Surpahs STT-1110 User manual

User Manual
Digital Body Scale STT-1110
Features
Capacity: 180kg / 397lb / 28st: 5lb
Division: 0.1kg / 0.2lb
Weight unit: kg / lb / st: lb
Minimal weight: 5kg
Function key: UNIT
Display: Positive LCD
Battery: 1*CR2032
Auto on or press UNIT to switch on
Auto off function
LCD diplay
Function indication
UNIT: Press “UNIT” to select desired unit in weighing mode.
Operation instruction
I. Select unit before use
a) Open the battery door at the back of the scale.
b) Put the batteries in and ensure +/- terminals are correct. The LCD will be on as below.
c) Close the battery door and wait until “0.0kg” is shown.
1

d) Press “UNIT” to select the desired unit.
Note: Please put the scale on flat hard ground when finishing selecting unit. Wait for a few
seconds, then you may start measuring according to the measuring procedure below. If
there is not any operation in weighing mode, the scale will turn off automatically after
about 10s.
II. Measuring(Unit kg selected)
a) Please put the scale on flat hard ground.
b) Please stand on the flatform directly to switch on.
c) Stand still and the weight data will be locked automatically with blinking twice when
stable. Then the scale will turn off after about 10s.
Note: If you want to measure once again, please step off, then step on the flatform again.
Indication message
a) Low battery indication. When “Lo” is shown, the scale will turn off after a few seconds
and please change the batteries.
b) Overload indication. Please remove the weight on the scale to protect the loadcells.
Reminder
a) Please do not put the scale on carpet.
b) If the scale is not to being used for a long period, please remove the batteries.
c) Clean the scale with a slightly damp cloth, DO NOT immerse the scale in water or use
chemical/abrasive cleaning agents.
2