STIEBEL ELTRON BBI 5 User manual

INSTALLATION
INSTALLATIE
ASENNUS
INSTALACE
INSTALACJA
INŠTALÁCIA
Bausatz Brauchwasserbereitung intern | Internal DHW heating set | Kit de montage pour production d’eau sanitaire interne|
Bouwset tapwateropwarming intern | Asennussarja - sisäinen käyttöveden lämmitys | Sada pro přípravu užitkové vody
interně | Wewnętrzny zestaw montażowy do przygotowywania wody użytkowej | Vnútorná konštrukčná súprava na prípravu
úžitkovej vody
»BBI 5

4| BBI 5
INSTALLATION
General information
INSTALLATION
1. General information
This document is intended for contractors.
Note Read these instructions carefully before using the ap-
pliance and retain them for future reference.
Pass on the instructions to a new user if required.
 This symbol indicates that you have to do something. The
action you need to take is described step by step.
Relevant documents
Operating and installation instructions for system
components
Note Please see appliance operating and installation in-
structions for information on the "Guarantee" and
"Environment and recycling".
2. Safety
Only a qualied contractor should carry out installation, com-
missioning, maintenance and repair of the set.
2.1 General safety instructions
We guarantee trouble-free function and operational reliability
only if original accessories and spare parts intended for the
appliance are used.
2.2 Instructions, standards and regulations
Note Observe all applicable national and regional regula-
tions and instructions.
2.3 Intended use
The set is used in connection with the WPKI5.
Any other use beyond that described shall be deemed inap-
propriate. Observation of these instructions and of instructions
for any accessories used is also part of the correct use of this
appliance.
3. Appliance description
The BBI5 internal DHW heating set is intended as a connection
between the WPKI5 and a DHW cylinder with integral heat
exchanger.
The set enables clear and straightforward connection of a DHW
cylinder to the WPKI 5 compact heat pump installation.
3.1 Standard delivery
The set is supplied in pre-assembled individual parts. All
pre-assembled components are sealed in at the factory.
D0000055092
1
2
3
5
2
4
1 Union nut G11/2 female thread
2 Gasket 11/2”
3 Pump manifold with non-return valve
4 Female/female pipe tting G1 female thread
5 Solder insert Ø28 with union nut G11/2 female thread
3.2 Required accessories
- UP 25/7.0 E
- UP25/7.5E
- WPKI5

BBI 5 |5
ENGLISH
INSTALLATION
Installation
4. Installation
D0000051812
1
2
3
4
6
7
8
9
5
1 Buer cylinder
2 Solder insert Ø28 with union nut G11/2 female thread
3 Circulation pump G11/2 male thread (accessories)
4 Pump manifold with non-return valve
5 Female/female pipe tting G1 female thread
6 Heat pump return G11/4male thread
7 Drain valve
8 Connection, expansion vessel
9 Heat pump flow G11/4male thread
 Replace the lower connection of the WPKI5 with the
pump manifold with non-return valve.
 Fit all components to the buer cylinder.
 Fit the ow and return connections to the heat pump.
 Tighten all ttings.
Note Ensure the safety valve of the WPKI5 cannot be shut
o from the heat source.
5. Specication
5.1 Pressure drop diagram
0
50
100
150
200
250
300
0500 1000 1500 2000 2500
2
1
D0000055447
X Flow rate [l/h]
Y Pressure drop [hPa]
1 Pressure drop with return connector
2 Pressure drop without return connector
5.2 Data table
BBI 5
234764
Max. operating pressure MPa 0.3
Connection G 1 1/4 / Cu 28 x 1.5
Installed length (gauge) mm 180
Weight kg 1.38

STIEBEL ELTRON GmbH & Co. KG
Dr.-Stiebel-Str. 33 | 37603 Holzminden
Tel. [phone] | Fax [phone]
[email protected]
www.stiebel-eltron.de
Irrtum und technische Änderungen vorbehalten! | Subject to errors and technical changes! | Sous réserve d‘erreurs et de modifications techniques! | Onder voorbehoud
van vergissingen en technische wijzigingen! | Salvo error o modificación técnica! | Rätt till misstag och tekniska ändringar förbehålls! | Excepto erro ou alteração técnica |
Zastrzeżone zmiany techniczne i ewentualne błędy | Omyly a technické změny jsou vyhrazeny! | A muszaki változtatások és tévedések jogát fenntartjuk! | Отсутствие ошибок
не гарантируется. Возможны технические изменения. | Chyby a technické zmeny sú vyhradené! Stand 8843
tecalor GmbH
Fürstenberger Str. 77 | 37603 Holzminden
Tel. [phone] | Fax [phone]
[e-mail]
www.tecalor.de
A 268939-38930-9061
4<AMHCMN=gijdje>