Store More CASSANDRA ARBOUR User manual

CASSANDRA ARBOUR ASSEMBLY INSTRUCTIONS
Please ensure that you check all component parts for quantity
and quality before you commence building the product.
If there are any missing parts, please contact the sales
company immediately.
Timber is a natural product. It will shrink and swell as a
result of varying moisture content.
This product has been pressure treated to ensure protection
against all weather conditions. Annual cleaning and re-
treatment with a timber preservative will help to prolong the
life of the product.
A power drill/screwdriver plus tape measure will be required
to assemble this product.
NB. It is recommended that pilot holes are pre drilled where necessary before
screws are fixed. This reduces the risk of splitting of timber.
Screw fixings supplied
14 x 25mm screws
8 x 50mm screws
16 x 70mm screws
4 x 90mm screws
4 x 6mm screw caps
2 x metal roof brace plates
Component supply.
2 x side panels 1x back panel 1 x seat base + 1 x seat back 2 x roof panels
1 x top back support 1 x finial 1 x bottom front support
Store More Garden Buildings Ltd.
Edward Merton House, Park Gate Close, Bredbury Park Way, Bredbury Industrial Park,
Stockport, Cheshire. SK6 2SN
Tel: [phone] Fax: [phone] E-mail: [email protected]
www.shedbaron.co.uk

Stage 1.
Secure the seat base to side panel at 380mm from end
of post to bottom of seat support.
Use 4 x 70mm screws, 2 at each end.
Ensure that top rafter is facing outside of assembly.
Fix second side panel in similar manner.
Use 4 x 70mm screws , 2 at each end.
Stage 2. Stand arbour upright and fix seat back into
angled slots provided in seat base support.
Use 2 x 25mm screws for each side to secure
seat back into angled joint with seat base.
Stage 3. Fit back trellis panel by placing on the horizontal seat
support and then fixing into corner posts with 2 x
50mm screws on each side.
Secure the seat back support by screwing two 70mm
Screws through the back trellis panel frame ( one each
Side) into the seat support .
Stage 4. Fix horizontal top back support to post,
Flush with top of posts using
4 x 50mm screws, 2 at each end.
.

Stage 5.
Fix lower horizontal bottom front support between posts
and secure through posts with 4 x 90mm screws and screw
caps (2 per side).
Stage 6.
Place the two roof sections together.
Secure the roof sections with 2 x 70mm
screws ensuring the screws locate
into the framing of the roof panel.
Fix metal braces to inside of roof join
With 4 x 25mm screws each side.
Stage 7.
Lift the assembled roof sections into
position. The roof should be flush
with the back of the arbour.
Secure the roof in place
using 1 x 70mm
screw placed
through each corner into the
posts of the arbour
.
Stage 8.

Secure the finial to cover the joint of the
roof sections at the front of the arbour
using 2 x 25mm screws.
A ‘GARDEN TECHNOLOGY’ PRODUCT FROM ESTONIA.
TIMBER SUPPLIED FROM SUSTAINABLE FOREST RESOURCES.