Stirling EE-5612 User manual

Premium Tower Fan
Model Number EE-5612
QUICK START GUIDE
AFTER SALES SUPPORT
MODEL: EE-5612 PRODUCT CODE: 10973 11/2019
Version: 3
1800 898 750
AUS
[email protected]

The base of the tower fan comes in two parts, which fit around the tower. Both
parts fit easily together. The back half is the one with cut-outs for the power
supply cord.
1. First attach the front half of the base, aligning the
holes in base with the screw holes at the base of
the tower fan, and leading the power cord through
the centre hole.
2. Then snap the back half of the base to the front half
and secure with the four screws supplied (Fig. 1).
3. Thread the power supply cord through the two
cut-outs at the bottom of the base.
Assembly
AFTER SALES SUPPORT
MODEL: EE-5612 PRODUCT CODE: 10973 11/2019
Version: 3
1800 898 750
AUS
[email protected]
The fan may be operated by the manual controls located on the top of the fan
(Fig. 3) or by using the remote control (shown in Fig. 2).
1. Place the fan on a stable flat surface. Plug the cord set into a
220V-240V~A.C. electrical outlet.
2. POWER: Turn the fan on by pressing the ‘POWER’ button; Turn the fan off by
pressing the ‘POWER’ button again.
3. SPEED: You can adjust the fan speed to the desired level; low, medium, or
high by pressing ‘SPEED’. The speed setting is displayed on the LED screen
(Fig. 4).
4. MODE: Pressing the ‘MODE’ button will set the fan into NORMAL,
NATURAL, and SLEEP mode.
Getting Started Fig. 1
Fig. 3 Fig. 4
Fig. 2

AFTER SALES SUPPORT
MODEL: EE-5612 PRODUCT CODE: 10973 11/2019
Version: 3
1800 898 750
AUS
[email protected]
5. TIMER: When the fan is in use, you can set the Timer to switch the fan to
standby after the specified time. Press the ‘TIMER’ button repeatedly to
increase the Timer setting from 1 hour to 12 hours as indicated on the LED
Display. After 5 seconds, the Timer will start. Once the Timer runs out, the
fan will switch off, and the detected Room Temperature will be shown on the
LED Display. When the Timer is set, the LED display shows the time after
which the fan will switch off.
6. OSC: Pressing the ‘OSC’ button will start and stop the oscillation function.
The symbol is displayed on the LED screen.
7. TEMP: Once the unit is plugged into the power socket and switched on, the
fan will show the room temperature, and the ‘TEMP’ will change to ‘TIMER’
when the timer is set.
8. Power save mode: When the ‘SLEEP’ mode or the ‘TIMER’ is on, the main
display will turn off after 30 seconds. Press any key to turn on the display
again.
Getting Started
WARNING: Keep batteries out of reach of children. Swallowing may
lead to serious injury or death in as little as 2 hours due to internal
burns. If swallowed, go straight to a hospital emergency room.
Dispose of used batteries immediately. If you suspect your child has
swallowed or inserted a button battery immediately call the 24-hour
Poisons Information Centre on 13 11 26 and you will be directed to
the nearest hospital or emergency service that can manage the injury.
0-5
DANGER if swallowed