Store More ATHENA ARBOUR User manual

ATHENA ARBOUR ASSEMBLY INSTRUCTIONS
Please ensure that you check all component parts for quantity and
quality before you commence building the product.
If there are any missing parts, please contact the sales company
immediately.
Timber is a natural product. It will shrink and swell as a result of
varying moisture content.
This product has been pressure treated to ensure protection against all
weather conditions. Annual cleaning and re-treatment with a timber
preservative will help to prolong the life of the product.
A powerdrill/screwdriver plus tape measure will be required to
assemble this product.
Screw fixings supplied
6 x 25mm screws
6 x 50mm screws
12 x 70mm screws
2 x 90mm screws
Component supply.
2 x side panels 1 x seat base + 1 x seat back 2 x roof panels
1 x top back support 2 x angled braces 1 x bottom front 1 x finial
support
Store More Garden Buildings Ltd.
Edward Merton House, Park Gate Close, Bredbury Park Way, Bredbury Industrial Park,
Stockport, Cheshire. SK6 2SN
Tel: [phone] Fax: [phone] E-mail: [email protected]
www.shedbaron.co.uk

Stage 1.
Secure the seat base to side panel at 380mm
from end of post to bottom of seat support.
Use 2 x 70mm screws.
Ensure that top rafter is facing outside of
assembly.
Fix second side panel in similar manner.
Use 2 x 70mm screws.
Stage 2.
Stand arbour upright and fix seat back into
angled slots provided in seat base support.
Use 1 x 70mm screw for each side of seat
back.
Use 2 x 25mm screws for each side to secure
seat back into angled joint with seat base.
Stage 3.
Fix horizontal top back support to post,
35mm down from top of side panels, using
2 x 50mm screws.
Fix angled braces into post and inside surface
of back support using 4 x 50mm screws.

Stage 4.
Fix lower horizontal bottom front support
between posts and secure with 2 x 90mm
screws.
Stage 5.
Place the two roof sections together.
Secure the roof sections with 2 x 70mm
screws ensuring the screws locate into the
framing of the roof panel.
Stage 6.
Lift the assembled roof sections into
position.
The roof should be flush with the back of the
arbour.
Secure the roof in place using 1 x 70mm
screw placed through each corner into the
posts of the arbour.

Stage 7.
Secure the finial to cover the joint of the
roof sections at the front of the arbour
using 2 x 25mm screws.
A ‘GARDEN TECHNOLOGY’ PRODUCT FROM ESTONIA.
TIMBER SUPPLIED FROM SUSTAINABLE FOREST RESOURCES.