area exposed to
excessive wind.
If using power tools or a step ladder always follow the
manufacturer’s safety instructions.
Hot items such as recently used grills, blow torches etc.,
must not be stored in the greenhouse.
Store the polycarbonate panels in a cool dark place like a
garage until you are ready to use them.
Make sure the greenhouse complies with local building codes.
level surface.
conditions.
Introduction .....................................
Safety Advice .................................
General Order of Assembly ......
List of Parts .....................................
Assemble Front and Back...........
Prepare Doors ...............................
Assemble Sides .............................
Prepare Shelves ............................
Connect Sides to Back ...............
Connect Sides to Front .............
Prepare Roof Vents ......................
Connect Gables and Roof Vents
Brace Sides ...................................
Install Circular Vent ..................
Install Side and Roof Panels ...
Install Trim Plates .......................
Hang Doors ..................................
Secure to Ground .......................
Install Trays.....................................
1
2
2
3
6
8
16
22
23
25
28
29
37
38
39
41
43
44
35