Sunny Health & Fitness SF-B020029 User manual

PWR CYCLE ELECTRIC UNDER DESK
BIKE
SF-B020029
USER MANUAL
DO NOT STAND ON THE UNIT
IMPORTANT! Please retain owner’s manual for maintenance and adjustment instructions. Your
satisfaction is very important to us, PLEASE DO NOT RETURN UNTIL YOU HAVE CONTACTED
US: [email protected] or 1-877-90SUNNY (877-907-8669).

1
IMPORTANT SAFETY INSTRUCTIONS
Thank you for purchasing the PWR Cycle Electric Under Desk Bike. Please read the operating
instructions carefully before use, especially the safety precautions.
When using an electrical appliance, basic precautions should always be followed, including the
following:
Read all instructions before using this appliance.
DANGER – To reduce the risk of electric shock:
Always unplug this appliance from the electrical outlet immediately after using and before cleaning.
WARNING – To reduce the risk of burns, fire, electric shock, or injury to persons:
1. This product’s rated voltage is 120V, rated power is 220W, 30 min.
2. An appliance should never be left unattended when plugged in. Unplug from outlet when not in
use, and before putting on or taking off parts.
3. Do not stand on the bike, only use the bike while sitting.
4. Use this appliance only for its intended use as described in this manual. Do not use attachments
not recommended by the manufacturer.
5. This appliance is not intended for use by persons with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety. Keep children
under the age of 13 and pets away from this machine. This is for adult use only.
6. Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has
been dropped or damaged, or dropped into water. Return the appliance to a service center for
examination and repair.
7. Do not carry this appliance by supply cord or use cord as a handle.
8. Keep the cord away from the heated surfaces.
9. Never operate the appliance with the air openings blocked. Keep the air openings free of lint, hair,
and the like.
10.Never drop or insert any object into any opening.
11.Do not use outdoors.
12.Do not operate where aerosol (spray) products are being used or where oxygen is being
administered.
13.To disconnect, turn all controls off, then unplug from outlet.
14.To reduce the risk of injury, place the appliance on a flat, horizontal, and stable surface. Do not
place or use the appliance on a slippery surface.
15.To reduce the risk of injury, do not use the appliance with wet shoes, wet feet, or socks.
16.To reduce the risk of injury, do not use the appliance if the surface is wet. If the appliance surface
becomes wet, dry the surface before using.
17.Turn off the power after each use. After using or before cleaning the appliance, unplug the power
supply from the outlet.
18.Do not cover while using, to avoid motor overheating and cause malfunction or damage.
19.Be aware how you are feeling. If you feel uncomfortable or experience any adverse symptoms,
stop the using the appliance immediately.
20.Do not use the appliance if it is damaged or defective.
21.This appliance is not suitable for therapeutic use. Do not use with other medical electronic
equipment, such as pacemakers or EKG machines.

2
22.Do not use the appliance in wet or dusty environment. Do not use in humid environment, such as
bathroom.
23.Keep the appliance away from direct sunlight.
24.Do not operate the appliance with wet hands.
25.Do not allow water and other liquids to touch control switch.
26.Do not place the power cable under the appliance or any heavy object.
27.Do not wind the power cable around the appliance. That could damage the power cable, cause
electric shock or electrical fire.
28.If the power plug is loose, do not use the appliance.
29.If there is a power surge during use, stop using the appliance. Sudden restoration of power could
cause injury to you.
30.Consult your physician before use, especially if you have any medical conditions such as diabetes.
31.Connect this appliance to a properly grounded outlet only. See Grounding Instructions.
32.Use the equipment on a solid, flat level surface with a protective cover for your floor or carpet. To
ensure safety, the equipment should have at least 2 feet (60 CM) of free space all around it.
SAVE THESE INSTRUCTIONS

3
EXPLODED DIAGRAM
HARDWARE PACKAGE
29
30
11
#39
S13-S14-S15
1
3L
3R
4
56
6
7L
7R
8L
8R
9
10
12
13
14
14
15
15
17
17
15
15
16
16
16
16
21L
21R
24
24
24
24
24
22
22
22
22
22
22
25
26
25 26
27
28
31
31
32
33
34
35
33
34 35
36
37
38
23
19
20
#14 M8*42 4PCS
#15 ID8.2*OD16*1.5 4PCS
#21R 12"-20 1PC
#17 M8 4PCS
#39 S13-S14-S15 1PC
#40 S17-S19 1PC
#21L 12"-20 1PC

