Street Guardian sg9665gc User manual

Sg9665GC
Quick start
guide

2
Product safety & precautions
Thank you for purchasing the Street Guardian SG9665GC
Digital Video Recorder (DVR , please read and follow this
quick start guide before installation and use.
The camera is designed to operate at temperatures of
between -10 °
°°
° c to +60 °
°°
° c, operating outside of these
temperatures may produce unpredictable results and
should be avoided.
Clean only with a soft dry cloth, being careful not to use
excessive pressure when cleaning the lens, the use of
liquids or cleaning fluids may damage the product and void
your warranty.
The DVR records video in full high definition 1080P/30fps
at 15Mbit/sec, a large amount of data is generated for the
video recording function. To prevent recording problems it
is recommended to only use good quality high speed Class
10 Micro SD cards with a maximum capacity of 32 GB.
The DVR does not support hot plugging of the Micro SD
memory card. Be sure to remove or replace the Micro SD
memory card only while the recorder is powered off or the
memory card and any recordings may be damaged.

3
Introduction
The Street Guardian SG9665GC Digital Video Recorder is
engineered as a set and forget device, it is pre configured
with logical default settings and is supplied ready to use
once installed with a minimum of adjustment needed to
personalise to your needs.
The default operation of the product means that it will
power on and start recording shortly after starting the
vehicle and will power down shortly after the vehicle is
turned off, the recordings will be segmented into easy to
navigate chapters and once the memory card is full will
automatically delete the oldest recorded segment to make
way for further recordings.
Operating in this ‘first in, first out’ manner means that the
supplied 32GB memory card will cycle the recordings
continuously and will always have the most recent
recordings, the 32GB memory card will store around 4
hours worth of recordings before beginning to recycle.
Emergency files created either by activation of the built in
G-Sensor or by pressing the
OK/lock key will not be
overwritten when the camera recycles old recordings.

4
Ca era layout & Overview
Installation
The DVR should preferably be mounted behind, or to
either side of the rear view mirror and within the sweep
area of the windscreen wipers. Before mounting the DVR
ensure that there is enough room for the cables and clean
the glass prior to installation to ensure a good bond for the
adhesive to the glass, it is always advisable to route any
cables across the passenger side of the vehicle to avoid any
chance of cables interfering with control of the vehicle or
causing a distraction should a cable become loose.

5
1. Once a suitable mounting location is decided secure the
DVR mount bracket to the windshield using the provided
3M adhesive tape, ensuring the window is clean prior to
application, remove the backing tape and press and hold
the bracket firmly against the glass for 2 minutes, then
wait 20 minutes before attaching the camera. The
adhesive will achieve 50% bond after 20 minutes, 100%
bond is achieved after 72 hours, if the camera is attached
to the bracket too soon after installation the adhesive may
not bond correctly to the glass.
2. Fix the power and GPS cables properly by using the
cable slot and cable clip (if required and route all cables
across the passenger side, preventing the line of sight from
being affected.

6
3. Insert the charging interface of the in vehicle charger
into the USB interface of the DVR.
4. Connect the GPS and position the cables accordingly, the
GPS should be mounted with the adhesive side down so
that the antenna is oriented correctly.
5. Insert the in vehicle charger into the cigarette lighter
socket of the vehicle.
6. Adjust the angle of the DVR lens ensuring that the
camera lens is aimed slightly down from the horizon (40%
sky, 60% road , this will improve the results of the auto
white balance function.
[Note] Video performance is adversely affected if the
window is not kept clean, ammonia free automotive glass
cleaners are recommended for the inside glass surfaces for
optimum results.

7
Settings
The DVR is preset with logical default settings and is ready
to operate, when powered on the internal capacitors will
charge, the DVR will then power up and recording will
commence, the time and date settings are automatically
updated via GPS (if fitted and will sync periodically to
maintain accuracy, the time zone will need to be
configured to your specific region to ensure correct
operation.
[Note] The DVR does not contain a attery and will need to
e connected to a power source to configure settings.
Adjust the time zone settings, press the MENU key twice
to enter the SETUP submenu, press the Mic/pg down
key to scroll down to the TIME ZONE menu, press the
OK/lock key to enter and adjust accordingly.
[Note] The GPS signal carries time and date information for
GMT 0, the time offset to suit your region is set y the DVR,
if you are in a region that supports daylight savings offset
it will e necessary to adjust the time zone at the eginning
and end of the period accordingly.

8
Technical Specifications
Processor Novatek NT96655
Image Sensor Sony Exmor IMX322
Lens 7 Element glass lens
ngle of View 120°
°°
° horizontal
Resolution Full HD 1920×1080
Frame Rate 30FPS
Video Format H.264 MOV
V Output NTSC/P L
LCD display 1.5-inch
Storage Temp -20°
°°
°C to 70°
°°
°C
Operating Temp: -10°
°°
°C to 60°
°°
°C
Operating Humidity 15% to 65% (RH)
Memory Card 4 GB to 32 GB
Standard Voltage DC5V

9
Further infor ation
All attempts are made to ensure that the information
contained in this quick start guide is correct at time of
publication.
[Note] A full user guide for this product is availa le for
download from the support section of our we site.
The specifications and details within this guide are based
on the Australian market version of the product and are
subject to change.
The pictures used are for illustration purposes only.
Information about the latest specification, amendments,
the availability of replacement parts and accessories,
warranty information, detail of other sales region product
specifications and their respective user manuals are
available on our website.
www.streetguardian.info
© Street Guardian 2015