Sunbeam SAFETY-GLO 644 User manual

SAFETY-GLO@ COOL MIST
HUMIDIFIER
Modal 644,646
Part # 66047
Important notes
Please read this manual carefully before using this device
For Household Use Only.

SAFETY-GLOB
COOL MIST HUMIDIFIER
INSTRUCTION BOOK
READ AND SAVE THESE INSTRUCTIONS
WHEN USING ELECTRICAL APPLIANCES,
ESPECIALLY WHEN CHILDREN ARE PRESENT,
BASIC SAFETY PRECAUTIONS SHOULD ALWAYS
BE FOLLOWED, INCLUDING THE FOLLOWING:
1.
2.
3.
4.
5
READ ENTIRE INSTRUCTION BOOK BEFORE
USING.
TO FILLWATER RESERVOIR, USE ONLY CLEAN,
COOL TAP WATER.
PLACE HUMIDIFIER ON A FLAT, LEVEL SURFACE.
DO NOT PLACE NEAR HEATING DEVICES. KEEP
THE CORD AWAY FROM HEATED SURFACES AND
AREAS WHERE IT CAN BE STEPPED ON OR
TRIPPED OVER.
PLUG HUMIDIFIER INTO POLARIZED 120 VOLT AC
OUTLET ONLY. BE SURE UNIT IS PLUGGED IN
FIRMLY AND COMPLETELY. TURN HUMIDIFIER OFF
AND UNPLUG WHEN NOT IN USE AND BEFORE
CLEANING.
NEVER OPERATE HUMIDIFIER WITH A DAMAGED
CORD OR PLUG. IF IT IS NOT WORKING PROPERLY,
OR IT HAS BEEN DROPPED OR DAMAGED,
RETURN IT TO THE APPLIANCE SERVICE STATION
FOR EXAMINATION, REPAIR, OR POSSIBLE

ELECTRICAL OR MECHANICAL ADJUSTMENT
6. DO NOT ADD MEDICATION OF ANY TYPE INTO THE
WATER IN THE RESERVOIR. DO NOT COVER VENTS
OR LOUVERS OR PLACE ANYTHING OVER THEM
WHILE HUMIDIFIER IS OPERATING. NEVER DROP
OR INSERT ANY OBJECT INTO ANY
OPENING.
7. SUPERVISION IS RECOMMENDED WHEN
HUMIDIFIER IS USED NEAR CHILDREN,
INVALIDS OR PETS.
8. DO NOT REMOVE HUMIDIFIER MOTOR
ASSEMBLY WHILE HUMIDIFIER IS OPERATING.
9. DO NOT TILT OR TIP HUMIDIFIER OR ATTEMPT
TO EMPTY OR FILLWHILE IN OPERATION.
10. TURN HUMIDIFIER OFF AND UNPLUG WHEN
WATER RESERVOIR IS EMPTY AND BEFORE
CLEANING OR MOVING HUMIDIFIER.
111. TO GUARD AGAINST ELECTRICAL SHOCK, DO NOT
IMMERSE HUMIDIFIER MOTOR ASSEMBLY IN
WATER OR OTHER LIQUIDS.
12. DO NOT USE OUTDOORS.
1
13. DO NOT USE HUMIDIFIER OTHER THAN FOR
HUMIDITY CONTROL.
L

INSTRUCTIONS
Please refer to the directions below for inserting and removing the humidifier
motor assembly. Unit may make vibrating noise if motor assembly is not
placed properly on humidifier water reservoir.
To remove motor assembly from water reservoir lift motor assembly directly
upwards from water reservoir. To insert motor assembly onto water reservoir
set motor assembly gently on ridge of water reservoir. Be sure motor
assembly cannot move around on water reservoir.
Warning: Protect yourself against electrical shock. Always unplug your
humidifier when not in use, and before cleaning, rinsing, filling
or moving. Unit will reach maximum output after about five
uses. If greater output is desired, warm tap water may be used.
OPERATING INSTRUCTIONS
1. Always rinse and empty the water container before each
filling and after each use.
2. Before filling container, unplug the unit, lift top of unit and
place upside down to avoid damaging the impeller stem.
3. Fill with cool tap water to fill line indicated on the outside of
the bucket. There are two fill lines located on the back side
of the reservoir. The first line is half full and the top line is
full. Do not fill the reservoir higher than the top line. The half
full line is to be used for running the humidifier half the
normal running time. (Example: If your humidifier runs 20
hours when you fill it up, and you only want to fill 10 hours,
simply fill your humidifier to the first line.) Do not add
Figure 1
Full Line
medication of any type to the water in the container. After filling, replace
top as explained above.
4. Place the humidifier on flat hard surface. Do not place under a tent.
Do not direct the mist toward the patient or toward walls or furniture.
5. The power cord must be extended to its full length (unhanked;
not bunched up) to prevent overheating of the cord. Plug
humidifier into a 120 volt outlet only

