STI EZ-Path NEZ33R User manual

INSTALLATION INSTRUCTIONS
Specified Technologies Inc.
Somerville, NJ 08876 USA
T: [phone] • F: [phone]
www.stifirestop.com
Page 1 of 2
Warranty: www.stifirestop.com/legal/warranty
Made in USA • Printed in USA
ZIS1089 3059
1
3
5
2
4
6
Wrap outer (larger) pathway shell assemblies
around cables and align them. Attach them
together completely until there are audible
clicks.
x2
x8x8
x2
Cut gasket and wrap around outer shell
assembly ange.
Using the hardware supplied, drill
appropriate size hole and install anchors.
Slide outer shell towards wall, mark hole
locations and slide outer shell back.
Push outer shell towards the wall,
sandwiching the gasket.
Secure outer shell to the wall using
provided screws.
(Instructions continued on back)
Note: When installing NEZ33 the EZ-Path®logo needs to be facing you in the upright
position and the arrows should be pointing to the top and bottom of the device. For vertical
installations, horizontal supports should be installed.
Note: For more information on restop installation, refer to ASTM E3157.
Parts Included (Not to Scale)
Single Device Retrofit Device
(Part Number: NEZ33R)

INSTALLATION INSTRUCTIONS
Specified Technologies Inc.
Somerville, NJ 08876 USA
T: [phone] • F: [phone]
www.stifirestop.com
Page 2 of 2
Warranty: www.stifirestop.com/legal/warranty
Made in USA • Printed in USA
ZIS1089 3059
Single Device Retrofit Device
(Part Number: NEZ33R)
7
9
11
8
10
12
Wrap inner (smaller) pathway shell
assemblies around cables and align them.
Attach them together completely until there
are audible clicks.
Cut gasket and wrap around inner shell
assembly ange.
Using the hardware supplied, drill appropriate
size hole and install anchors.
Slide inner shell towards wall (and into
the outer shell from the other side), mark
hole locations and slide inner shell back
Push inner shell towards the wall,
sandwiching the gasket.
Secure inner shell to the wall using
provided screws.
Note: When installing NEZ33 the EZ-Path®logo needs to be facing you in the upright
position and the arrows should be pointing to the top and bottom of the device. For vertical
installations, horizontal supports should be installed.
Note: For more information on restop installation, refer to ASTM E3157.