4
PARTS LIST
Ordering Replacement Parts (U.S. and Canadian Customers only)
Please provide the following information in order for us to accurately identify the part(s) needed:
The model number (found on cover of manual)
The product name (found on cover of manual)
The part number found on the “EXPLODED DIAGRAM” and “PARTS LIST” (found near the front of
the manual)
Please contact us at [email protected] or 1-877-90SUNNY (877-907-8669).
No.
Description
Spec.
Qty
No.
Description
Spec.
Qty
1
Main Frame
1
21L/R
Nylon Nut
1/2’’-20
2
2
N/A
--
22
Screw
ST4.2*15
6
3L/R
Crank
2
23
Toothed Lock
Washer
D4
1
4
Power Cable
1
24
Screw
ST4.2*19
5
5
Power Switch
1
25
Flange Nut
M10
2
6
Rubber Pad
2
26
End Cap
2
7L/R
Pedal
2
27
Spring Washer
D4
1
8L/R
Belt Cover
2
28
3P Data Line
1
9
Motor
1
29
Sensor
1
10
Console
1
30
Screw
M3*8
2
11
Remote Control
1
31
Fixing Bolt
4
12
Controller
1
32
6P Data Line
1
13
Outlet
1
33
Screw
M6*15
6
14
Carriage Bolt
M8*42
4
34
Spring Washer
D6
6
15
Flat Washer
ID8.2*OD16*1.5
4
35
Flat Washer
Φ6.4*Φ12*1.2
6
16
End Cap
4
36
Screw
M4*10
1
17
High Cap Nut
M8
4
37
Screw
M3*6
4
18
N/A
--
38
Washer
Φ17*Φ70*1.0
1
19
Front Stabilizer
1
39
Spanner
S13-S14-S15
1
20
Rear Stabilizer
1
40
Spanner
S17-S19
1

5
ASSEMBLY INSTRUCTIONS
We value your experience using Sunny Health and Fitness products. For assistance with parts or
troubleshooting, please contact us at [email protected] or 1-877-90SUNNY (877-907-
8669).
STEP 1:
Attach Rear Stabilizer (No. 20) to the Main
Frame (No. 1) with 2 Carriage Bolts (No. 14), 2
Flat Washers (No. 15), and 2 High Cap Nuts
(No. 17). Tighten and secure with Spanner (No.
39).
Attach Front Stabilizer (No. 19) to the Main
Frame (No. 1) with 2 Carriage Bolts (No. 14), 2
Flat Washers (No. 15), and 2 High Cap Nuts
(No. 17). Tighten and secure with Spanner (No.
39).
20
14
15
17
14
15
17
1
15
17
19
#39
S13-S14-S15
#15 ID8.2*OD16*1.5 4PCS
#17 M8 4PCS
#14 M8*42 4PCS

