Supermicro HK030 User manual

1S 3.5A Brushless ESC manual
Parameter:
Voltage：3.0-4.2V
Output urrent:3.5A( instant maximum urrent4.0A)
Weight:0.3g
1,Features:
* Safe prote tion for onne ting power, no matter what position the throttle
sti k is when the power is turn on, the ESC won’t start the motor instantly;
* Throttle signal lost prote tion, if signal ommuni ation between the
transmitter and re eiver is not good or not stable and auses lost ontrol,
the ESC will ut off the power within 2 se onds softly, and if the signal
is found during this period, the output power will re over and the ESC will
ontinue its normal working state;
* Overheat prote tion, the ESC will limit its output power when the
temperature rea hes 95℃,if the temperature ontinues to in rease, the ESC
will ut off the power slowly, only the temperature is low enough an the
ESC be powered up and return to normal working state;
* Low voltage prote tion, when the input is less than 3.0V or more than
4.4V,theESC will enter prote tion mode, this fun tion only workable
when the power is onne ted;
* Lipo battery prote tion， when the battery voltage is lower than 3.0V, the
ESC will ut off the power slowly, as soon as the voltage is more
than 3.0V, onne t the power and it returns to normal working;
* Blo k prote tion, if the prop is blo ked, the maximum limitation power
output will be 36%;
2、Throttle setup
Initial full throttle position is 1850us, the bottom throttle position is
1200us, it an automati ally dete t the bottom throttle position as soon as
the power is onne ted, the followings are for throttle setup order, from the
way the full throttle position an be re orded permanently:
1. Push the throttle to full position, onne t the power and wait for 4
se onds, it makes a long beep and the maximum throttle range is re orded.
2. Pull the throttle to lowest position ， wait for 0.5 se ond, it makes 3
short beeps and the lowest throttle re orded.
3. When it makes several beeps, it indi ates the self-test has been done, the
ESC is ready for work.
The dete ted range of lowest throttle is0.8ms~1.2ms，and the dete ted range
of full throttle is 1.8ms~2.3ms.
3、Diagram of connection：

4、Explanation for warning(alarm) beeps
Signal lost prote tion: it makes one beep ea h se ond.
Overheat prote tion: it makes 3 beeps ea h se ond.
Low voltage prote tion and lipo prote tion: it makes 1 beep for ea h 2 se ond.
The sti k is not on the lowest position when it onne ts power: it makes 1
beep ea h se ond.