Superior LK36-B User manual

WOOD BURNING APPLIANCE
KITS AND ACCESSORIES
INSTALLATION INSTRUCTIONS FOR GRILLE TRIM KITS
FOR USE WITH SUPERIOR'S WOOD BURNING APPLIANCES
SHIPPING AND PACKING LIST
Grille Trim Kit must include:
6 Grille Trim (Full Length)
The Grille Trim Kits covered in this document are:
Catalog # Model #
91L55 LK36-B
91L56 LK36-P
91L59 LK42-B
91L60 LK42-P
GRILLE TRIM KIT INSTALLATION INSTRUCTIONS
Step 1. Remove fireplace grille assemblies by lifting up and out of holes
on frame. Then pull from bottom out towards you. ( Figures 1 and 2 ).
Note: Lift grille near outer support rods to fully clear holes.
Step 2. Insert grille trim onto grille and bend tabs over and around
until fully secured (
See Figure 3 ). Bend tabs utilizing the flat end of a
screw driver or pliers.
Step 3. Remove protective covering from decorative grille trim
pieces and wipe with damp cloth.
Step 4. Replace grills by aligning top ends of rods to upper set of holes
on corresponding frames. Swing grilles towards frame in the same
manner as they were removed and allow rod bottoms to fall into bottom
holes until fully secured. Make sure all rods are completely inside holes.
GRILLE TRIM KITS
Figure 1
Figure 2
750,054M
05/2001
Figure 3
Printed in U.S.A. © 2000 by FCT
P/N 750,054M REV. B 05/2001
FireCraft Technologies reserves the right to make changes at any time, without notice,
in design, materials, specifications, prices and also to discontinue colors, styles and
products. Consult your local distributor for fireplace code information.
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Grille Assembly
Bend Tab Over
With The Flat End
Of A Screw Driver
Or Pliers.
Louver Trim
Shown In Place
Decorative
Louver Trim