6. If humidifier does not start immediately, make sure humidifier is
plugged in. If a wet area forms around your humidifier, the room
air is at maximum humidity; unplug and empty your humidifier.
To reduce the risk of electric shock, this appliance has a polarized plug
(one blade is wider than the other). This plug will fit in a polarized outlet only
one way. If the plug does not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician to install the proper outlet. Do
not change the plug in any way.
HUMIDIFIER IMPELLER TIP
This humidifier contains a removable moisture
Impeller Tip Impeller Tlp
Holder
control impeller tip. The impeller tip comes already l
6 $
.
placed on the units impeller stem (Figure 2).
: =.
.
: *
‘.
. . .-
The impeller tip enables you to control the
r:
Figure 2’ Impeller Stem
amount of moisture the unit puts into the air. If
you would like to increase moisture output, carefully lift motor
assembly from water reservoir and remove impeller tip and
place on tip holder on under side of humidifier cap. (Figure 3).
figure 3
This enables more water to flow through impeller stem and increases the
amount of moisture that is put into the air. To decrease moisture output just
slide impeller tip back on to impeller stem.
CLEANING INSTRUCTIONS
WARNING: Always unplug humidifier before attempting any service,
especially cleaning.
1. Periodically, it is imperative to clean impeller, due to the impurities found
in water. Deposits will build up within the impeller stem and limit the
! moisture output of your humidifier.
2. To clean inside impeller stem, set motor assembly on flat sturdy surface
with impeller stem facing up.
3. Use a small brush or toothpick to clear or loosen any minerals that are
built up in impeller stem.
NOTE: If impeller stem is completely or partially blocked it will inhibit the
performance of the product.

WEEKLY CLEANING:
(Always Clean Humidifier Before Storing).
1. Disconnect the humidifier and remove top of unit.
2. Fill the container with one gallon water and l/4 cup household bleach.
Seal humidifier opening with a soft cloth to prevent moisture from
escaping.
3. Plug unit into 120 volt outlet and run for 30 minutes with opening sealed.
Operate unit in an empty bathtub to avoid damage to surrounding area
from bleach water.
4. Remove cloth from opening, empty bucket, and thoroughly rinse until
bleach smell is gone.
5. Wipe humidifier dry.
Failure to properly clean your humidifier will result in the build up of harmful
bacteria and mold.
In areas where tap water contains excessive mineral matter, a white dust
may accumulate in the area near the humidifier. This white dust can be
readily removed with a cloth or vacuum cleaner or be completely eliminated
by using distilled water. The white dust is not a defect in the humidifier, but
is due to minerals suspended in the water. DO NOT use any type of water
conditioning tablet as it may cause other problems.
DO NOT
add medication of any type to the
/
water in the container.
DO NOT
use impeller stem as a handle.
This could damage your
humidifier.
Do not allow humidifier to stand with water unused; this could cause
growth of fungi.
It will not harm unit to continue running without water, if the water is used
up during normal operation. However, do not leave humidifier plugged in
when not in use.

1
SAFETY GLOW HUMIDIFIERS
All Sunbeam humidifiers are built with the safety of our customers as a
priority. Our Safety Glow plastic glows in the dark, letting you know the
location of your humidifier at night. The length and intensity of the glow will
vary depending upon the amount and quality of light the product absorbs dur-
ing the day. to achieve the greatest glow at night, place in direct sunlight dur-
ing the day. The brightness of the glow will be more intense for the first 1-2
hours in the dark. The glow will then diminish, but still remain at a level
noticeable to the human eye. Our safety thermostat motors automatically turn
off if any overheating occurs. There is no changing of fuses with a Sunbeam
humidifier. If overheating occurs just unplug the unit from outlet
for a short period of time, plug back into outlet and resume operation
of humidifier.
2 Year Limited Warranty
Congratulations on your recent purchase of a quality Sunbeam product. We
are confident that our product will perform well and therefore warrant to you,
as the original retail purchaser, for a period of 2 years from the date of original
purchase, that your new product will be free of mechanical and electrical
defects in material and workmanship.
If your product is covered during the warranty period, we will repair or replace
a new or refurbished unit of your new product (at our option) without cost to
you, which will be your exclusive remedy under this warranty. Please do not
return this product to the place of purchase; doing so may delay the processing
of your claim and our repair of your product. Simply send your product postage
prepaid, with proof of purchase and a short description of the problem directly
to our factory service center at the following address: SUNBEAM PRODUCTS,
Sunbeam Appliance Service Station, 95 WL Runnels Industrial Drive, Dock M5,
Hattiesburg, MS 39401. California residents may call the following number to
locate the nearest authorized service center: I-800-597-5978.

Our warranty for your product will not cover normal wear of parts, damage
resulting from negligent use or misuse of the product, use of improper voltage
or current, use contrary to operating instructions, glass breakage (if applica-
ble), or disassembly, repair, or alteration by any person other than an autho-
rized service station. Any implied warranty of merchantability or fitness for a
particular purpose on your product is limited to the duration of this written
warranty. We shall not be liable for any incidental or consequential damages
for breach of any express or implied warranty on your product.
Some states do not allow limitations on how long an implied warranty lasts
or the exclusion or limitation of incidental or consequential damages, so the
above limitation may not apply to you. This warranty gives you specific legal
rights, and you may also have other rights which vary from state to state.
01999 Sunbeam Corporation or its affiliated companies, all rights reserved.
SUNBEAM@ and HEALTH AT HOME@ are registered trademarks of Sunbeam
Corporation or its affiliated companies. Distributed by Sunbeam Products,
Inc., Boca Raton, Florida 33431. Imported by Sunbeam Corporation. The
product you buy may differ slightly from the one shown on this carton due
to continuing product development. Questions or comments, please call
customer service at I-800-435-1250.
0
VL UL LISTED FOR HOUSEHOLD USE IJULY