6
We value your experience using Sunny Health and Fitness products. For assistance with parts or
troubleshooting, please contact us at [email protected] or 1-877-90SUNNY (877-907-
8669).
STEP 2:
NOTE: The Pedals (No. 7L & No. 7R) are
marked “L” and “R” for Left and Right.
WARNING! Read instructions carefully as
improper assembly may cause permanent
damage to your bike.
Remove the 2 Left & Right Nylon Nuts (No.
21L & No. 21R) located on the Pedals (No. 7L
& No. 7R).
Align the Left Pedal (No. 7L) with the Left
Crank (No. 3L) at 90°. Gently insert the Left
Pedal (No. 7L) into the Left Crank (No. 3L)
and turn the Left Pedal (No. 7L) counter-
clockwise as tightly as you can with your hand.
Use Spanner (No. 39) to tighten and secure.
Turn the Left Nylon Nut (No. 21L) clockwise as
tightly as you can with your hand. Use Spanner
(No. 39) to hold the pedal bolt on the Left Pedal
(No. 7L) and use Spanner (No. 40) to turn the
Left Nylon Nut (No. 21L) clockwise at the same
time, until it is tightened on to the Left Crank
(No. 3L).
Align the Right Pedal (No. 7R) with the Right
Crank (No. 3R) at 90°. Gently insert the Right
Pedal (No. 7R) into the Right Crank (No. 3R)
and turn the Right Pedal (No. 7R) clockwise as
tightly as you can with your hand. Use Spanner
(No. 39) to tighten and secure.
Turn the Right Nylon Nut (No. 21R) counter-
clockwise as tightly as you can with your hand.
Use Spanner (No. 39) to hold the pedal bolt on
the Right Pedal (No. 7R) and use Spanner (No.
40) to turn the Right Nylon Nut (No. 21R)
counter-clockwise at the same time, until it is
tightened on to the Right Crank (No. 3R).
1
7L
7R
21L
21R
3R
3L
#39
S13-S14-S15
#40
S17-S19
#21L 12"-20 1PC
#21R 12"-20 1PC
3R
7R
21R
39
3R
7R
39 40
3L 7L
39
3L
7L
21L
39
40

7
We value your experience using Sunny Health and Fitness products. For assistance with parts or
troubleshooting, please contact us at [email protected] or 1-877-90SUNNY (877-907-
8669).
STEP 3:
Plug the Power Cable (No. 4) into the Outlet
(No. 13) on the Main Frame (No. 1).
The assembly is complete!
4
13
1

8
IMPORTANT ELECTRICAL INFORMATION
WARNING:
This PWR Cycle Electric Under Desk Bike requires a power source of 120V in order to properly
operate. For your safety as well as the safety of others, please verify that the power source is correct
before powering in the equipment. Any power supply source above or below this level could cause
significant damage to the equipment and/or user.
GROUNDING METHODS:
This PWR Cycle Electric Under Desk Bike must be grounded. Should the PWR Cycle Electric Under
Desk Bike malfunction or breakdown, grounding provides a path of least resistance for electric
current to reduce the risk of electric shock. This product is equipped with a plug that has an
equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate
outlet that is properly installed and grounded in accordance with all local codes and ordinances.
This PWR Cycle Electric Under Desk Bike is for use on a nominal 120V circuit and has a grounding
plug that looks like the plug illustrated in sketch A. Ensure that the cycle is connected to an outlet
with the same configuration as the plug. Do not use an adaptor for this product.
DANGER:
Improper connection of the equipment can result in risk of electric shock. Check with a qualified
electrician or serviceman if you are unsure whether the product has been properly grounded. Do not
modify the plug provided with the product. If it will not fit the outlet, have a proper outlet installed by a
qualified electrician.
WARNING!
1. NEVER use a ground fault circuit interrupt (GFCI) wall outlet with this PWR Cycle Electric Under
Desk Bike.
2. NEVER operate the bike using a generator or UPS power supply.
3. NEVER remove any cover on this bike without first disconnecting the Power Cable (No. 4).
4. NEVER expose the bike to rain or moisture. This PWR Cycle Electric Under Desk Bike is not
designed for outdoor use or use in any high humidity environment.
GROUNDING METHOD

9
BATTERY INSTALLATION & REPLACEMENT
Battery
Battery Seat
12
3
11 11
11
a
b
Battery Seat
Battery Seat
Battery
BATTERY INSTALLATION:
1. Press the arrow at squeeze point a of battery seat and buckle point b of battery seat, then pull out
battery seat. Take out the 1pc CR2025 3V battery that is included inside the remote control box.
2. Install the 1pc battery into the battery seat with the positive end facing up.
3. Put the battery seat back.
The installation is complete!
12
34
11 11
11 11
a
b
Old Battery
Old Battery
Battery Seat
Battery Seat
Battery Seat
New Battery
Battery Seat
BATTERY REPLACEMENT:
1. Press the arrow at squeeze point a of battery seat and buckle point b of battery seat, then pull out
battery seat.
2. Take out the old battery from the battery seat.
3. Install the new battery, CR2025 3V into the battery seat with the positive pole facing up.
4. Put the battery seat back.
.
The replacement is complete!
Dispose the old battery according to your regional guidelines.